Abstract: The present study was conducted to observe the effect
of Plantago psyllium on blood glucose and cholesterol levels in
normal and alloxan induced diabetic rats. To investigate the effect of
Plantago psyllium 40 rats were included in this study divided into
four groups of ten rats in each group. One group A was normal,
second group B was diabetic, third group C was non diabetic and
hypercholesterolemic and fourth group D was diabetic and
hypercholesterolemic. Two groups B and D were made diabetic by
intraperitonial injection of alloxan dissolved in 1mL distilled water at
a dose of 125mg/Kg of body weight. Two groups C and D were
made hypercholesterolemic by oral administration of powder
cholesterol (1g/Kg of body weight). The blood samples from all the
rats were collected from coccygial vein on 1st day, then on 21st and
42nd day respectively. All the samples were analyzed for blood
glucose and cholesterol level by using enzymatic kits. The blood
glucose and cholesterol levels of treated groups of rats showed
significant reduction after 7 weeks of treatment with Plantago
psyllium. By statistical analysis of results it was found that Plantago
psyllium has anti-diabetic and hypocholesterolemic activity in
diabetic and hypercholesterolemic albino rats.
Abstract: This paper proposes a method which reduces power consumption in single-error correcting, double error-detecting checker circuits that perform memory error correction code. Power is minimized with little or no impact on area and delay, using the degrees of freedom in selecting the parity check matrix of the error correcting codes. The genetic algorithm is employed to solve the non linear power optimization problem. The method is applied to two commonly used SEC-DED codes: standard Hamming and odd column weight Hsiao codes. Experiments were performed to show the performance of the proposed method.
Abstract: The electrical interaction between two axisymmetric
spheroidal particles in an electrolyte solution is examined numerically.
A Galerkin finite element method combined with a Newton-Raphson
iteration scheme is proposed to evaluate the spatial variation in the
electrical potential, and the result obtained used to estimate the
interaction energy between two particles. We show that if the surface
charge density is fixed, the potential gradient is larger at a point, which
has a larger curvature, and if surface potential is fixed, surface charge
density is proportional to the curvature. Also, if the total interaction
energy against closest surface-to-surface curve exhibits a primary
maximum, the maximum follows the order (oblate-oblate) >
(sphere-sphere)>(oblate-prolate)>(prolate-prolate), and if the curve
has a secondary minimum, the absolute value of the minimum follows
the same order.
Abstract: The design of chaos-based secure communication
via synchronized modified Chua-s systems is investigated in
this paper. A continuous control law is proposed to ensure
synchronization of the master and slave modified Chua-s
systems by using the variable structure control technique.
Particularly, the concept of extended systems is introduced
such that a continuous control input is obtained to avoid
chattering phenomenon. Then, it becomes possible to ensure
that the message signal embedded in the transmitter can be
recovered in the receiver.
Abstract: Whit the increasing of traffic, noise emanated from
motor vehicles increases as well, which subsequently causes adding
to the stress of modern city. Thus, it is needed to look for most
critical areas in terms of environmental and social impact of noise.
There are several critical situations for noise emanated from motor
vehicles such as stop and go situation which usually occurs near
junctions or at-grade intersections. This study was conducted in two
locations, most common types of intersections, crossroads and Tjunctions.
The highest average noise levels are recorded during Go
phase for T-junction, 64.4 dB, and Drive phase for crossroad, 64 dB.
It implies that the existence of intersection caused the noise level to
increase. The vehicles starting to move produce more sound than
when they travel at a constant speed along the intersection. It is
suggested that special considerations and priority of allocating funds
should be given to these critical spots.
Abstract: Since its independence in 1962, Algeria has struggled
to establish an educational system tailored to the needs of the
population it may address. Considering the historical connection with
France, Algeria has always looked at the French language as a
cultural imperative until late in the seventies. After the Arabization
policy of 1971 and the socioeconomic changes taking place
worldwide, the use of English as a communicating vehicle started to
gain more space within globalized Algeria. Consequently, disparities
in the use of French started to fade away at the cross-roads leaving
more space to the teaching of English as a second foreign language.
Moreover, the introduction of the Bologna Process and the
European Credit Transfer System in Higher Education has
necessitated some innovations in the design and development of new
curricula adapted to the socioeconomic market. In this paper, I will
try to highlight the important historical dimensions Algeria has taken
towards the implementation of an English language methodology and
to the status it acquired from second foreign language, to first foreign
language to “the language of knowledge and sciences". I will also
propose new pedagogical perspectives for a better treatment of the
English language in order to encourage independent and autonomous
learning.
Abstract: Diagnostic goal of transformers in service is to detect the winding or the core in fault. Transformers are valuable equipment which makes a major contribution to the supply security of a power system. Consequently, it is of great importance to minimize the frequency and duration of unwanted outages of power transformers. So, Frequency Response Analysis (FRA) is found to be a useful tool for reliable detection of incipient mechanical fault in a transformer, by finding winding or core defects. The authors propose as first part of this article, the coupled circuits method, because, it gives most possible exhaustive modelling of transformers. And as second part of this work, the application of FRA in low frequency in order to improve and simplify the response reading. This study can be useful as a base data for the other transformers of the same categories intended for distribution grid.
Abstract: When the crisscross baffles and logarithmic spiral
baffles are placed on the bottom of the stirred tank with elliptic
bottom, using CFD software FLUENT simulates the velocity field of
the stirred tank with elliptic bottom and bottom baffles. Compare the
velocity field of stirred tank with bottom crisscross baffle to the
velocity field of stirred tank without bottom baffle and analysis the
flow pattern on the same axis-section and different cross-sections. The
sizes of the axial and radial velocity are compared respectively when
the stirred tank with bottom crisscross baffles, bottom logarithmic
spiral baffles and without bottom baffle. At the same time, the
numerical calculations of mixing power are compared when the stirred
tank with bottom crisscross baffles and bottom logarithmic spiral
baffles. Research shows that bottom crisscross baffles and logarithmic
spiral baffles have a great impact on flow pattern within the reactor
and improve the mixing effect better than without baffle. It also has
shown that bottom logarithmic spiral baffles has lower power
consumption than bottom crisscross baffles.
Abstract: Securing instream flows for aquatic ecosystems is
critical for sustainable water management and the promotion of
human and environmental health. Using a case study from the semiarid
region of southern Alberta (Canada) this paper considers how
the determination of instream flow standards requires judgments with
respect to: (1) The relationship between instream flow indicators and
assessments of overall environmental health; (2) The indicators used
to determine adequate instream flows, and; (3) The assumptions
underlying efforts to model instream flows given data constraints. It
argues that judgments in each of these areas have an inherently
ethical component because instream flows have direct effects on the
water(s) available to meet obligations to humans and non-humans.
The conclusion expands from the case study to generic issues
regarding instream flows, the growing water ethics literature and
prospects for linking science to policy.
Abstract: Two-dimensional heat conduction within a composed solid material with a constant internal heat generation has been investigated numerically in a sector of the rotor a generator. The heat transfer between two adjacent materials is assumed to be purely conduction. Boundary conditions are assumed to be forced convection on the fluid side and adiabatic on symmetry lines. The control volume method is applied for the diffusion energy equation. Physical coordinates are transformed to the general curvilinear coordinates. Then by using a line-by-line method, the temperature distribution in a sector of the rotor has been determined. Finally, the results are normalized and the effect of cooling fluid on the maximum temperature of insulation is investigated.
Abstract: This paper introduces an adaptive control scheme to synchronize two identical Chua's systems. Introductory part of the paper is presented in the first part of the paper and then in the second part, a new theorem is proposed based on which an adaptive control scheme is developed to synchronize two identical modified Chua's circuit. Finally, numerical simulations are included to verify the effectiveness of the proposed control method.
Abstract: The Malaysia Highway Authority (MHA) was
established by the Government in 1980 for the purpose of designing,
constructing and maintaining toll highways in Malaysia that include
the North-South Expressway and the Penang Bridge, which were
procured using the publicly-funded traditional procurement. However
following a recession in the mid 80-s, the operations of these tolledhighways
had been privatized to ensure that their operational services
continue through private financing as a result of long-term
concession agreement concurred between the Malaysian Government
and private operators. The change in the contract strategy for
highway projects in Malaysia would have a great tendency to dictate
a significant risk exposure towards the key parties involved,
particularly the Malaysian Government as project principal, unless
operational risks are clearly identified and managed via appropriate
mitigation measures prior to a contract signing.
This research identifies potential operational risks that have a
possibility to occur in highway projects in Malaysia from the
perspective of public sector clients. Since this research focuses on the
operational risks for highway projects in Malaysia, the initial results
acquired from literature review on the operational risks of highway
projects in some Asian countries are then justified by a number of
key individuals from the MHA through interviews. As a result,
among key operational risks that have possibility to occur in the
highway projects in Malaysia include initial toll-tariff decided by the
Government, traffic congestion, change of road network and overloaded
freight transportation, which could cause damage to the road
surface and hence affecting the operation of a particular highway.
Abstract: In this paper, we proposed the robust mobile object
detection method for light effect in the night street image block based
updating reference background model using block state analysis.
Experiment image is acquired sequence color video from steady
camera. When suddenly appeared artificial illumination, reference
background model update this information such as street light, sign
light. Generally natural illumination is change by temporal, but
artificial illumination is suddenly appearance. So in this paper for
exactly detect artificial illumination have 2 state process. First process
is compare difference between current image and reference
background by block based, it can know changed blocks. Second
process is difference between current image-s edge map and reference
background image-s edge map, it possible to estimate illumination at
any block. This information is possible to exactly detect object,
artificial illumination and it was generating reference background
more clearly. Block is classified by block-state analysis. Block-state
has a 4 state (i.e. transient, stationary, background, artificial
illumination). Fig. 1 is show characteristic of block-state respectively
[1]. Experimental results show that the presented approach works well
in the presence of illumination variance.
Abstract: In this paper, encrypted audio communications based on synchronization of coupled unified chaotic systems in master-slave configuration is numerically studied. We transmit the encrypted audio messages by using two unsecure channels. Encoding, transmission, and decoding audio messages in chaotic communication is presented.
Abstract: The Principal component regression (PCR) is a
combination of principal component analysis (PCA) and multiple linear regression (MLR). The objective of this paper is to revise the
use of PCR in shortwave near infrared (SWNIR) (750-1000nm) spectral analysis. The idea of PCR was explained mathematically and
implemented in the non-destructive assessment of the soluble solid
content (SSC) of pineapple based on SWNIR spectral data. PCR achieved satisfactory results in this application with root mean
squared error of calibration (RMSEC) of 0.7611 Brix°, coefficient of determination (R2) of 0.5865 and root mean squared error of crossvalidation
(RMSECV) of 0.8323 Brix° with principal components
(PCs) of 14.
Abstract: Tailor-welded Blanks (TWBs) are tailor made for
different complex component designs by welding multiple metal
sheets with different thicknesses, shapes, coatings or strengths prior
to forming. In this study the Hemispherical Die Stretching (HDS) test
(out-of-plane stretching) of TWBs were simulated via
ABAQUS/Explicit to obtain the Forming Limit Diagrams (FLDs) of
Stainless steel (AISI 304) laser welded blanks with different
thicknesses. Two criteria were used to detect the start of necking to
determine the FLD for TWBs and parent sheet metals. These two
criteria are the second derivatives of the major and thickness strains
that are given from the strain history of simulation. In the other word,
in these criteria necking starts when the second derivative of
thickness or major strain reaches its maximum. With having the time
of onset necking, one can measure the major and minor strains at the
critical area and determine the forming limit curve.
Abstract: IPsec protocol[1] is a set of security extensions
developed by the IETF and it provides privacy and authentication
services at the IP layer by using modern cryptography. In this paper,
we describe both of H/W and S/W architectures of our router system,
SRS-10. The system is designed to support high performance routing
and IPsec VPN. Especially, we used Cavium-s CN2560 processor to
implement IPsec processing in inline-mode.
Abstract: Due to its special data structure and manipulative principle, Object-Oriented Database (OODB) has a particular security protection and authorization methods. This paper first introduces the features of security mechanism about OODB, and then talked about authorization checking process of OODB. Implicit authorization mechanism is based on the subject hierarchies, object hierarchies and access hierarchies of the security authorization modes, and simplifies the authorization mode. In addition, to combine with other authorization mechanisms, implicit authorization can make protection on the authorization of OODB expediently and effectively.
Abstract: Transnational corporations (TNCs) are playing a major role in global R&D, not only through activities in their home countries but also increasingly abroad. However, the process of R&D offshoring is not yet discussed thoroughly. Based on in-depth case study on Agilent China Communications Operation, this paper presents a stage model for theorizing the R&D offshoring process. This stage model outlines 5 maturity levels of organization and the offshoring process: Subsidiary team, Mirror team, Independent team, Mirror sector and the Independent sector (from software engineering point of view, it is similar to the local team's capability level of maturity model). Moreover, the paper gives a detailed discussion on the relevant characteristics, as well as the ability/responsibility of transfer, priorities and the corresponding organization structure. It also gives the characteristics and key points of different level-s R&D offshoring implementation using actual team practice.
Abstract: The electric power industry is currently undergoing an unprecedented reform. One of the most exciting and potentially profitable recent developments is increasing usage of artificial intelligence techniques. The intention of this paper is to give an overview of using neural network (NN) techniques in power systems. According to the growth rate of NNs application in some power system subjects, this paper introduce a brief overview in fault diagnosis, security assessment, load forecasting, economic dispatch and harmonic analyzing. Advantages and disadvantages of using NNs in above mentioned subjects and the main challenges in these fields have been explained, too.