Abstract: With advances in computer vision, non-contact gaze tracking systems are heading towards being much easier to operate and more comfortable for use, the technique proposed in this paper is specially designed for achieving these goals. For the convenience in operation, the proposal aims at the system with simple configuration which is composed of a fixed wide angle camera and dual infrared illuminators. Then in order to enhance the usability of the system based on single camera, a self-adjusting method which is called Real-time gaze Tracking Algorithm with head movement Compensation (RTAC) is developed for estimating the gaze direction under natural head movement and simplifying the calibration procedure at the same time. According to the actual evaluations, the average accuracy of about 1° is achieved over a field of 20×15×15 cm3.
Abstract: The solution algorithm, based on Lagrangian relaxation, a sub-gradient method and a heuristic to find the upper bound of the solution, is proposed to solve the coordinated fleet routing and flight scheduling problems. Numerical tests are performed to evaluate the proposed algorithm using real operating data from two Taiwan airlines. The test results indicate that the solution algorithm is a significant improvement over those obtained with CPLEX, consequently they could be useful for allied airlines to solve coordinated fleet routing and flight scheduling problems.
Abstract: Dew harvesting needs only weak investment and
exploits a free, clean and inexhaustible energy. This study aims to
measure the relative contributions of dew and rain water in the
Mediterranean Dalmatian coast and islands of Croatia and determine
whether dew water is potable. Two sites were chosen, an open site on
the coast favourable to dew formation (Zadar) and a less favourable
site in a circus of mountains in Komiža (Vis Island). Between July
1st, 2003 and October 31st, 2006, dew hasbeen daily collected on a 1
m2 tilted (30°) test dew condenser together with ordinary
meteorological data (air temperature and relative humidity, cloud
coverage, windspeed and direction). The mean yearly cumulative
dew yields were found to be 20 mm (Zadar) and 9.3 mm (Komiža ).
During the dry season (May to October), monthly cumulative dew
water yield can represent up to 38% of water collected by rain fall. In
July 2003 and 2006, dew water represented about 120% of the
monthly cumulative rain water. Dew and rain water were analyzed in
Zadar. The corresponding parameters were measured: pH, electrical
conductivity, major anions (HCO3
-, Cl-, SO4
2-
, NO3
-
, ,) and major
cations (NH4
+, Na+, K+, Ca2+, Mg2+. Both dew and rain water are in
conformity with the WHO directives for potability except Mg2+.
Using existing roofs and refurbishing the abandoned impluviums to
permit dew collection could then provide a useful supplementary
amount of water, especially during the dry season.
Abstract: Number of documents being created increases at an
increasing pace while most of them being in already known topics
and little of them introducing new concepts. This fact has started a
new era in information retrieval discipline where the requirements
have their own specialties. That is digging into topics and concepts
and finding out subtopics or relations between topics. Up to now IR
researches were interested in retrieving documents about a general
topic or clustering documents under generic subjects. However these
conventional approaches can-t go deep into content of documents
which makes it difficult for people to reach to right documents they
were searching. So we need new ways of mining document sets
where the critic point is to know much about the contents of the
documents. As a solution we are proposing to enhance LSI, one of
the proven IR techniques by supporting its vector space with n-gram
forms of words. Positive results we have obtained are shown in two
different application area of IR domain; querying a document
database, clustering documents in the document database.
Abstract: The aim of current research was to investigate ASLT method suitability for accelerated beer shelf-life determination. The research was accomplished on popular Latvian beer: light filtrated and unfiltered pasteurized beer with alcohol content 5.2%; dark filtrated pasteurized beer with alcohol content 4.2% with shelf-life five months. Bottled in dark glass bottles beer samples were storage during 20 weeks at several temperature regimes: +10±1 °C, +20±1 °C, +30±1 °C, +40±1 °C. Samples quality parameters as physically-chemical and microbiological was tested every two weeks using standard methods. It is possible to determine beer shelf-life rapidly during storage at +30±1 °C for filtered pasteurized light beer by 2.5 times, unfiltered pasteurized light beer by 1.4 times and for filtered pasteurized dark beer by 1.7 times. During preset experiments it was proved, that it is possible to determine beer shelf-life rapidly using ASLT method if beer storage temperature could be increased by +10±1 °C.
Abstract: This paper presents a physics-based model for the
high-voltage fast recovery diodes. The model provides a good
trade-off between reverse recovery time and forward voltage drop
realized through a combination of lifetime control and emitter
efficiency reduction techniques. The minority carrier lifetime can be
extracted from the reverse recovery transient response and forward
characteristics. This paper also shows that decreasing the amount of
the excess carriers stored in the drift region will result in softer
characteristics which can be achieved using a lower doping level. The
developed model is verified by experiment and the measurement data
agrees well with the model.
Abstract: Let n ≥ 3 be an integer and p be a prime odd number. Let us consider Gp(n) the subgroup of (Z/nZ)* defined by : Gp(n) = {x ∈ (Z/nZ)* / xp = 1}. In this paper, we give an algorithm that computes a generating set of this subgroup.
Abstract: In this work, biohydrogen production via dark
fermentation from alcohol wastewater using upflow anaerobic sludge
blanket reactors (UASB) with a working volume of 4 L was
investigated to find the optimum conditions for a maximum hydrogen
yield. The system was operated at different COD loading rates (23,
31, 46 and 62 kg/m3d) at mesophilic temperature (37 ºC) and pH 5.5.
The seed sludge was pretreated before being fed to the UASB system
by boiling at 95 ºC for 15 min. When the system was operated under
the optimum COD loading rate of 46 kg/m3d, it provided the
hydrogen content of 27%, hydrogen yield of 125.1 ml H2/g COD
removed and 95.1 ml H2/g COD applied, hydrogen production rate of
18 l/d, specific hydrogen production rate of 1080 ml H2/g MLVSS d
and 1430 ml H2/ L d, and COD removal of 24%.
Abstract: The growth and interconnection of power networks in many regions has invited complicated techniques for energy management services (EMS). State estimation techniques become a powerful tool in power system control centers, and that more information is required to achieve the objective of EMS. For the online state estimator, assuming the continuous time is equidistantly sampled with period Δt, processing events must be finished within this period. Advantage of Kalman Filtering (KF) algorithm in using system information to improve the estimation precision is utilized. Computational power is a major issue responsible for the achievement of the objective, i.e. estimators- solution at a small sampled period. This paper presents the optimum utilization of processors in a state estimator based on KF. The model used is presented using Petri net (PN) theory.
Abstract: Cements, which are intrinsically brittle materials, can
exhibit a degree of pseudo-ductility when reinforced with a sufficient
volume fraction of a fibrous phase. This class of materials, called
Engineered Cement Composites (ECC) has the potential to be used in
future tunneling applications where a level of pseudo-ductility is
required to avoid brittle failures. However uncertainties remain
regarding mechanical performance. Previous work has focused on
comparatively thin specimens; however for future civil engineering
applications, it is imperative that the behavior in tension of thicker
specimens is understood. In the present work, specimens containing
cement powder and admixtures have been manufactured following
two different processes and tested in tension. Multiple matrix
cracking has been observed during tensile testing, leading to a
“strain-hardening" behavior, confirming the possible suitability of
ECC material when used as thick sections (greater than 50mm) in
tunneling applications.
Abstract: Mobile Ad Hoc Networks (MANETs) are multi-hop
wireless networks in which all nodes cooperatively maintain network
connectivity. In such a multi-hop wireless network, every node may
be required to perform routing in order to achieve end-to-end
communication among nodes. These networks are energy constrained
as most ad hoc mobile nodes today operate with limited battery
power. Hence, it is important to minimize the energy consumption of
the entire network in order to maximize the lifetime of ad hoc
networks. In this paper, a mechanism involving the integration of
load balancing approach and transmission power control approach is
introduced to maximize the life-span of MANETs. The mechanism is
applied on Ad hoc On-demand Vector (AODV) protocol to make it
as energy aware AODV (EA_AODV). The simulation is carried out
using GloMoSim2.03 simulator. The results show that the proposed
mechanism reduces the average required transmission energy per
packet compared to the standard AODV.
Abstract: This Paper presents a particle swarm optimization (PSO) method for determining the optimal proportional-integral-derivative (PID) controller parameters, for speed control of a linear brushless DC motor. The proposed approach has superior features, including easy implementation, stable convergence characteristic and good computational efficiency. The brushless DC motor is modelled in Simulink and the PSO algorithm is implemented in MATLAB. Comparing with Genetic Algorithm (GA) and Linear quadratic regulator (LQR) method, the proposed method was more efficient in improving the step response characteristics such as, reducing the steady-states error; rise time, settling time and maximum overshoot in speed control of a linear brushless DC motor.
Abstract: Amphawa is the most popular weekend destination for
both domestic and international tourists in Thailand. More than 112
homestays and resorts have been developed along the water
resources. This research aims to initiate appropriate environmental
management system for riverside tourist accommodations in
Amphawa by investigating current environmental characteristics.
Eighty-eight riverside tourist accommodations were survey from
specific questionnaire, GPS data were also gathered for spatial
analysis. The results revealed that the accommodations are welled
manage in regards to some environmental aspects. In order to reduce
economic costs, energy efficiency equipment is utilized. A substantial
number of tourist accommodations encouraged waste separation,
followed by transfer to local administration organization. Grease
traps also utilized in order to decrease chemical discharged, grease
and oil from canteen and restaurants on natural environment. The
most notable mitigation is to initiate environmental friendly cleansers
for tourist accommodation along the riverside in tourism destinations.
Abstract: A new data fusion method called joint probability density matrix (JPDM) is proposed, which can associate and fuse measurements from spatially distributed heterogeneous sensors to identify the real target in a surveillance region. Using the probabilistic grids representation, we numerically combine the uncertainty regions of all the measurements in a general framework. The NP-hard multisensor data fusion problem has been converted to a peak picking problem in the grids map. Unlike most of the existing data fusion method, the JPDM method dose not need association processing, and will not lead to combinatorial explosion. Its convergence to the CRLB with a diminishing grid size has been proved. Simulation results are presented to illustrate the effectiveness of the proposed technique.
Abstract: Quality control is the crucial step for ISO 9001
Quality System Management Standard for companies. While
measuring the quality level of both raw material and semi
product/product, the calibration of the measuring device is an
essential requirement. Calibration suppliers are in the service sector
and therefore the calibration supplier selection is becoming a worthy
topic for improving service quality.
This study presents the results of a questionnaire about the
selection criteria of a calibration supplier. The questionnaire was
applied to 103 companies and the results are discussed in this paper.
The analysis was made with MINITAB 14.0 statistical programs.
“Competence of documentations" and “technical capability" are
defined as the prerequisites because of the ISO/IEC17025:2005
standard. Also “warranties and complaint policy", “communication",
“service features", “quality" and “performance history" are defined as
very important criteria for calibration supplier selection.
Abstract: The flow filed around a flatted-roof compound has
been investigated by means of 2D and 3D numerical simulations. A
constant wind velocity profile, based both on the maximum reference
wind speed in the building site (peak gust speed worked out for a 50-
year return period) and on the local roughness coefficient, has been
simulated in order to determine the wind-induced loads on top of the
roof. After determining the influence of the incoming wind directions
on the induced roof loads, a 2D analysis of the most severe load
condition has been performed, achieving a numerical quantification
of the expected wind-induced forces on the PV panels on top of the
roof.
Abstract: Professional development is the focus of this study. It
reports on questionnaire data that examined the perceived
effectiveness of the Train the Trainer model of technology
professional development for elementary teachers. Eighty-three
selected teachers called Information Technology Coaches received
four half-day and one after-school in-service sessions. Subsequently,
coaches shared the information and skills acquired during training
with colleagues. Results indicated that participants felt comfortable
as Information Technology Coaches and felt well prepared because
of their technological professional development. Overall, participants
perceived the Train the Trainer model to be effective. The outcomes
of this study suggest that the use of the Train the Trainer model, a
known professional development model, can be an integral and
interdependent component of the newer more comprehensive
learning community professional development model.
Abstract: We intend to point out the differences which exist
between the classical Gini concentration coefficient and a proposed
bipolarization index defined for an arbitrary random variable which
have a finite support.
In fact Gini's index measures only the "poverty degree" for the
individuals from a given population taking into consideration their
wages. The Gini coefficient is not so sensitive to the significant
income variations in the "rich people class" .
In practice there are multiple interdependent relations between the
pauperization and the socio-economical polarization phenomena. The
presence of a strong pauperization aspect inside the population
induces often a polarization effect in this society. But the
pauperization and the polarization phenomena are not identical. For
this reason it isn't always adequate to use a Gini type coefficient,
based on the Lorenz order, to estimate the bipolarization level of the
individuals from the studied population.
The present paper emphasizes these ideas by considering two
families of random variables which have a linear or a triangular type
distributions. In addition, the continuous variation, depending on the
parameter "time" of the chosen distributions, could simulate a real
dynamical evolution of the population.
Abstract: In this investigation, the antibacterial effects of
ethanolic and 7:3 isopropyl –hexane mixture extracts of Zingiber
officinale were evaluated against three Gram positive bacteria, B.
cereus, S.epidermidis, S. aureus and three Gram negative bacteria, E.
coli, K.pneumonia and P.areuginosa. Utilizing paper disk diffusion
and well methods in-vitro, MIC and MBC were determined by
macrodilution. The results showed that ethanolic rhizome extract of
ginger had significantly active than Isopropyl –hexan extract. Further
work needs to be done in these extracts including fractionation to
isolate active constituents and subsequent pharmacological
evaluation.
Abstract: An effective method for the early detection of breast
cancer is the mammographic screening. One of the most important
signs of early breast cancer is the presence of microcalcifications. For
the detection of microcalcification in a mammography image, we
propose to conceive a multiagent system based on a dual irregular
pyramid.
An initial segmentation is obtained by an incremental approach;
the result represents level zero of the pyramid. The edge information
obtained by application of the Canny filter is taken into account to
affine the segmentation. The edge-agents and region-agents cooper
level by level of the pyramid by exploiting its various characteristics
to provide the segmentation process convergence.