Abstract: We consider here the subsonic impinging jet
representing the flow field of a vertical take-off aircraft or the initial
stage of rocket launching. Implicit Large-Eddy Simulation (ILES) is
used to calculate the time-dependent flow field and the radiate sound
pressure associated with jet impinging. With proper boundary
treatments and high-order numerical scheme, the near field sound
pressure is successfully obtained. Results are presented for both a
rectangular as well a circular jet.
Abstract: The implementation of Super-Ultra Low Emission
Vehicle standards requires more efficient exhaust gas purification. To
increase the efficiency of exhaust gas purification, an the adsorbent
capable of holding hydrocarbons up to 250-300 ОС should be
developed. The possibility to design such adsorbents by modification
of zeolites of mordenite type, ZSM-5 and NaY, using different
metals cations has been studied.
It has been shown that introducing Cr, Cs, Zn, Ni, Co, Li, Mn in
zeolites results in modification of the toluene TPD and toluene
sorption capacity.
5%LiZSM-5 zeolite exhibits the most attractive TPD curve, with
toluene desorption temperature ranging from 250 to 350ОС. The
sorption capacity of 5%Li-ZSM-5 is 0.4 mmol/g. NaY zeolite has the
highest sorption capacity, up to 2 mmol/g, and holds toluene up to
350ОС, but at 120ОС toluene desorption starts, which is not desirable,
since the adsorbent of cold start hydrocarbons should retain them
until 250-300ОС. Therefore 5%LiZSM-5 zeolite was found to be the
most promising to control the cold-start hydrocarbon emissions
among the samples studied.
Abstract: The purpose of this work is to establish the theoretical
foundations for calculating and designing the sublimationcondensation
processes in chemical apparatuses which are intended
for production of ultrafine powders of crystalline and amorphous
materials with controlled fractional composition. Theoretic analysis
of the primary processes of nucleation and growth kinetics of the
clusters according to the degree of super-saturation and the
homogeneous or heterogeneous nature of nucleation has been carried
out. The engineering design procedures of desublimation processes
have been offered and tested for modification of the Claus process.