Abstract: This paper proposes new hybrid approaches for face
recognition. Gabor wavelets representation of face images is an
effective approach for both facial action recognition and face
identification. Perform dimensionality reduction and linear
discriminate analysis on the down sampled Gabor wavelet faces can
increase the discriminate ability. Nearest feature space is extended to
various similarity measures. In our experiments, proposed Gabor
wavelet faces combined with extended neural net feature space
classifier shows very good performance, which can achieve 93 %
maximum correct recognition rate on ORL data set without any preprocessing
step.
Abstract: The feasibility of employing solar radiation for
enhanced Fenton process in degradation of combined chlorpyrifos,
cypermethrin and chlorothalonil pesticides was examined. The effect
of various operating conditions of the process on biodegradability
improvement and mineralization of the pesticides were also
evaluated. The optimum operating conditions for treatment of
aqueous solution containing 100, 50 and 250 mg L-1 chlorpyrifos
cypermethrin and chlorothalonil, respectively were observed to be
H2O2/COD molar ratio 2, H2O2/Fe2+ molar ratio 25 and pH 3. Under
the optimum operating conditions, complete degradation of the
pesticides occurred in 1 min. Biodegradability (BOD5/COD)
increased from zero to 0.36 in 60 min, and COD and TOC removal
were 74.19 and 58.32%, respectively in 60 min. Due to
mineralization of organic carbon, decrease in ammonia-nitrogen from
22 to 4.3 mg L-1 and increase in nitrate from 0.7 to 18.1 mg L-1 in
60 min were recorded. The study indicated that solar photo-Fenton
process can be used for pretreatment of chlorpyrifos, cypermethrin
and chlorothalonil pesticides in aqueous solution for further
biological treatment.
Abstract: The paper deals with calculation of the parameters of
ceramic material from a set of destruction tests of ceramic heads of
total hip joint endoprosthesis. The standard way of calculation of the
material parameters consists in carrying out a set of 3 or 4 point
bending tests of specimens cut out from parts of the ceramic material
to be analysed. In case of ceramic heads, it is not possible to cut out
specimens of required dimensions because the heads are too small (if
the cut out specimens were smaller than the normalised ones, the
material parameters derived from them would exhibit higher strength
values than those which the given ceramic material really has). On
that score, a special testing jig was made, in which 40 heads were
destructed. From the measured values of circumferential strains of the
head-s external spherical surface under destruction, the state of stress
in the head under destruction was established using the final elements
method (FEM). From the values obtained, the sought for parameters
of the ceramic material were calculated using Weibull-s weakest-link
theory.
Abstract: The characterization of κ-carrageenan could provide a
better understanding of its functions in biological, medical and
industrial applications. Chemical and physical analyses of
carrageenan from seaweeds, Euchema cottonii L., were done to offer
information on its properties and the effects of Co-60 γ-irradiation on
its thermochemical characteristics. The structural and morphological
characteristics of κ-carrageenan were determined using scanning
electron microscopy (SEM) while the composition, molecular weight
and thermal properties were determined using attenuated total
reflectance Fourier transform infrared spectroscopy (ATR-FTIR), gel
permeation chromatography (GPC), thermal gravimetric analysis
(TGA) and differential scanning calorimetry (DSC). Further chemical
analysis was done using hydrogen-1 nuclear magnetic resonance (1H
NMR) and functional characteristics in terms of biocompatibility
were evaluated using cytotoxicity test.
Abstract: The main purpose of this paper is to research on the
methodologies of BYD to implement the opportune innovation. BYD
is a Chinese company which has the IT component manufacture, the
rechargeable battery and the automobile businesses. The paper deals
with the innovation methodology as the same as the IPR management
BYD implements in order to obtain the rapid growth of technology
development with the reasonable cost of money and time.
Abstract: In this paper the neural network-based controller is
designed for motion control of a mobile robot. This paper treats the
problems of trajectory following and posture stabilization of the
mobile robot with nonholonomic constraints. For this purpose the
recurrent neural network with one hidden layer is used. It learns
relationship between linear velocities and error positions of the
mobile robot. This neural network is trained on-line using the
backpropagation optimization algorithm with an adaptive learning
rate. The optimization algorithm is performed at each sample time to
compute the optimal control inputs. The performance of the proposed
system is investigated using a kinematic model of the mobile robot.
Abstract: We propose a decoy-pulse protocol for frequency-coded implementation of B92 quantum key distribution protocol. A direct extension of decoy-pulse method to frequency-coding scheme results in security loss as an eavesdropper can distinguish between signal and decoy pulses by measuring the carrier photon number without affecting other statistics. We overcome this problem by optimizing the ratio of carrier photon number of decoy-to-signal pulse to be as close to unity as possible. In our method the switching between signal and decoy pulses is achieved by changing the amplitude of RF signal as opposed to modulating the intensity of optical signal thus reducing system cost. We find an improvement by a factor of 100 approximately in the key generation rate using decoy-state protocol. We also study the effect of source fluctuation on key rate. Our simulation results show a key generation rate of 1.5×10-4/pulse for link lengths up to 70km. Finally, we discuss the optimum value of average photon number of signal pulse for a given key rate while also optimizing the carrier ratio.
Abstract: The Chinese Postman Problem (CPP) is one of the
classical problems in graph theory and is applicable in a wide range
of fields. With the rapid development of hybrid systems and model
based testing, Chinese Postman Problem with Time Dependent Travel
Times (CPPTDT) becomes more realistic than the classical problems.
In the literature, we have proposed the first integer programming
formulation for the CPPTDT problem, namely, circuit formulation,
based on which some polyhedral results are investigated and a cutting
plane algorithm is also designed. However, there exists a main drawback:
the circuit formulation is only available for solving the special
instances with all circuits passing through the origin. Therefore, this
paper proposes a new integer programming formulation for solving
all the general instances of CPPTDT. Moreover, the size of the circuit
formulation is too large, which is reduced dramatically here. Thus, it
is possible to design more efficient algorithm for solving the CPPTDT
in the future research.
Abstract: As the Computed Tomography(CT) requires normally
hundreds of projections to reconstruct the image, patients are exposed
to more X-ray energy, which may cause side effects such as cancer.
Even when the variability of the particles in the object is very less,
Computed Tomography requires many projections for good quality
reconstruction. In this paper, less variability of the particles in an
object has been exploited to obtain good quality reconstruction.
Though the reconstructed image and the original image have same
projections, in general, they need not be the same. In addition
to projections, if a priori information about the image is known,
it is possible to obtain good quality reconstructed image. In this
paper, it has been shown by experimental results why conventional
algorithms fail to reconstruct from a few projections, and an efficient
polynomial time algorithm has been given to reconstruct a bi-level
image from its projections along row and column, and a known sub
image of unknown image with smoothness constraints by reducing the
reconstruction problem to integral max flow problem. This paper also
discusses the necessary and sufficient conditions for uniqueness and
extension of 2D-bi-level image reconstruction to 3D-bi-level image
reconstruction.
Abstract: Wireless Mesh Networking is a promising proposal
for broadband data transmission in a large area with low cost and
acceptable QoS. These features- trade offs in WMNs is a hot research
field nowadays. In this paper a mathematical optimization framework
has been developed to maximize throughput according to upper
bound delay constraints. IEEE 802.11 based infrastructure
backhauling mode of WMNs has been considered to formulate the
MINLP optimization problem. Proposed method gives the full
routing and scheduling procedure in WMN in order to obtain
mentioned goals.
Abstract: Tomato powder has good potential as substitute of tomato paste and other tomato products. In order to protect physicochemical properties and nutritional quality of tomato during dehydration process, investigation was carried out using different drying methods and pretreatments. Solar drier and continuous conveyor (tunnel) drier were used for dehydration where as calcium chloride (CaCl2), potassium metabisulphite (KMS), calcium chloride and potassium metabisulphite (CaCl2 +KMS), and sodium chloride (NaCl) selected for treatment.. lycopene content, dehydration ratio, rehydration ratio and non-enzymatic browning in addition to moisture, sugar and titrable acidity were studied. Results show that pre-treatment with CaCl2 and NaCl increased water removal and moisture mobility in tomato slices during drying of tomatoes. Where CaCl2 used along with KMS the NEB was recorded the least compared to other treatments and the best results were obtained while using the two chemicals in combination form. Storage studies in LDPE polymeric and metalized polyesters films showed less changes in the products packed in metallized polyester pouches and even after 6 months lycopene content did not decrease more than 20% as compared to the control sample and provide extension of shelf life in acceptable condition for 6 months. In most of the quality characteristics tunnel drier samples presented better values in comparison to solar drier.
Abstract: Dhaka, the capital city of Bangladesh, is one of the
densely populated cities in the world. Due to rapid urbanization 60%
of its population lives in slum and squatter settlements. The reason
behind this poverty is low economic growth, inequitable distribution
of income, unequal distribution of productive assets, unemployment
and underemployment, high rate of population growth, low level of
human resource development, natural disasters, and limited access to
public services. Along with poverty, creating pressure on urban land,
shelter, plots, open spaces this creates environmental and ecological
degradation. These constraints are mostly resulted from the failures
of the government policies and measures and only Government can
solve this problem. This is now prime time to establish planning and
environmental management policy and sustainable urban
development for the city and for the urban slum dwellers which are
free from eviction, criminals, rent seekers and other miscreants.
Abstract: Environment both endowed and built are essential for
tourism. However tourism and environment maintains a complex
relationship, where in most cases environment is at the receiving end.
Many tourism development activities have adverse environmental
effects, mainly emanating from construction of general infrastructure
and tourism facilities. These negative impacts of tourism can lead to
the destruction of precious natural resources on which it depends.
These effects vary between locations; and its effect on a hill
destination is highly critical. This study aims at developing a
Sustainable Tourism Planning Model for an environmentally
sensitive tourism destination in Kerala, India. Being part of the
Nilgiri mountain ranges, Munnar falls in the Western Ghats, one of
the biological hotspots in the world. Endowed with a unique high
altitude environment Munnar inherits highly significant ecological
wealth. Giving prime importance to the protection of this ecological
heritage, the study proposes a tourism planning model with resource
conservation and sustainability as the paramount focus. Conceiving a
novel approach towards sustainable tourism planning, the study
proposes to assess tourism attractions using Ecological Sensitivity
Index (ESI) and Tourism Attractiveness Index (TAI). Integration of
these two indices will form the Ecology – Tourism Matrix (ETM),
outlining the base for tourism planning in an environmentally
sensitive destination. The ETM Matrix leads to a classification of
tourism nodes according to its Conservation Significance and
Tourism Significance. The spatial integration of such nodes based on
the Hub & Spoke Principle constitutes sub – regions within the STZ.
Ensuing analyses lead to specific guidelines for the STZ as a whole,
specific tourism nodes, hubs and sub-regions. The study results in a
multi – dimensional output, viz., (1) Classification system for tourism
nodes in an environmentally sensitive region/ destination (2)
Conservation / Tourism Development Strategies and Guidelines for
the micro and macro regions and (3) A Sustainable Tourism Planning
Tool particularly for Ecologically Sensitive Destinations, which can
be adapted for other destinations as well.
Abstract: In this paper, an effective sliding mode design is
applied to chaos synchronization. The proposed controller can make
the states of two identical modified Chua-s circuits globally
asymptotically synchronized. Numerical results are provided to show
the effectiveness and robustness of the proposed method.
Abstract: This paper presents a genetic algorithm based
approach for solving security constrained optimal power flow
problem (SCOPF) including FACTS devices. The optimal location of
FACTS devices are identified using an index called overload index
and the optimal values are obtained using an enhanced genetic
algorithm. The optimal allocation by the proposed method optimizes
the investment, taking into account its effects on security in terms of
the alleviation of line overloads. The proposed approach has been
tested on IEEE-30 bus system to show the effectiveness of the
proposed algorithm for solving the SCOPF problem.
Abstract: This paper focuses on analyzing medical diagnostic data using classification rules in data mining and context reduction in formal concept analysis. It helps in finding redundancies among the various medical examination tests used in diagnosis of a disease. Classification rules have been derived from positive and negative association rules using the Concept lattice structure of the Formal Concept Analysis. Context reduction technique given in Formal Concept Analysis along with classification rules has been used to find redundancies among the various medical examination tests. Also it finds out whether expensive medical tests can be replaced by some cheaper tests.
Abstract: A new SUZ-4 zeolite membrane with
tetraethlyammonium hydroxide as the template was fabricated on
mullite tube via hydrothermal sol-gel synthesis in a rotating
autoclave reactor. The suitable synthesis condition was SiO2:Al2O3
ratio of 21.2 for 4 days at 155 °C crystallization under autogenous
pressure. The obtained SUZ-4 possessed a high BET surface area of
396.4 m2/g, total pore volume at 2.611 cm3/g, and narrow pore size
distribution with 97 nm mean diameter and 760 nm long of needle
crystal shape. The SUZ-4 layer obtained from seeding crystallization
was thicker than that of without seeds or in situ crystallization.
Abstract: Modeling product configurations needs large amounts of knowledge about technical and marketing restrictions on the product. Previous attempts to automate product configurations concentrate on representations and management of the knowledge for specific domains in fixed and isolated computing environments. Since the knowledge about product configurations is subject to continuous change and hard to express, these attempts often failed to efficiently manage and exchange the knowledge in collaborative product development. In this paper, XML Topic Map (XTM) is introduced to represent and exchange the knowledge about product configurations in collaborative product development. A product configuration model based on XTM along with its merger and inference facilities enables configuration engineers in collaborative product development to manage and exchange their knowledge efficiently. A prototype implementation is also presented to demonstrate the proposed model can be applied to engineering information systems to exchange the product configuration knowledge.
Abstract: Discrete particle swarm optimization (DPSO) is a
powerful stochastic evolutionary algorithm that is used to solve the
large-scale, discrete and nonlinear optimization problems. However,
it has been observed that standard DPSO algorithm has premature
convergence when solving a complex optimization problem like
transmission expansion planning (TEP). To resolve this problem an
advanced discrete particle swarm optimization (ADPSO) is proposed
in this paper. The simulation result shows that optimization of lines
loading in transmission expansion planning with ADPSO is better
than DPSO from precision view point.
Abstract: Nowadays there are more than thirty maturity models
in different knowledge areas. Maturity model is an area of interest
that contributes organizations to find out where they are in a specific
knowledge area and how to improve it. As Information Resource
Management (IRM) is the concept that information is a major
corporate resource and must be managed using the same basic
principles used to manage other assets, assessment of the current
IRM status and reveal the improvement points can play a critical role
in developing an appropriate information structure in organizations.
In this paper we proposed a framework for information resource
management maturity model (IRM3) that includes ten best practices
for the maturity assessment of the organizations' IRM.