Abstract: This study investigated the relationship between urban
and rural ozone concentrations and quantified the extent to which
ambient rural conditions and the concentrations of other pollutants
can be used to predict urban ozone concentrations. The study
describes the variations of ozone in weekday and weekends as well as
the daily maximum recorded at selected monitoring stations. The
results showed that Putrajaya station had the highest concentrations
of O3 on weekend due the titration of NO during the weekday.
Additionally, Jerantut had the lowest average concentration with a
reading value high on Wednesdays. The comparisons of average and
maximum concentrations of ozone for the three stations showed that
the strongest significant correlation is recorded in Jerantut station
with the value R2= 0.769. Ozone concentrations originating from a
neighbouring urban site form a better predictor to the urban ozone
concentrations than widespread rural ozone at some levels of
temporal averaging. It is found that in urban and rural of Malaysian
peninsular, the concentration of ozone depends on the concentration
of NOx and seasonal meteorological factors. The HYSPLIT Model
(the northeast monsoon) showed that the wind direction can also
influence the concentration of ozone in the atmosphere in the studied
areas.
Abstract: This study uses simulated meta-analysis to assess the effects of publication bias on meta-analysis estimates and to evaluate the efficacy of the trim and fill method in adjusting for these biases. The estimated effect sizes and the standard error were evaluated in terms of the statistical bias and the coverage probability. The results demonstrate that if publication bias is not adjusted it could lead to up to 40% bias in the treatment effect estimates. Utilization of the trim and fill method could reduce the bias in the overall estimate by more than half. The method is optimum in presence of moderate underlying bias but has minimal effects in presence of low and severe publication bias. Additionally, the trim and fill method improves the coverage probability by more than half when subjected to the same level of publication bias as those of the unadjusted data. The method however tends to produce false positive results and will incorrectly adjust the data for publication bias up to 45 % of the time. Nonetheless, the bias introduced into the estimates due to this adjustment is minimal
Abstract: This paper addresses control of commutation of switched reluctance (SR) motor without the use of a physical position detector. Rotor position detection schemes for SR motor based on magnetisation characteristics of the motor use normal excitation or applied current /voltage pulses. The resulting schemes are referred to as passive or active methods respectively. The research effort is in realizing an economical sensorless SR rotor position detector that is accurate, reliable and robust to suit a particular application. An effective and reliable means of generating commutation signals of an SR motor based on inductance profile of its stator windings determined using active probing technique is presented. The scheme has been validated online using a 4-phase 8/6 SR motor and an 8-bit processor.
Abstract: Detection of player identity is challenging task in sport video content analysis. In case of soccer video player number recognition is effective and precise solution. Jersey numbers can be considered as scene text and difficulties in localization and recognition appear due to variations in orientation, size, illumination, motion etc. This paper proposed new method for player number localization and recognition. By observing hue, saturation and value for 50 different jersey examples we noticed that most often combination of low and high saturated pixels is used to separate number and jersey region. Image segmentation method based on this observation is introduced. Then, novel method for player number localization based on internal contours is proposed. False number candidates are filtered using area and aspect ratio. Before OCR processing extracted numbers are enhanced using image smoothing and rotation normalization.
Abstract: An electrical apparatus for measuring moisture
content was developed by our laboratory and uses dependence of
electrical properties on water content in studied material. Error
analysis of the apparatus was run by measuring different volumes of
water in a simplified specimen, i.e. hollow plexiglass block, in order
to avoid as many side-effects as possible. Obtained data were
processed using both basic and advanced statistics and results were
compared with each other. The influence of water content on
accuracy of measured data was studied as well as the influence of
variation of apparatus' proper arrangement or factual methodics of its
usage. The overall coefficient of variation was 4%. There was no
trend found in results of error dependence on water content.
Comparison with current surveys led to a conclusion, that the studied
apparatus can be used for indirect measurement of water content in
porous materials, with expectable error and under known conditions.
Factual experiments with porous materials are not involved, but are
currently under investigation.
Abstract: When the crisscross baffles and logarithmic spiral
baffles are placed on the bottom of the stirred tank with elliptic
bottom, using CFD software FLUENT simulates the velocity field of
the stirred tank with elliptic bottom and bottom baffles. Compare the
velocity field of stirred tank with bottom crisscross baffle to the
velocity field of stirred tank without bottom baffle and analysis the
flow pattern on the same axis-section and different cross-sections. The
sizes of the axial and radial velocity are compared respectively when
the stirred tank with bottom crisscross baffles, bottom logarithmic
spiral baffles and without bottom baffle. At the same time, the
numerical calculations of mixing power are compared when the stirred
tank with bottom crisscross baffles and bottom logarithmic spiral
baffles. Research shows that bottom crisscross baffles and logarithmic
spiral baffles have a great impact on flow pattern within the reactor
and improve the mixing effect better than without baffle. It also has
shown that bottom logarithmic spiral baffles has lower power
consumption than bottom crisscross baffles.
Abstract: The aim of this studywas toinvestigate the effect
ofrunning classification (sprint, middle, and long distance)and two
distances on blood lactate (BLa), heart rate (HR), and rating of
perceived exertion (RPE) Borg scale ratings in collegiate athletes. On
different days, runners (n = 15) ran 400m and 1600m at a five min
mile pace, followed by a two min 6mph jog, and a two min 3mph
walk as part of the cool down. BLa, HR, and RPE were taken at
baseline, post-run, plus 2 and 4 min recovery times. The middle and
long distance runners exhibited lower BLa concentrations than sprint
runners after two min of recovery post 400 m runs, immediately after,
and two and four min recovery periods post 1600 m runs. When
compared to sprint runners, distance runners may have exhibited the
ability to clear BLa more quickly, particularly after running 1600 m.
Abstract: The approach based on the wavelet transform has
been widely used for image denoising due to its multi-resolution
nature, its ability to produce high levels of noise reduction and the
low level of distortion introduced. However, by removing noise, high
frequency components belonging to edges are also removed, which
leads to blurring the signal features. This paper proposes a new
method of image noise reduction based on local variance and edge
analysis. The analysis is performed by dividing an image into 32 x 32
pixel blocks, and transforming the data into wavelet domain. Fast
lifting wavelet spatial-frequency decomposition and reconstruction is
developed with the advantages of being computationally efficient and
boundary effects minimized. The adaptive thresholding by local
variance estimation and edge strength measurement can effectively
reduce image noise while preserve the features of the original image
corresponding to the boundaries of the objects. Experimental results
demonstrate that the method performs well for images contaminated
by natural and artificial noise, and is suitable to be adapted for
different class of images and type of noises. The proposed algorithm
provides a potential solution with parallel computation for real time
or embedded system application.
Abstract: The existence of many biological systems,
especially human societies, is based on cooperative behavior
[1, 2]. If natural selection favors selfish individuals, then what
mechanism is at work that we see so many cooperative
behaviors? One answer is the effect of network structure. On a
graph, cooperators can evolve by forming network bunches
[2, 3, 4]. In a research, Ohtsuki et al used the idea of iterated
prisoners- dilemma on a graph to model an evolutionary
game. They showed that the average number of neighbors
plays an important role in determining whether cooperation is
the ESS of the system or not [3]. In this paper, we are going to
study the dynamics of evolution of cooperation in a social
network. We show that during evolution, the ratio of
cooperators among individuals with fewer neighbors to
cooperators among other individuals is greater than unity. The
extent to which the fitness function depends on the payoff of
the game determines this ratio.
Abstract: Frequency domain independent component analysis has
a scaling indeterminacy and a permutation problem. The scaling
indeterminacy can be solved by use of a decomposed spectrum. For
the permutation problem, we have proposed the rules in terms of gain
ratio and phase difference derived from the decomposed spectra and
the source-s coarse directions.
The present paper experimentally clarifies that the gain ratio and
the phase difference work effectively in a real environment but their
performance depends on frequency bands, a microphone-space and
a source-microphone distance. From these facts it is seen that it is
difficult to attain a perfect solution for the permutation problem in a
real environment only by either the gain ratio or the phase difference.
For the perfect solution, this paper gives a solution to the problems
in a real environment. The proposed method is simple, the amount of
calculation is small. And the method has high correction performance
without depending on the frequency bands and distances from source
signals to microphones. Furthermore, it can be applied under the real
environment. From several experiments in a real room, it clarifies
that the proposed method has been verified.
Abstract: Water Sensitive Urban Design (WSUD) features are
increasingly used to treat and manage polluted stormwater runoff in urbanised areas. It is important to monitor and evaluate the effectiveness of the infrastructure in achieving their intended performance targets after constructing and operating these features
overtime. The paper presents the various methods of analysis used to
assess the effectiveness of the in-situ WSUD features, such as: onsite visual inspections during operational and non operational periods, maintenance audits and periodic water quality testing. The results will contribute to a better understanding of the operational and
maintenance needs of in-situ WSUD features and assist in providing recommendations to better manage life cycle performance.
Abstract: In this article, biomechanical aspects of hen-s eggshell as a natural ceramic structure are studied. The images, taken by a scanning electron microscope (SEM), are used to investigate the microscopic aspects of the egg. It is observed that eggshell has a three-layered microstructure with different morphological and structural characteristics. Studies on the eggshell membrane (ESM) as a prosperous tissue suggest that it is placed to prevent the penetration of microorganisms into the egg. Finally, numerical models of the egg are presented to study the stress distribution and its deformation under different loading conditions. The effects of two different types of loading (hydrostatic and point loadings) on two different shell models (with constant and variable thicknesses) are investigated in detail.
Abstract: Securing instream flows for aquatic ecosystems is
critical for sustainable water management and the promotion of
human and environmental health. Using a case study from the semiarid
region of southern Alberta (Canada) this paper considers how
the determination of instream flow standards requires judgments with
respect to: (1) The relationship between instream flow indicators and
assessments of overall environmental health; (2) The indicators used
to determine adequate instream flows, and; (3) The assumptions
underlying efforts to model instream flows given data constraints. It
argues that judgments in each of these areas have an inherently
ethical component because instream flows have direct effects on the
water(s) available to meet obligations to humans and non-humans.
The conclusion expands from the case study to generic issues
regarding instream flows, the growing water ethics literature and
prospects for linking science to policy.
Abstract: This paper proposes a Wavelength Division
Multiplexing (WDM) technology based Storage Area Network
(SAN) for all type of Disaster recovery operation. It considers
recovery when all paths failure in the network as well as the main
SAN site failure also the all backup sites failure by the effect of
natural disasters such as earthquakes, fires and floods, power outage,
and terrorist attacks, as initially SAN were designed to work within
distance limited environments[2]. Paper also presents a NEW PATH
algorithm when path failure occurs. The simulation result and
analysis is presented for the proposed architecture with performance
consideration.
Abstract: In this work the effects of uniaxial mechanical stress on a pixel readout circuit are theoretically analyzed. It is the effects of mechanical stress on the in-pixel transistors do not arise at the output, when a correlated double sampling circuit is used. However, mechanical stress effects on the photodiode will directly appear at the readout chain output. Therefore, compensation techniques are needed to overcome this situation. Moreover simulation technique of mechanical stress is proposed and diverse layout as well as design recommendations are put forward, in order to minimize stress related effects on the output of a circuit. he shown, that wever, Moreover, a out
Abstract: Outlier detection in streaming data is very challenging because streaming data cannot be scanned multiple times and also new concepts may keep evolving. Irrelevant attributes can be termed as noisy attributes and such attributes further magnify the challenge of working with data streams. In this paper, we propose an unsupervised outlier detection scheme for streaming data. This scheme is based on clustering as clustering is an unsupervised data mining task and it does not require labeled data, both density based and partitioning clustering are combined for outlier detection. In this scheme partitioning clustering is also used to assign weights to attributes depending upon their respective relevance and weights are adaptive. Weighted attributes are helpful to reduce or remove the effect of noisy attributes. Keeping in view the challenges of streaming data, the proposed scheme is incremental and adaptive to concept evolution. Experimental results on synthetic and real world data sets show that our proposed approach outperforms other existing approach (CORM) in terms of outlier detection rate, false alarm rate, and increasing percentages of outliers.
Abstract: Two-dimensional heat conduction within a composed solid material with a constant internal heat generation has been investigated numerically in a sector of the rotor a generator. The heat transfer between two adjacent materials is assumed to be purely conduction. Boundary conditions are assumed to be forced convection on the fluid side and adiabatic on symmetry lines. The control volume method is applied for the diffusion energy equation. Physical coordinates are transformed to the general curvilinear coordinates. Then by using a line-by-line method, the temperature distribution in a sector of the rotor has been determined. Finally, the results are normalized and the effect of cooling fluid on the maximum temperature of insulation is investigated.
Abstract: This paper introduces an adaptive control scheme to synchronize two identical Chua's systems. Introductory part of the paper is presented in the first part of the paper and then in the second part, a new theorem is proposed based on which an adaptive control scheme is developed to synchronize two identical modified Chua's circuit. Finally, numerical simulations are included to verify the effectiveness of the proposed control method.
Abstract: This paper shows the advantages of the material failure process simulation by improve finite elements with embedded discontinuities, using a new definition of traction vector, dependent on the discontinuity length and the angle. Particularly, two families of this kind of elements are compared: kinematically optimal symmetric and statically and kinematically optimal non-symmetric. The constitutive model to describe the behavior of the material in the symmetric formulation is a traction-displacement jump relationship equipped with softening after reaching the failure surface.
To show the validity of this symmetric formulation, representative numerical examples illustrating the performance of the proposed formulation are presented. It is shown that the non-symmetric family may over or underestimate the energy required to create a discontinuity, as this effect is related with the total length of the discontinuity, fact that is not noticed when the discontinuity path is a straight line.
Abstract: In this paper, we proposed the robust mobile object
detection method for light effect in the night street image block based
updating reference background model using block state analysis.
Experiment image is acquired sequence color video from steady
camera. When suddenly appeared artificial illumination, reference
background model update this information such as street light, sign
light. Generally natural illumination is change by temporal, but
artificial illumination is suddenly appearance. So in this paper for
exactly detect artificial illumination have 2 state process. First process
is compare difference between current image and reference
background by block based, it can know changed blocks. Second
process is difference between current image-s edge map and reference
background image-s edge map, it possible to estimate illumination at
any block. This information is possible to exactly detect object,
artificial illumination and it was generating reference background
more clearly. Block is classified by block-state analysis. Block-state
has a 4 state (i.e. transient, stationary, background, artificial
illumination). Fig. 1 is show characteristic of block-state respectively
[1]. Experimental results show that the presented approach works well
in the presence of illumination variance.