Abstract: The increasing importance of FlexRay systems in
automotive domain inspires unceasingly relative researches. One
primary issue among researches is to verify the reliability of FlexRay
systems either from protocol aspect or from system design aspect.
However, research rarely discusses the effect of network topology on
the system reliability. In this paper, we will illustrate how to model
the reliability of FlexRay systems with various network topologies by
a well-known probabilistic reasoning technology, Bayesian Network.
In this illustration, we especially investigate the effectiveness of error
containment built in star topology and fault-tolerant midpoint
synchronization algorithm adopted in FlexRay communication
protocol. Through a FlexRay steer-by-wire case study, the influence
of different topologies on the failure probability of the FlexRay steerby-
wire system is demonstrated. The notable value of this research is
to show that the Bayesian Network inference is a powerful and
feasible method for the reliability assessment of FlexRay systems.
Abstract: This paper contributes to the debate on the proximate
causes of climate change. Also, it discusses the impact of the global
temperature increases since the beginning of the twentieth century
and the effectiveness of climate change models in isolating the
primary cause (anthropogenic influences or natural variability in
temperature) of the observed temperature increases that occurred
within this period. The paper argues that if climate scientist and
policymakers ignore the anthropogenic influence (greenhouse gases)
on global warming on the pretense of lack of agreement among
various climate models and their inability to account for all the
necessary factors of global warming at all levels the current efforts of
greenhouse emissions control and global warming as a whole could
be exacerbated.
Abstract: The Partitioned Global Address Space (PGAS) programming
paradigm offers ease-of-use in expressing parallelism
through a global shared address space while emphasizing performance
by providing locality awareness through the partitioning of
this address space. Therefore, the interest in PGAS programming
languages is growing and many new languages have emerged and
are becoming ubiquitously available on nearly all modern parallel
architectures. Recently, new parallel machines with multiple cores
are designed for targeting high performance applications. Most of the
efforts have gone into benchmarking but there are a few examples of
real high performance applications running on multicore machines.
In this paper, we present and evaluate a parallelization technique
for implementing a local DNA sequence alignment algorithm using
a PGAS based language, UPC (Unified Parallel C) on a chip
multithreading architecture, the UltraSPARC T1.
Abstract: This paper presents an architecture to assist in the
development of tools to perform experimental analysis. Existing
implementations of tools based on this architecture are also described
in this paper. These tools are applied to the real world problem of
fault attack emulation and detection in cryptographic algorithms.
Abstract: For a variety of safety and economic reasons, engineering undergraduates in Australia have experienced diminishing access to the real hardware that is typically the embodiment of their theoretical studies. This trend will delay the development of practical competence, decrease the ability to model and design, and suppress motivation. The author has attempted to address this concern by creating a software tool that contains both photographic images of real machinery, and sets of graphical modeling 'tools'. Academics from a range of disciplines can use the software to set tutorial tasks, and incorporate feedback comments for a range of student responses. An evaluation of the software demonstrated that students who had solved modeling problems with the aid of the electronic tutor performed significantly better in formal examinations with similar problems. The 2-D graphical diagnostic routines in the Tutor have the potential to be used in a wider range of problem-solving tasks.
Abstract: Artificial Neural Networks (ANNs) have been used successfully in many scientific, industrial and business domains as a method for extracting knowledge from vast amounts of data. However the use of ANN techniques in the sporting domain has been limited. In professional sport, data is stored on many aspects of teams, games, training and players. Sporting organisations have begun to realise that there is a wealth of untapped knowledge contained in the data and there is great interest in techniques to utilise this data. This study will use player data from the elite Australian Football League (AFL) competition to train and test ANNs with the aim to predict the onset of injuries. The results demonstrate that an accuracy of 82.9% was achieved by the ANNs’ predictions across all examples with 94.5% of all injuries correctly predicted. These initial findings suggest that ANNs may have the potential to assist sporting clubs in the prediction of injuries.
Abstract: This paper presents an integrated case based and rule
based reasoning method for car faulty diagnosis. The reasoning
method is done through extracting the past cases from the Proton
Service Center while comparing with the preset rules to deduce a
diagnosis/solution to a car service case. New cases will be stored to
the knowledge base. The test cases examples illustrate the
effectiveness of the proposed integrated reasoning. It has proven
accuracy of similar reasoning if carried out by a service advisor from
the service center.
Abstract: In this study, a fuzzy similarity approach for Arabic web pages classification is presented. The approach uses a fuzzy term-category relation by manipulating membership degree for the training data and the degree value for a test web page. Six measures are used and compared in this study. These measures include: Einstein, Algebraic, Hamacher, MinMax, Special case fuzzy and Bounded Difference approaches. These measures are applied and compared using 50 different Arabic web-pages. Einstein measure was gave best performance among the other measures. An analysis of these measures and concluding remarks are drawn in this study.
Abstract: This paper describes an expanded system for a servo
system design by using the Loop Shaping Design Procedure (LSDP).
LSDP is one of the H∞ design procedure. By conducting Loop
Shaping with a compensator and robust stabilization to satisfy the
index function, we get the feedback controller that makes the control
system stable. In this paper, we propose an expanded system for a
servo system design and apply to the DC motor. The proposed method
performs well in the DC motor positioning control. It has no
steady-state error in the disturbance response and it has robust
stability.
Abstract: Threedimensional numerical simulations are conducted on a full scale CANDU Moderator and Transient variations of the temperature and velocity distributions inside the tank are determined. The results show that the flow and temperature distributions inside the moderator tank are three dimensional and no symmetry plane can be identified.Competition between the upward moving buoyancy driven flows and the downward moving momentum driven flows, results in the formation of circulation zones. The moderator tank operates in the buoyancy driven mode and any small disturbances in the flow or temperature makes the system unstable and asymmetric. Different types of temperature fluctuations are noted inside the tank: (i) large amplitude are at the boundaries between the hot and cold (ii) low amplitude are in the core of the tank (iii) high frequency fluctuations are in the regions with high velocities and (iv) low frequency fluctuations are in the regions with lower velocities.
Abstract: Production of biogas from bakery waste was enhanced
by additional bacterial cell. This study was divided into 2 steps. First
step, grease waste from bakery industry-s grease trap was initially
degraded by Pseudomonas aeruginosa. The concentration of byproduct,
especially glycerol, was determined and found that glycerol
concentration increased from 12.83% to 48.10%. Secondary step, 3
biodigesters were set up in 3 different substrates: non-degraded waste
as substrate in first biodigester, degraded waste as substrate in
secondary biodigester, and degraded waste mixed with swine manure
in ratio 1:1 as substrate in third biodigester. The highest
concentration of biogas was found in third biodigester that was
44.33% of methane and 63.71% of carbon dioxide. The lower
concentration at 24.90% of methane and 18.98% of carbon dioxide
was exhibited in secondary biodigester whereas the lowest was found
in non-degraded waste biodigester. It was demonstrated that the
biogas production was greatly increased with the initial grease waste
degradation by Pseudomonas aeruginosa.
Abstract: The noticeable advance in the area of computer technology has paved the way for the invention of powerful mobile devices. However, limited storage, short battery life, and relatively low computational power define the major problems of such devices. Due to the ever increasing computational requirements, such devices may fail to process needed tasks under certain constraints. One of the proposed solutions to this drawback is the introduction of Collaborative Computing, a new concept dealing with the distribution of computational tasks amongst several handhelds. This paper introduces the basics of Collaborative Computing, and proposes a new protocol that aims at managing and optimizing computing tasks in Ad-Hoc Collaborative Computing Environments.
Abstract: Variable digital filters are useful for various signal processing and communication applications where the frequency characteristics, such as fractional delays and cutoff frequencies, can be varied. In this paper, we propose a design method of variable FIR digital filters with an approximate linear phase characteristic in the passband. The proposed variable FIR filters have some large attenuation in stopband and their large attenuation can be varied by spectrum parameters. In the proposed design method, a quasi-equiripple characteristic can be obtained by using an iterative weighted least square method. The usefulness of the proposed design method is verified through some examples.
Abstract: Recently, Denial of Service(DoS) attacks and Distributed DoS(DDoS) attacks which are stronger form of DoS attacks from plural hosts have become security threats on the Internet. It is important to identify the attack source and to block attack traffic as one of the measures against these attacks. In general, it is difficult to identify them because information about the attack source is falsified. Therefore a method of identifying the attack source by tracing the route of the attack traffic is necessary. A traceback method which uses traffic patterns, using changes in the number of packets over time as criteria for the attack traceback has been proposed. The traceback method using the traffic patterns can trace the attack by matching the shapes of input traffic patterns and the shape of output traffic pattern observed at a network branch point such as a router. The traffic pattern is a shapes of traffic and unfalsifiable information. The proposed trace methods proposed till date cannot obtain enough tracing accuracy, because they directly use traffic patterns which are influenced by non-attack traffics. In this paper, a new traffic pattern matching method using Independent Component Analysis(ICA) is proposed.
Abstract: Active network was developed to solve the problem of
the current sharing-based network–difficulty in applying new
technology, service or standard, and duplicated operation at several
protocol layers. Active network can transport the packet loaded with
the executable codes, which enables to change the state of the network
node. However, if the network node is placed in the sharing-based
network, security and safety issues should be resolved. To satisfy this
requirement, various security aspects are required such as
authentication, authorization, confidentiality and integrity. Among
these security components, the core factor is the encryption key. As a
result, this study is designed to propose the scheme that manages the
encryption key, which is used to provide security of the
comprehensive active directory, based on the domain.
Abstract: In this paper, LDPC Codes based on defected fullerene
graphs have been generated. And it is found that the codes generated
are fast in encoding and better in terms of error performance on
AWGN Channel.
Abstract: It-s known that incorporating prior knowledge into support
vector regression (SVR) can help to improve the approximation
performance. Most of researches are concerned with the incorporation
of knowledge in form of numerical relationships. Little work,
however, has been done to incorporate the prior knowledge on the
structural relationships among the variables (referred as to Structural
Prior Knowledge, SPK). This paper explores the incorporation of SPK
in SVR by constructing appropriate admissible support vector kernel
(SV kernel) based on the properties of reproducing kernel (R.K).
Three-levels specifications of SPK are studies with the corresponding
sub-levels of prior knowledge that can be considered for the method.
These include Hierarchical SPK (HSPK), Interactional SPK (ISPK)
consisting of independence, global and local interaction, Functional
SPK (FSPK) composed of exterior-FSPK and interior-FSPK. A
convenient tool for describing the SPK, namely Description Matrix
of SPK is introduced. Subsequently, a new SVR, namely Motivated
Support Vector Regression (MSVR) whose structure is motivated
in part by SPK, is proposed. Synthetic examples show that it is
possible to incorporate a wide variety of SPK and helpful to improve
the approximation performance in complex cases. The benefits of
MSVR are finally shown on a real-life military application, Air-toground
battle simulation, which shows great potential for MSVR to
the complex military applications.
Abstract: This research is to study the performance of heat
pump dryer for drying of kaffir lime leaves under different media and
to compare the color values and essential oil content of final products
after drying. In the experiments, kaffir lime leaves were dried in the
closed-loop system at drying temperatures of 40, 50 and 60 oC. The
drying media used in this study were hot air, CO2 and N2 gases. The
velocity of drying media in the drying chamber was 0.4 m/s with
bypass ratio of 30%. The initial moisture content of kaffir lime leaves
was approximately 180-190 % d.b. It was dried until down to a final
moisture content of 10% d.b. From the experiments, the results
showed that drying rate, the coefficient of performance (COP) and
specific energy consumption (SEC) depended on drying temperature.
While drying media did not affect on drying rate. The time for kaffir
lime leaves drying at 40, 50 and 60 oC was 10, 5 and 3 hours,
respectively. The performance of the heat pump system decreased
with drying temperature in the range of 2.20-3.51. In the aspect of
final product color, the greenness and overall color had a great
change under drying temperature at 60 oC rather than drying at 40
and 50 oC. When compared among drying media, the greenness and
overall color of product dried with hot air at 60 oC had a great change
rather than dried with CO2 and N2.
Abstract: The home in these days has not one computer connected to the Internet but rather a network of many devices within the home, and that network might be connected to the Internet. In such an environment, the potential for attacks is greatly increased. The general security technology can not apply because of the use of various wired and wireless network, middleware and protocol in digital home environment and a restricted system resource of home information appliances. To offer secure home services home network environments have need of access control for various home devices and information when users want to access. Therefore home network access control for user authorization is a very important issue. In this paper we propose access control model using RBAC in home network environments to provide home users with secure home services.
Abstract: Innovations, especially technological, are considered
key-drivers for sustainable economic growth and competitiveness in
the globalised world. As such they should also play an important role
in the process of economical convergence inside the EU.
Unfortunately, the problem of insufficient innovation performance
concerns around half of the EU countries. Poland shows that a lack of
a consistent high-tech financing system constitutes a serious obstacle
for the development of innovative firms. In this article we will
evaluate these questions referring to the example of Ammono S.A., a
Polish company established to develop and commercialise an original
technology for the production of bulk GaN crystals. We will focus on
its efforts to accumulate the financial resources necessary at different
stages of its development. The purpose of this article is to suggest
possible ways to improve the national innovative system, which
would make it more competent in generating high-tech leaders.