Abstract: This work is an attempt to use the standard Smoothed
Particle Hydrodynamics methodology for the simulation of the
complex unsteady, free-surface flow in a rotating Turgo impulse
water turbine. A comparison of two different geometries was
conducted. The SPH method due to its mesh-less nature is capable of
capturing the flow features appearing in the turbine, without
diffusion at the water/air interface. Furthermore results are compared
with a commercial CFD package (Fluent®) and the SPH algorithm
proves to be capable of providing similar results, in much less time
than the mesh based CFD program. A parametric study was also
performed regarding the turbine inlet angle.
Abstract: Due to the complex network architecture, the mobile
adhoc network-s multihop feature gives additional problems to the
users. When the traffic load at each node gets increased, the
additional contention due its traffic pattern might cause the nodes
which are close to destination to starve the nodes more away from the
destination and also the capacity of network is unable to satisfy the
total user-s demand which results in an unfairness problem. In this
paper, we propose to create an algorithm to compute the optimal
MAC-layer bandwidth assigned to each flow in the network. The
bottleneck links contention area determines the fair time share which
is necessary to calculate the maximum allowed transmission rate used
by each flow. To completely utilize the network resources, we
compute two optimal rates namely, the maximum fair share and
minimum fair share. We use the maximum fair share achieved in
order to limit the input rate of those flows which crosses the
bottleneck links contention area when the flows that are not allocated
to the optimal transmission rate and calculate the following highest
fair share. Through simulation results, we show that the proposed
protocol achieves improved fair share and throughput with reduced
delay.
Abstract: Recently studies in area of supply chain network
(SCN) have focused on the disruption issues in distribution systems.
Also this paper extends the previous literature by providing a new biobjective
model for cost minimization of designing a three echelon
SCN across normal and failure scenarios with considering multi
capacity option for manufacturers and distribution centers. Moreover,
in order to solve the problem by means of LINGO software, novel
model will be reformulated through a branch of LP-Metric method
called Min-Max approach.
Abstract: The contamination of 15 ground water resources
of a selected region earmarked for the emergency supply
of population has been monitored. The resources have been selected
on the basis of previous assessment of natural conditions
and the exploitation of territory in their surroundings and infiltration
area. Two resources out of 15 have been excluded from further
exploitation, because they have not met some of the 72 assessed
hygienic indicators of extended analysis. The remaining 13 resources
have been the subject of health risk analysis in relation
to the contamination by arsenic, lead, cadmium, mercury, nickel and
manganese. The risk analysis proved that all 13 resources meet
health standards with regard to the above mentioned purposefully
selected elements and may thus be included into crisis plans. Water
quality of ground resources may be assessed in the same way
with regard to other contaminants.
Abstract: Obfuscation is a low cost software protection
methodology to avoid reverse engineering and re engineering of
applications. Source code obfuscation aims in obscuring the source
code to hide the functionality of the codes. This paper proposes an
Array data transformation in order to obfuscate the source code
which uses arrays. The applications using the proposed data
structures force the programmer to obscure the logic manually. It
makes the developed obscured codes hard to reverse engineer and
also protects the functionality of the codes.
Abstract: There have been different approaches to compute the
analytic instantaneous frequency with a variety of background reasoning
and applicability in practice, as well as restrictions. This paper presents an adaptive Fourier decomposition and (α-counting) based
instantaneous frequency computation approach. The adaptive Fourier
decomposition is a recently proposed new signal decomposition
approach. The instantaneous frequency can be computed through the so called mono-components decomposed by it. Due to the fast energy
convergency, the highest frequency of the signal will be discarded by the adaptive Fourier decomposition, which represents the noise of
the signal in most of the situation. A new instantaneous frequency
definition for a large class of so-called simple waves is also proposed
in this paper. Simple wave contains a wide range of signals for which
the concept instantaneous frequency has a perfect physical sense.
The α-counting instantaneous frequency can be used to compute the highest frequency for a signal. Combination of these two approaches one can obtain the IFs of the whole signal. An experiment is demonstrated the computation procedure with promising results.
Abstract: This paper describes an optimal approach for feature
subset selection to classify the leaves based on Genetic Algorithm
(GA) and Kernel Based Principle Component Analysis (KPCA). Due
to high complexity in the selection of the optimal features, the
classification has become a critical task to analyse the leaf image
data. Initially the shape, texture and colour features are extracted
from the leaf images. These extracted features are optimized through
the separate functioning of GA and KPCA. This approach performs
an intersection operation over the subsets obtained from the
optimization process. Finally, the most common matching subset is
forwarded to train the Support Vector Machine (SVM). Our
experimental results successfully prove that the application of GA
and KPCA for feature subset selection using SVM as a classifier is
computationally effective and improves the accuracy of the classifier.
Abstract: The thermal, epithermal and fast fluxes were
calculated for three irradiation channels at Egypt Second Research
Reactor (ETRR-2) using CITVAP code. The validity of the
calculations was verified by experimental measurements. There are
some deviations between measurements and calculations. This is due
to approximations in the calculation models used, homogenization of
regions, condensation of energy groups and uncertainty in nuclear
data used. Neutron flux data for the three irradiation channels are
now available. This would enable predicting the irradiation
conditions needed for future radioisotope production.
Abstract: This research deals with techno economic analysis to select the most economic desalination method for Asalouyeh combined cycle power plant . Due to lack of fresh water, desalination of sea water is necessary to provide required DM water of Power Plant. The most common desalination methods are RO, MSF, MED, and MED–TVC. In this research, methods of RO, MED, and MED– TVC have been compared. Simulation results show that recovery of heat of exhaust gas of main stack is optimum case for providing DM water required for injected steam of MED desalination. This subject is very important because of improving thermal efficiency of power plant using extra heat recovery. Also, it has been shown that by adding 3 rows of finned tube to de-aerator evaporator, which is very simple and low cost, required steam for generating 5200 m3/day of desalinated water is obtainable.
Abstract: Several studies have shown the association between
ambient particulate matter (PM) and adverse health effects and
climate change, thus highlighting the need to limit the anthropogenic
sources of PM. PM Exposure is commonly monitored as mass
concentration of PM10 (particle aerodynamic diameter < 10μm) or
PM2.5 (particle aerodynamic diameter < 2.5μm), although increasing
toxicity with decreasing aerodynamic diameter has been reported due
to increased surface area and enhanced chemical reactivity with other
species. Additionally, the light scattering properties of PM increases
with decreasing size. Hence, it is important to study the chemical
characterization of finer fraction of the particulate matter and to
identify their sources so that they can be controlled appropriately to a
large extent at the sources before reaching to the receptors.
Abstract: The power consumption of an Optical Packet Switch
equipped with SOA technology based Spanke switching fabric is
evaluated. Sophisticated analytical models are introduced to evaluate
the power consumption versus the offered traffic, the main
switch parameters, and the used device characteristics. The impact
of Amplifier Spontaneous Emission (ASE) noise generated by a
transmission system on the power consumption is investigated. As
a matter of example for 32×32 switches supporting 64 wavelengths
and offered traffic equal to 0,8, the average energy consumption per
bit is 5, 07 · 10-2 nJ/bit and increases if ASE noise introduced by
the transmission systems is increased.
Abstract: The objective of this paper is to use the Pfaffian
technique to construct different classes of exact Pfaffian solutions and
N-soliton solutions to some of the generalized integrable nonlinear
partial differential equations in (3+1) dimensions. In this paper, I will
show that the Pfaffian solutions to the nonlinear PDEs are nothing but
Pfaffian identities. Solitons are among the most beneficial solutions
for science and technology, from ocean waves to transmission of
information through optical fibers or energy transport along protein
molecules. The existence of multi-solitons, especially three-soliton
solutions, is essential for information technology: it makes possible
undisturbed simultaneous propagation of many pulses in both directions.
Abstract: Creep stresses and strain rates have been obtained
for a thin rotating disc having variable density with inclusion by
using Seth-s transition theory. The density of the disc is assumed to
vary radially, i.e. ( ) 0 ¤ü ¤ü r/b m - = ; ¤ü 0 and m being real positive
constants. It has been observed that a disc, whose density increases
radially, rotates at higher angular speed, thus decreasing the
possibility of a fracture at the bore, whereas for a disc whose
density decreases radially, the possibility of a fracture at the bore
increases.
Abstract: The hypercube Qn is one of the most well-known
and popular interconnection networks and the k-ary n-cube Qk
n is
an enlarged family from Qn that keeps many pleasing properties
from hypercubes. In this article, we study the panpositionable
hamiltonicity of Qk
n for k ≥ 3 and n ≥ 2. Let x, y of V (Qk
n)
be two arbitrary vertices and C be a hamiltonian cycle of Qk
n.
We use dC(x, y) to denote the distance between x and y on the
hamiltonian cycle C. Define l as an integer satisfying d(x, y) ≤ l ≤ 1
2 |V (Qk
n)|. We prove the followings:
• When k = 3 and n ≥ 2, there exists a hamiltonian cycle C
of Qk
n such that dC(x, y) = l.
• When k ≥ 5 is odd and n ≥ 2, we request that l /∈ S
where S is a set of specific integers. Then there exists a
hamiltonian cycle C of Qk
n such that dC(x, y) = l.
• When k ≥ 4 is even and n ≥ 2, we request l-d(x, y) to be
even. Then there exists a hamiltonian cycle C of Qk
n such
that dC(x, y) = l.
The result is optimal since the restrictions on l is due to the
structure of Qk
n by definition.
Abstract: In this study we investigate silica nanoparticle (SiO2- NP) effects on the structure and phase properties of supported lipid monolayers and bilayers, coupling surface pressure measurements, fluorescence microscopy and atomic force microscopy. SiO2-NPs typically in size range of 10nm to 100 nm in diameter are tested. Our results suggest first that lipid molecules organization depends to their nature. Secondly, lipid molecules in the vinicity of big aggregates nanoparticles organize in liquid condensed phase whereas small aggregates are localized in both fluid liquid-expanded (LE) and liquid-condenced (LC). We demonstrated also by atomic force microscopy that by measuring friction forces it is possible to get information as if nanoparticle aggregates are recovered or not by lipid monolayers and bilayers.
Abstract: In this paper, we present parallel alternating two-stage methods for solving linear system Ax = b, where A is a monotone matrix or an H-matrix. And we give some convergence results of these methods for nonsingular linear system.
Abstract: Recently, neural networks have shown good
results for detection of a certain pattern in a given image. In
our previous papers [1-5], a fast algorithm for pattern
detection using neural networks was presented. Such
algorithm was designed based on cross correlation in the
frequency domain between the input image and the weights
of neural networks. Image conversion into symmetric shape
was established so that fast neural networks can give the
same results as conventional neural networks. Another
configuration of symmetry was suggested in [3,4] to improve
the speed up ratio. In this paper, our previous algorithm for
fast neural networks is developed. The frequency domain
cross correlation is modified in order to compensate for the
symmetric condition which is required by the input image.
Two new ideas are introduced to modify the cross correlation
algorithm. Both methods accelerate the speed of the fast
neural networks as there is no need for converting the input
image into symmetric one as previous. Theoretical and
practical results show that both approaches provide faster
speed up ratio than the previous algorithm.
Abstract: A zero-field ferromagnetic Ising model is utilized to
simulate the propagation of infection in a population that assumes a
square lattice structure. The rate of infection increases with
temperature. The disease spreads faster among individuals with low J
values. Such effect, however, diminishes at higher temperatures.
Abstract: The group mutual exclusion (GME) problem is a
variant of the mutual exclusion problem. In the present paper a
token-based group mutual exclusion algorithm, capable of handling
transient faults, is proposed. The algorithm uses the concept of
dynamic request sets. A time out mechanism is used to detect the
token loss; also, a distributed scheme is used to regenerate the token.
The worst case message complexity of the algorithm is n+1. The
maximum concurrency and forum switch complexity of the
algorithm are n and min (n, m) respectively, where n is the number of
processes and m is the number of groups. The algorithm also satisfies
another desirable property called smooth admission. The scheme can
also be adapted to handle the extended group mutual exclusion
problem.
Abstract: Nowadays, where most of the leading economies are
service oriented and e-business is being widely used for their
management, supply chain management has become one of the most
studied and practiced fields. Quality has an important role on today-s
business processes, so it is important to understand the impact of IT
service quality on the performance of supply chains. This paper will
start by analyzing the Supply Chain Operations Reference (SCOR)
model and each of its five activities: Plan, Source, Make, Delivery,
and Return. This article proposes a framework for analyzing Effect of
IT Service Quality on Supply Chain Performance. Using the
proposed framework, hypotheses are framed for the direct effect of IT
service quality on Supply Chain Performance and its indirect effect
through effective Supply Chain Management. The framework will be
validated empirically based on the surveys of executives of various
organizations and statistical analyses of the data collected.