Abstract: Electric vehicle (EV) is one of the effective solutions to
control emission of greenhouses gases in the world. It is of interest
for future transportation due to its sustainability and efficiency by
automotive manufacturers. Various electrical motors have been used
for propulsion system of electric vehicles in last decades. In this
paper brushed DC motor, Induction motor (IM), switched reluctance
motor (SRM) and brushless DC motor (BLDC) are simulated and
compared. BLDC motor is recommended for high performance
electric vehicles. PWM switching technique is implemented for speed
control of BLDC motor. Behavior of different modes of PWM speed
controller of BLDC motor are simulated in MATLAB/SIMULINK.
BLDC motor characteristics are compared and discussed for various
PWM switching modes under normal and inverter fault conditions.
Comparisons and discussions are verified through simulation results.
Abstract: In this paper, we evaluate the choice of suitable
quantization characteristics for both the decoder messages and the
received samples in Low Density Parity Check (LDPC) coded
systems using M-QAM (Quadrature Amplitude Modulation)
schemes. The analysis involves the demapper block that provides
initial likelihood values for the decoder, by relating its quantization
strategy of the decoder. A mapping strategy refers to the grouping of
bits within a codeword, where each m-bit group is used to select a
2m-ary signal in accordance with the signal labels. Further we
evaluate the system with mapping strategies like Consecutive-Bit
(CB) and Bit-Reliability (BR). A new demapper version, based on
approximate expressions, is also presented to yield a low complexity
hardware implementation.
Abstract: Multiparty voice over IP (MVoIP) systems allows a group of people to freely communicate each other via the internet, which have many applications such as online gaming, teleconferencing, online stock trading etc. Peertalk is a peer to peer multiparty voice over IP system (MVoIP) which is more feasible than existing approaches such as p2p overlay multicast and coupled distributed processing. Since the stream mixing and distribution are done by the peers, it is vulnerable to major security threats like nodes misbehavior, eavesdropping, Sybil attacks, Denial of Service (DoS), call tampering, Man in the Middle attacks etc. To thwart the security threats, a security framework called PEERTS (PEEred Reputed Trustworthy System for peertalk) is implemented so that efficient and secure communication can be carried out between peers.
Abstract: In this paper present a sensorless maximum wind power extraction for variable speed constant frequency (VSCF) wind power generation systems with a doubly-fed induction generators (DFIG), to ensure stability and to impose the ideal feedback control solution despite of model uncertainties , using the principles of an active and reactive power controller (DPC) a robust sliding mode power control has been proposed to guarantees fast response times and precise control actions for control the active and reactive power independently. The simulation results in MATLAB/Simulink platform confirmed the good dynamic performance of power control approach for DFIGbased variable speed wind turbines.
Abstract: Typical Intelligent Decision Support System is 4-based, its design composes of Data Warehouse, Online Analytical Processing, Data Mining and Decision Supporting based on models, which is called Decision Support System Based on Data Warehouse (DSSBDW). This way takes ETL,OLAP and DM as its implementing means, and integrates traditional model-driving DSS and data-driving DSS into a whole. For this kind of problem, this paper analyzes the DSSBDW architecture and DW model, and discusses the following key issues: ETL designing and Realization; metadata managing technology using XML; SQL implementing, optimizing performance, data mapping in OLAP; lastly, it illustrates the designing principle and method of DW in DSSBDW.
Abstract: The brain MR imaging-based clinical research and analysis system were specifically built and the development for a large-scale data was targeted. We used the general clinical data available for building large-scale data. Registration period for the selection of the lesion ROI and the region growing algorithm was used and the Mesh-warp algorithm for matching was implemented. The accuracy of the matching errors was modified individually. Also, the large ROI research data can accumulate by our developed compression method. In this way, the correctly decision criteria to the research result was suggested. The experimental groups were age, sex, MR type, patient ID and smoking which can easily be queries. The result data was visualized of the overlapped images by a color table. Its data was calculated by the statistical package. The evaluation for the utilization of this system in the chronic ischemic damage in the area has done from patients with the acute cerebral infarction. This is the cause of neurologic disability index location in the center portion of the lateral ventricle facing. The corona radiate was found in the position. Finally, the system reliability was measured both inter-user and intra-user registering correlation.
Abstract: Dioscorea species or commonly named as yam is
reported to be one of the major food sources worldwide. This
ethnobotanical study was conducted to document local knowledge
and potentials of DioscoreahispidaDennst. and to investigate and
record its distribution in three districts of Terengganu. Information
was gathered from 23 villagers from three districts of Besut, Marang
and Setiu by using semi-structured questionnaire. The villagers were
randomly selected and no appointment was made prior to the visits.
For distribution, the location of Dioscoreahispida was recorded by
using the Global Positioning System (GPS). The villagers identified
Dioscoreahispida or locally named ubigadong by looking at the
physical characteristics that include its leaf shape, stem and the color
of the tuber-s flesh. The villagers used Dioscoreahispida in many
ways in their life such as for food, medicinal purposes and fish
poison.
Abstract: The results show that the bridge equipped with seismic isolation bearing system shows a high amount of energy dissipation. The purpose of the present study is to analyze the overall performance of continuous curved highway viaducts with different bearing supports, with an emphasis on the effectiveness of seismic isolation based on lead rubber bearing and hedge reaction force bearing system consisted of friction sliding bearing and rubber bearing. The bridge seismic performance has been evaluated on six different cases with six bearing models. The effects of the different arrangement of bearing on the deck superstructure displacements, the seismic damage at the bottom of the piers, movement track at the pier-s top and the total and strain energies absorbed by the structure are evaluated. In conclusion, the results provide sufficient evidence of the effectiveness on the use of seismic isolation on steel curved highway bridges.
Abstract: Presently and in line with the United Nations (EPA),
human thinking system has shifted towards clean fuels so as to
maintain a cleaner environment and to save our planet earth.
One of the most successful studies in order to achieve new
energies includes the use of animal wastes and their organic residues,
and the result of these researches has been represented in the form of
very simple and cheap methods called biogas technology. Biogas
technology has developed a lot in the recent decades; its reason is the
high cost of fossil fuels and the greater attention of countries to the
environmental pollutions due to the consumption of this kind of
fuels.
IRAN is ready for the optimized application of renewable
energies, having much enriched resources of this kind of energies; so
a special place could be considered for it when making programs.
The purpose of biogas technology is the recovery of energy and
finally the protection of the environment, which is much appropriate
for the third world farmers with respect to their technical abilities and
economic potentials. Studies show that the production and
consumption of biogas is appropriate and economic in IRAN,
because of the high amount of waste in the agriculture sector, the
significant amount of animal and human excrement production, the
great volume of garbage produced and the most important the
specific social, climatic and agricultural conditions in IRAN, in order
to proceed towards the reduction of pollution due to the use of fossil
fuels.
Abstract: Various intelligences and inspirations have been
adopted into the iterative searching process called as meta-heuristics.
They intelligently perform the exploration and exploitation in the
solution domain space aiming to efficiently seek near optimal
solutions. In this work, the bee algorithm, inspired by the natural
foraging behaviour of honey bees, was adapted to find the near
optimal solutions of the transportation management system, dynamic
multi-zone dispatching. This problem prepares for an uncertainty and
changing customers- demand. In striving to remain competitive,
transportation system should therefore be flexible in order to cope
with the changes of customers- demand in terms of in-bound and outbound
goods and technological innovations. To remain higher service
level but lower cost management via the minimal imbalance scenario,
the rearrangement penalty of the area, in each zone, including time
periods are also included. However, the performance of the algorithm
depends on the appropriate parameters- setting and need to be
determined and analysed before its implementation. BEE parameters
are determined through the linear constrained response surface
optimisation or LCRSOM and weighted centroid modified simplex
methods or WCMSM. Experimental results were analysed in terms
of best solutions found so far, mean and standard deviation on the
imbalance values including the convergence of the solutions
obtained. It was found that the results obtained from the LCRSOM
were better than those using the WCMSM. However, the average
execution time of experimental run using the LCRSOM was longer
than those using the WCMSM. Finally a recommendation of proper
level settings of BEE parameters for some selected problem sizes is
given as a guideline for future applications.
Abstract: A novel three-phase active power filter (APF) circuit with photovoltaic (PV) system to improve the quality of service and to reduce the capacity of energy storage capacitor is presented. The energy balance concept and sampling technique were used to simplify the calculation algorithm for the required utility source current and to control the voltage of the energy storage capacitor. The feasibility was verified by using the Pspice simulations and experiments. When the APF mode was used during non-operational period, not only the utilization rate, power factor and power quality could be improved, but also the capacity of energy storage capacitor could sparing. As the results, the advantages of the APF circuit are simplicity of control circuits, low cost, and good transient response.
Abstract: Virtual engineering technology has undergone rapid progress in recent years and is being adopted increasingly by manufacturing companies of many engineering disciplines. There is an increasing demand from industry for qualified virtual engineers. The qualified virtual engineers should have the ability of applying engineering principles and mechanical design methods within the commercial software package environment. It is a challenge to the engineering education in universities which traditionally tends to lack the integration of knowledge and skills required for solving real world problems. In this paper, a case study shows some recent development of a MSc Mechanical Engineering course at Department of Engineering and Technology in MMU, and in particular, two units Simulation of Mechanical Systems(SMS) and Computer Aided Fatigue Analysis(CAFA) that emphasize virtual engineering education and promote integration of knowledge acquisition, skill training and industrial application.
Abstract: Thanks to VR technology advanced, there are many
researches had used VR technology to develop a training system.
Using VR characteristics can simulate many kinds of situations to
reach our training-s goal. However, a good training system not only
considers real simulation but also considers learner-s learning
motivation. So, there are many researches started to conduct game-s
features into VR training system. We typically called this is a serious
game. It is using game-s features to engage learner-s learning
motivation. However, VR or Serious game has another important
advantage. That is simulating feature. Using this feature can create
any kinds of pressured environments. Because in the real
environment may happen any emergent situations. So, increasing the
trainees- pressure is more important when they are training. Most
pervious researches are investigated serious game-s applications and
learning performance. Seldom researches investigated how to
increase the learner-s mental workload when they are training. So, in
our study, we will introduce a real case study and create two types
training environments. Comparing the learner-s mental workload
between VR training and serious game.
Abstract: In general fuzzy sets are used to analyze the fuzzy
system reliability. Here intuitionistic fuzzy set theory for analyzing
the fuzzy system reliability has been used. To analyze the fuzzy
system reliability, the reliability of each component of the system as
a triangular intuitionistic fuzzy number is considered. Triangular
intuitionistic fuzzy number and their arithmetic operations are
introduced. Expressions for computing the fuzzy reliability of a
series system and a parallel system following triangular intuitionistic
fuzzy numbers have been described. Here an imprecise reliability
model of an electric network model of dark room is taken. To
compute the imprecise reliability of the above said system, reliability
of each component of the systems is represented by triangular
intuitionistic fuzzy numbers. Respective numerical example is
presented.
Abstract: Nosocomial (i.e., hospital-acquired) infections
(NI) is a major cause of morbidity and mortality in hospitals. NI
rate is higher in intensive care units (ICU) than in the general
ward due to patients with severe symptoms, poor immunity,
and accepted many invasive therapies. Contact behaviors
between health caregivers and patients is one of the infect
factors. It is difficult to obtain complete contact records by
traditional method of retrospective analysis of medical records.
This paper establishes a contact history inferential model
(CHIM) intended to extend the use of Proximity Sensing of
rapid frequency identification (RFID) technology to
transferring all proximity events between health caregivers and
patients into clinical events (close-in events, contact events and
invasive events).The results of the study indicated that the
CHIM can infer proximity care activities into close-in events
and contact events.
The infection control team could redesign and build optimal
workflow in the ICU according to the patient-specific contact
history which provided by our automatic tracing system.
Abstract: Wikis are promoted as collaborative writing tools that
allow students to transform a text into a collective document by
information sharing and group reflection. However, despite the
promising collaborative capabilities of wikis, their pedagogical value
regarding collaborative writing is still questionable. Wiki alone
cannot make collaborative writing happen, and students do not
automatically become more active, participate, and collaborate with
others when they use wikis. To foster collaborative writing and active
involvement in wiki development there is a need for a systematic
approach to wikis. Themain goal of this paper is to propose and
evaluate a co-writing approach to the development of wikis, along
with the study of three wiki applications to report on pedagogical
implications of collaborative writing in higher education.
Abstract: In this article, our objective is the analysis of the resolution of non-linear differential systems by combining Newton and Continuation (N-C) method. The iterative numerical methods converge where the initial condition is chosen close to the exact solution. The question of choosing the initial condition is answered by N-C method.
Abstract: Previous researches found that conventional WBL is effective for meaningful learner, because rote learner learn by repeating without thinking or trying to understand. It is impossible to have full benefit from conventional WBL. Understanding of rote learner-s intention and what influences it becomes important. Poorly designed user interface will discourage rote learner-s cultivation and intention to use WBL. Thus, user interface design is an important factor especially when WBL is used as comprehensive replacement of conventional teaching. This research proposes the influencing factors that can enhance learner-s intention to use the system. The enhanced TAM is used for evaluating the proposed factors. The research result points out that factors influencing rote learner-s intention are Perceived Usefulness of Homepage Content Structure, Perceived User Friendly Interface, Perceived Hedonic Component, and Perceived (homepage) Visual Attractiveness.
Abstract: In this paper application of artificial intelligence for
baby and children caring is studied. Then a new idea for injury
prevention and safety announcement is presented by using digital
image processing. The paper presents the structure of the proposed
system. The system determines the possibility of the dangers for
children and babies in yards, gardens and swimming pools or etc. In
the presented idea, multi camera System is used and receiver videos
are processed to find the hazardous areas then the entrance of
children and babies in the determined hazardous areas are analyzed.
In this condition the system does the programmed action capture,
produce alarm or tone or send message.
Abstract: This paper presents a speed sensorless direct torque
control scheme using space vector modulation (DTC-SVM) for
permanent magnet synchronous motor (PMSM) drive based a Model
Reference Adaptive System (MRAS) algorithm and stator resistance
estimator. The MRAS is utilized to estimate speed and stator
resistance and compensate the effects of parameter variation on stator
resistance, which makes flux and torque estimation more accurate
and insensitive to parameter variation. In other hand the use of SVM
method reduces the torque ripple while achieving a good dynamic
response. Simulation results are presented and show the effectiveness
of the proposed method.