Abstract: In this paper, a low noise microwave bandpass filter
(BPF) is presented. This filter is fabricated by modifying the
conventional cross-coupled structure. The spurious response is
improved by using the end open coupled lines, and the influence of the
noise is minimized. Impedance matrix of the open end coupled circuit
clarifies the characteristic of the suppression of the spurious response.
The rejection of spurious suppression region of the proposed filter is
greater than 20 dB from 3-13 GHz. The measured results of the
fabricated filter confirm the concepts of the proposed design and
exhibits high performance.
Abstract: The wireless adhoc network is comprised of wireless
node which can move freely and are connected among themselves
without central infrastructure. Due to the limited transmission range
of wireless interfaces, in most cases communication has to be relayed
over intermediate nodes. Thus, in such multihop network each node
(also called router) is independent, self-reliant and capable to route
the messages over the dynamic network topology. Various protocols
are reported in this field and it is very difficult to decide the best one.
A key issue in deciding which type of routing protocol is best for
adhoc networks is the communication overhead incurred by the
protocol. In this paper STAR a table driven and DSR on demand
protocols based on IEEE 802.11 are analyzed for their performance
on different performance measuring metrics versus varying traffic
CBR load using QualNet 5.0.2 network simulator.
Abstract: This paper evaluate the multilevel modulation for
different techniques such as amplitude shift keying (M-ASK), MASK,
differential phase shift keying (M-ASK-Bipolar), Quaternary
Amplitude Shift Keying (QASK) and Quaternary Polarization-ASK
(QPol-ASK) at a total bit rate of 107 Gbps. The aim is to find a costeffective
very high speed transport solution. Numerical investigation
was performed using Monte Carlo simulations. The obtained results
indicate that some modulation formats can be operated at 100Gbps
in optical communication systems with low implementation effort
and high spectral efficiency.
Abstract: The computer modeling is carried out for parameter of
sensitivity of optoelectronic chemical and biosensors, using
phenomena of surface plasmon resonance (SPR). The physical model
of SPR-sensor-s is described with (or without) of modifications of
sensitive gold film surface by a dielectric layer. The variants of
increasing of sensitivity for SPR-biosensors, constructed on the
principle gold – dielectric – biomolecular layer are considered. Two
methods of mathematical treatment of SPR-curve are compared –
traditional, with estimation of sensor-s response as shift of the SPRcurve
minimum and proposed, for system with dielectric layer, using
calculating of the derivative in the point of SPR-curve half-width.
Abstract: Medical image data hiding has strict constrains such
as high imperceptibility, high capacity and high robustness.
Achieving these three requirements simultaneously is highly
cumbersome. Some works have been reported in the literature on
data hiding, watermarking and stegnography which are suitable for
telemedicine applications. None is reliable in all aspects. Electronic
Patient Report (EPR) data hiding for telemedicine demand it blind
and reversible. This paper proposes a novel approach to blind
reversible data hiding based on integer wavelet transform.
Experimental results shows that this scheme outperforms the prior
arts in terms of zero BER (Bit Error Rate), higher PSNR (Peak Signal
to Noise Ratio), and large EPR data embedding capacity with
WPSNR (Weighted Peak Signal to Noise Ratio) around 53 dB,
compared with the existing reversible data hiding schemes.
Abstract: Due to the mobility of users, many information
systems are now developed with the capability of supporting retrieval
of information from both static and mobile users. Hence, the
amount, content and format of the information retrieved will need to
be tailored according to the device and the user who requested for it.
Thus, this paper presents a framework for the design and
implementation of such a system, which is to be developed for
communicating final examination related information to the
academic community at one university in Malaysia. The concept of
personalization will be implemented in the system so that only highly
relevant information will be delivered to the users. The
personalization concept used will be based on user profiling as well
as context. The system in its final state will be accessible through cell
phones as well as intranet connected personal computers.
Abstract: This paper presents a method of model selection and
identification of Hammerstein systems by hybridization of the genetic
algorithm (GA) and particle swarm optimization (PSO). An unknown
nonlinear static part to be estimated is approximately represented
by an automatic choosing function (ACF) model. The weighting
parameters of the ACF and the system parameters of the linear
dynamic part are estimated by the linear least-squares method. On
the other hand, the adjusting parameters of the ACF model structure
are properly selected by the hybrid algorithm of the GA and PSO,
where the Akaike information criterion is utilized as the evaluation
value function. Simulation results are shown to demonstrate the
effectiveness of the proposed hybrid algorithm.
Abstract: This paper presents an approach for an unequal error
protection of facial features of personal ID images coding. We
consider unequal error protection (UEP) strategies for the efficient
progressive transmission of embedded image codes over noisy
channels. This new method is based on the progressive image
compression embedded zerotree wavelet (EZW) algorithm and UEP
technique with defined region of interest (ROI). In this case is ROI
equal facial features within personal ID image. ROI technique is
important in applications with different parts of importance. In ROI
coding, a chosen ROI is encoded with higher quality than the
background (BG). Unequal error protection of image is provided by
different coding techniques and encoding LL band separately. In our
proposed method, image is divided into two parts (ROI, BG) that
consist of more important bytes (MIB) and less important bytes
(LIB). The proposed unequal error protection of image transmission
has shown to be more appropriate to low bit rate applications,
producing better quality output for ROI of the compresses image.
The experimental results verify effectiveness of the design. The
results of our method demonstrate the comparison of the UEP of
image transmission with defined ROI with facial features and the
equal error protection (EEP) over additive white gaussian noise
(AWGN) channel.
Abstract: Partitioning is a critical area of VLSI CAD. In order to build complex digital logic circuits its often essential to sub-divide multi -million transistor design into manageable Pieces. This paper looks at the various partitioning techniques aspects of VLSI CAD, targeted at various applications. We proposed an evolutionary time-series model and a statistical glitch prediction system using a neural network with selection of global feature by making use of clustering method model, for partitioning a circuit. For evolutionary time-series model, we made use of genetic, memetic & neuro-memetic techniques. Our work focused in use of clustering methods - K-means & EM methodology. A comparative study is provided for all techniques to solve the problem of circuit partitioning pertaining to VLSI design. The performance of all approaches is compared using benchmark data provided by MCNC standard cell placement benchmark net lists. Analysis of the investigational results proved that the Neuro-memetic model achieves greater performance then other model in recognizing sub-circuits with minimum amount of interconnections between them.
Abstract: In this paper, we propose a modified version of the
Constant Modulus Algorithm (CMA) tailored for blind Decision
Feedback Equalizer (DFE) of first order Markovian time varying
channels. The proposed NonStationary CMA (NSCMA) is designed
so that it explicitly takes into account the Markovian structure of
the channel nonstationarity. Hence, unlike the classical CMA, the
NSCMA is not blind with respect to the channel time variations.
This greatly helps the equalizer in the case of realistic channels, and
avoids frequent transmissions of training sequences.
This paper develops a theoretical analysis of the steady state
performance of the CMA and the NSCMA for DFEs within a time
varying context. Therefore, approximate expressions of the mean
square errors are derived. We prove that in the steady state, the
NSCMA exhibits better performance than the classical CMA. These
new results are confirmed by simulation.
Through an experimental study, we demonstrate that the Bit Error
Rate (BER) is reduced by the NSCMA-DFE, and the improvement
of the BER achieved by the NSCMA-DFE is as significant as the
channel time variations are severe.
Abstract: In modern human computer interaction systems
(HCI), emotion recognition is becoming an imperative characteristic.
The quest for effective and reliable emotion recognition in HCI has
resulted in a need for better face detection, feature extraction and
classification. In this paper we present results of feature space analysis
after briefly explaining our fully automatic vision based emotion
recognition method. We demonstrate the compactness of the feature
space and show how the 2d/3d based method achieves superior features
for the purpose of emotion classification. Also it is exposed that
through feature normalization a widely person independent feature
space is created. As a consequence, the classifier architecture has
only a minor influence on the classification result. This is particularly
elucidated with the help of confusion matrices. For this purpose
advanced classification algorithms, such as Support Vector Machines
and Artificial Neural Networks are employed, as well as the simple k-
Nearest Neighbor classifier.
Abstract: The crystalline quality of the AlGaN/GaN high electron mobility transistor (HEMT) structure grown on a 200 mm silicon substrate has been investigated using UV-visible micro- Raman scattering and photoluminescence (PL). The visible Raman scattering probes the whole nitride stack with the Si substrate and shows the presence of a small component of residual in-plane stress in the thick GaN buffer resulting from a wafer bowing, while the UV micro-Raman indicates a tensile interfacial stress induced at the top GaN/AlGaN/AlN layers. PL shows a good crystal quality GaN channel where the yellow band intensity is very low compared to that of the near-band-edge transition. The uniformity of this sample is shown by measurements from several points across the epiwafer.
Abstract: WIMAX relay station mesh network has been approved by IEEE 802.16j as a standard to provide a highly data rate transmission, the RS was implemented to extend the coverage zone of the BS, for instance the MSs previously were out of the coverage of the BS they become in the coverage of the RS, therefore these MSs can have Admission control from the BS through the RS. This paper describe a problem in the mesh network Relay station, for instance the problem of how to serve the mobile stations (MSs) which are out of the Relay station coverage. This paper also proposed a solution for mobile stations out of the coverage of the WIMAX Relay stations mesh Network. Therefore Ad-hoc network defined as a solution by using its admission control schema and apply it on the mobiles inside and outside the Relay station coverage.
Abstract: The realization of current-mode quadrature oscillators
using current controlled current conveyor transconductance
amplifiers (CCCCTAs) and grounded capacitors is presented. The
proposed oscillators can provide 2 sinusoidal output currents with 90º
phase difference. It is enabled non-interactive dual-current control for
both the condition of oscillation and the frequency of oscillation.
High output impedances of the configurations enable the circuit to be
cascaded without additional current buffers. The use of only
grounded capacitors is ideal for integration. The circuit performances
are depicted through PSpice simulations, they show good agreement
to theoretical anticipation.
Abstract: This paper presented a MATLAB-based system named Smart Access Network Testing, Analyzing and Database (SANTAD), purposely for in-service transmission surveillance and self restoration against fiber fault in fiber-to-the-home (FTTH) access network. The developed program will be installed with optical line terminal (OLT) at central office (CO) to monitor the status and detect any fiber fault that occurs in FTTH downwardly from CO towards residential customer locations. SANTAD is interfaced with optical time domain reflectometer (OTDR) to accumulate every network testing result to be displayed on a single computer screen for further analysis. This program will identify and present the parameters of each optical fiber line such as the line's status either in working or nonworking condition, magnitude of decreasing at each point, failure location, and other details as shown in the OTDR's screen. The failure status will be delivered to field engineers for promptly actions, meanwhile the failure line will be diverted to protection line to ensure the traffic flow continuously. This approach has a bright prospect to improve the survivability and reliability as well as increase the efficiency and monitoring capabilities in FTTH.
Abstract: In this paper, various algorithms for designing quadrature mirror filter are reviewed and a new algorithm is presented for the design of near perfect reconstruction quadrature mirror filter bank. In the proposed algorithm, objective function is formulated using the perfect reconstruction condition or magnitude response condition of prototype filter at frequency (ω = 0.5π) in ideal condition. The cutoff frequency is iteratively changed to adjust the filters coefficients using optimization algorithm. The performances of the proposed algorithm are evaluated in term of computation time, reconstruction error and number of iterations. The design examples illustrate that the proposed algorithm is superior in term of peak reconstruction error, computation time, and number of iterations. The proposed algorithm is simple, easy to implement, and linear in nature.
Abstract: Bandwidth allocation in wired network is less complex
and to allocate bandwidth in wireless networks is complex and
challenging, due to the mobility of source end system.This paper
proposes a new approach to bandwidth allocation to higher and lower
priority mobile nodes.In our proposal bandwidth allocation to new
mobile node is based on bandwidth utilization of existing mobile
nodes.The first section of the paper focuses on introduction to
bandwidth allocation in wireless networks and presents the existing
solutions available for allocation of bandwidth. The second section
proposes the new solution for the bandwidth allocation to higher and
lower priority nodes. Finally this paper ends with the analytical
evaluation of the proposed solution.
Abstract: Wireless Mesh Networks (WMNs) are an emerging
technology for last-mile broadband access. In WMNs, similar to ad
hoc networks, each user node operates not only as a host but also as a
router. User packets are forwarded to and from an Internet-connected
gateway in multi-hop fashion. The WMNs can be integrated with
other networking technologies i.e. ad hoc networks, to implement a
smooth network extension. The meshed topology provides good
reliability and scalability, as well as low upfront investments. Despite
the recent start-up surge in WMNs, much research remains to be
done in standardizing the functional parameters of WMNs to fully
exploit their full potential. An edifice of the security concerns of
these networks is authentication of a new client joining an integrated
ad hoc network and such a scenario will require execution of a multihop
authentication technique. Our endeavor in this paper is to
introduce a secure authentication technique, with light over-heads
that can be conveniently implemented for the ad-hoc nodes forming
clients of an integrated WMN, thus facilitating their inter-operability.
Abstract: Efficient handoff algorithms are a cost-effective way
of enhancing the capacity and QoS of cellular system. The higher
value of hysteresis effectively prevents unnecessary handoffs but
causes undesired cell dragging. This undesired cell dragging causes
interference or could lead to dropped calls in microcellular
environment. The problems are further exacerbated by the corner
effect phenomenon which causes the signal level to drop by 20-30 dB
in 10-20 meters. Thus, in order to maintain reliable communication
in a microcellular system new and better handoff algorithms must be
developed. A fuzzy based handoff algorithm is proposed in this paper
as a solution to this problem. Handoff on the basis of ratio of slopes
of normal signal loss to the actual signal loss is presented. The fuzzy
based solution is supported by comparing its results with the results
obtained in analytical solution.
Abstract: The effect of thermally induced stress on the modal
properties of highly elliptical core optical fibers is studied in this
work using a finite element method. The stress analysis is carried out
and anisotropic refractive index change is calculated using both the
conventional plane strain approximation and the generalized plane
strain approach. After considering the stress optical effect, the modal
analysis of the fiber is performed to obtain the solutions of
fundamental and higher order modes. The modal effective index,
modal birefringence, group effective index, group birefringence, and
dispersion of different modes of the fiber are presented. For
propagation properties, it can be seen that the results depend much on
the approach of stress analysis.