Abstract: In this paper the fatigue crack initiation location of double shear lap joints, treated by interference fit and bolt clamping, have been investigated both experimentally and numerically. To do so, using the fracture section of available fatigue tested specimens of interference fitted and torque tightened Aluminum 2024-T3 plates, the crack initiation location was determined. The stress distribution attained from the finite element analysis was used to help explain the results observed in the experimental tests. The results showed that the fatigue crack initiation location changes from top and mid plane at the hole edge to somewhere far from the hole edge (stress concentration region) in different combination of clamping force, interference fit size and applied cyclic load ranges. It is worth mentioning that the fatigue crack initiation location affects the fatigue life of the specimens too.
Abstract: In this paper, removal of chromium(VI) from aqueous
solution has been researched using reverse osmosis. The influence of
transmembrane pressure and feed concentration on permeate flux,
water recovery, permeate concentration, and salt rejection was
studied. The results showed that according to the variation of
transmembrane pressure and feed concentration, the permeate flux
and salt rejection were in the range 19.17 to 58.75 l/m2.min and
99.51 to 99.8 %, respectively. The highest permeate flux, 58.75
l/m2.min, and water recovery, 42.47 %, were obtained in the highest
pressure and the lowest feed concentration. On the other hand, the
lowest permeate concentration, 0.01 mg/l, and the highest salt
rejection, 99.8 %, were obtained in the highest pressure and the
lowest feed concentration.
Abstract: This paper focuses on creating a component model of information system under uncertainty. The paper identifies problem in current approach of component modeling and proposes fuzzy tool, which will work with vague customer requirements and propose components of the resulting component model. The proposed tool is verified on specific information system and results are shown in paper. After finding suitable sub-components of the resulting component model, the component model is visualised by tool.
Abstract: Environment today is featured with aging population,
increasing prevalence of chronic disease and complex of medical
treatment. Safe use of pharmaceutics relied very much on the efforts
made by both the health- related organizations and as well as the
government agencies. As far as the specialization concern in providing
health services to the patients, the government actively issued and
implemented the divisions of medical treatment and pharmaceutical to
improve the quality of care and to reduce medication errors and ensure
public health. Pharmaceutical sub-sector policy has been implemented
for 13 years. This study attempts to explore the factors that affect the
patients- behavior intention of refilling a prescription from a NHIB
pharmacy. Samples were those patients refilling their prescriptions
with the case NHIB pharmacies. A self-administered questionnaire
was used to collect respondents- information while the patients or
family members visit the pharmacy for the refilling. 1,200
questionnaires were dispatched in 37 pharmacies that randomly
selected from Pingtung City, Dongkang, Chaozhou, Hengchun areas.
732 responses were gained with 604 valid samples for further analyses.
Results of data analyses indicated that respondents- attitude,
subjective norm, perceived behavior control and behavior intentions
toward refilling behavior varied from some demographic variables to
another. This research also suggested adding actual behavior, either by
a self-report or observed, into the research.
Abstract: Yam starch obtained from the water yam (munlued)
by the wet milling process was studied for some physicochemical
properties. Yam starch film was prepared by casting using glycerol as
a plasticizer. The effect of different glycerol (1.30, 1.65 and
2.00g/100g of filmogenic solution) and starch concentrations (3.30,
3.65 and 4.00g /100g of filmogenic solution) were evaluated on some
characteristics of the film. The temperature for obtaining the
gelatinized starch solution was 70-80°C and then dried at 45°C for 4
hours. The resulting starch from munlued granular morphology was
triangular and the average size of the granule was 26.68 μm. The
amylose content by colorimetric method was 26 % and the gelatinize
temperature was 70-80°C. The appearance of the film was smooth,
transparent, and glossy with average moisture content of 25.96% and
thickness of 0.01mm. Puncture deformation and flexibility increased
with glycerol content. The starch and glycerol concentration were a
significant factor of the yam starch film characteristics. Yam starch
film can be described as a biofilm providing many applications and
developments with the advantage of biodegradability.
Abstract: Early breast cancer detection is an emerging field of
research as it can save the women infected by malignant tumors.
Microwave breast imaging is based on the electrical property contrast
between healthy and malignant tumor. This contrast can be detected
by use of microwave energy with an array of antennas that illuminate
the breast through coupling medium and by measuring the scattered
fields. In this paper, author has been presented the design and
simulation results of the bowtie antenna. This bowtie antenna is
designed for the detection of breast cancer detection.
Abstract: India is currently the second most populous nation in
the world with over 1.2 billion people, growing annually at the rate of
1.5%. It is experiencing a surge in energy demands, expected to grow
more than three to four times in 25 years. Most of the energy
requirements are currently satisfied by the import of fossil fuels –
coal, petroleum-based products and natural gas. Biofuels can satisfy
these energy needs in an environmentally benign and cost effective
manner while reducing dependence on import of fossil fuels, thus
providing National Energy Security. Among various forms of
bioenergy, bioethanol is one of the major options for India because of
availability of feed stock crops.
This paper presents an overview on bioethanol production and
technology, steps taken by the Indian government to facilitate and
bring about optimal development and utilization of indigenous
biomass feedstocks for production of this biofuel.
Abstract: This paper presents the use of a newly created network
structure known as a Self-Delaying Dynamic Network (SDN) to
create a high resolution image from a set of time stepped input
frames. These SDNs are non-recurrent temporal neural networks
which can process time sampled data. SDNs can store input data
for a lifecycle and feature dynamic logic based connections between
layers. Several low resolution images and one high resolution image
of a scene were presented to the SDN during training by a Genetic
Algorithm. The SDN was trained to process the input frames in order
to recreate the high resolution image. The trained SDN was then used
to enhance a number of unseen noisy image sets. The quality of high
resolution images produced by the SDN is compared to that of high
resolution images generated using Bi-Cubic interpolation. The SDN
produced images are superior in several ways to the images produced
using Bi-Cubic interpolation.
Abstract: A series of microarray experiments produces observations
of differential expression for thousands of genes across multiple
conditions.
Principal component analysis(PCA) has been widely used in
multivariate data analysis to reduce the dimensionality of the data in
order to simplify subsequent analysis and allow for summarization of
the data in a parsimonious manner. PCA, which can be implemented
via a singular value decomposition(SVD), is useful for analysis of
microarray data.
For application of PCA using SVD we use the DNA microarray
data for the small round blue cell tumors(SRBCT) of childhood
by Khan et al.(2001). To decide the number of components which
account for sufficient amount of information we draw scree plot.
Biplot, a graphic display associated with PCA, reveals important
features that exhibit relationship between variables and also the
relationship of variables with observations.
Abstract: We present a novel scheme to evaluate sinusoidal functions with low complexity and high precision using cubic spline interpolation. To this end, two different approaches are proposed to find the interpolating polynomial of sin(x) within the range [- π , π]. The first one deals with only a single data point while the other with two to keep the realization cost as low as possible. An approximation error optimization technique for cubic spline interpolation is introduced next and is shown to increase the interpolator accuracy without increasing complexity of the associated hardware. The architectures for the proposed approaches are also developed, which exhibit flexibility of implementation with low power requirement.
Abstract: The crystalline quality of the AlGaN/GaN high electron mobility transistor (HEMT) structure grown on a 200 mm silicon substrate has been investigated using UV-visible micro- Raman scattering and photoluminescence (PL). The visible Raman scattering probes the whole nitride stack with the Si substrate and shows the presence of a small component of residual in-plane stress in the thick GaN buffer resulting from a wafer bowing, while the UV micro-Raman indicates a tensile interfacial stress induced at the top GaN/AlGaN/AlN layers. PL shows a good crystal quality GaN channel where the yellow band intensity is very low compared to that of the near-band-edge transition. The uniformity of this sample is shown by measurements from several points across the epiwafer.
Abstract: In this note, we investigate the blind source separability of linear FIR-MIMO systems. The concept of semi-reversibility of a system is presented. It is shown that for a semi-reversible system, if the input signals belong to a binary alphabet, then the source data can be blindly separated. One sufficient condition for a system to be semi-reversible is obtained. It is also shown that the proposed criteria is weaker than that in the literature which requires that the channel matrix is irreducible/invertible or reversible.
Abstract: The purpose of this paper is to improve electromagnetic characteristics on grounding grid by applying the conductive concrete. The conductive concrete in this study is under an extra high voltage (EHV, 345kV) system located in a high-tech industrial park or science park. Instead of surrounding soil of grounding grid, the application of conductive concrete can reduce equipment damage and body damage caused by switching surges. The focus of the two cases on the EHV distribution system in a high-tech industrial park is presented to analyze four soil material styles. By comparing several soil material styles, the study results have shown that the conductive concrete can effectively reduce the negative damages caused by electromagnetic transient. The adoption of the style of grounding grid located 1.0 (m) underground and conductive concrete located from the ground surface to 1.25 (m) underground can obviously improve the electromagnetic characteristics so as to advance protective efficiency.
Abstract: The National Agricultural Biotechnology Information
Center (NABIC) plays a leading role in the biotechnology information
database for agricultural plants in Korea. Since 2002, we have
concentrated on functional genomics of major crops, building an
integrated biotechnology database for agro-biotech information that
focuses on bioinformatics of major agricultural resources such as rice,
Chinese cabbage, and microorganisms. In the NABIC,
integration-based biotechnology database provides useful information
through a user-friendly web interface that allows analysis of genome
infrastructure, multiple plants, microbial resources, and living
modified organisms.
Abstract: Falling has been one of the major concerns and threats
to the independence of the elderly in their daily lives. With the
worldwide significant growth of the aging population, it is essential
to have a promising solution of fall detection which is able to operate
at high accuracy in real-time and supports large scale implementation
using multiple cameras. Field Programmable Gate Array (FPGA) is a
highly promising tool to be used as a hardware accelerator in many
emerging embedded vision based system. Thus, it is the main
objective of this paper to present an FPGA-based solution of visual
based fall detection to meet stringent real-time requirements with
high accuracy. The hardware architecture of visual based fall
detection which utilizes the pixel locality to reduce memory accesses
is proposed. By exploiting the parallel and pipeline architecture of
FPGA, our hardware implementation of visual based fall detection
using FGPA is able to achieve a performance of 60fps for a series of
video analytical functions at VGA resolutions (640x480). The results
of this work show that FPGA has great potentials and impacts in
enabling large scale vision system in the future healthcare industry
due to its flexibility and scalability.
Abstract: With the development of Internet and databases application techniques, the demand that lots of databases in the Internet are permitted to remote query and access for authorized users becomes common, and the problem that how to protect the copyright of relational databases arises. This paper simply introduces the knowledge of cloud model firstly, includes cloud generators and similar cloud. And then combined with the property of the cloud, a method of protecting relational databases copyright with cloud watermark is proposed according to the idea of digital watermark and the property of relational databases. Meanwhile, the corresponding watermark algorithms such as cloud watermark embedding algorithm and detection algorithm are proposed. Then, some experiments are run and the results are analyzed to validate the correctness and feasibility of the watermark scheme. In the end, the foreground of watermarking relational database and its research direction are prospected.
Abstract: An immunomodulator bioproduct is prepared in a
batch bioprocess with a modified bacterium Pseudomonas
aeruginosa. The bioprocess is performed in 100 L Bioengineering
bioreactor with 42 L cultivation medium made of peptone, meat
extract and sodium chloride. The optimal bioprocess parameters were
determined: temperature – 37 0C, agitation speed - 300 rpm, aeration
rate – 40 L/min, pressure – 0.5 bar, Dow Corning Antifoam M-max.
4 % of the medium volume, duration - 6 hours. This kind of
bioprocesses are appreciated as difficult to control because their
dynamic behavior is highly nonlinear and time varying. The aim of
the paper is to present (by comparison) different models based on
experimental data.
The analysis criteria were modeling error and convergence rate.
The estimated values and the modeling analysis were done by using
the Table Curve 2D.
The preliminary conclusions indicate Andrews-s model with a
maximum specific growth rate of the bacterium in the range of
0.8 h-1.
Abstract: This paper presents nonlinear elastic dynamic analysis
of 3-D semi-rigid steel frames including geometric and connection
nonlinearities. The geometric nonlinearity is considered by using
stability functions and updating geometric stiffness matrix. The
nonlinear behavior of the steel beam-to-column connection is
considered by using a zero-length independent connection element
comprising of six translational and rotational springs. The nonlinear
dynamic equilibrium equations are solved by the Newmark numerical
integration method. The nonlinear time-history analysis results are
compared with those of previous studies and commercial SAP2000
software to verify the accuracy and efficiency of the proposed
procedure.
Abstract: This paper presents an application of level sets for the segmentation of abdominal and thoracic aortic aneurysms in CTA
datasets. An important challenge in reliably detecting aortic is the
need to overcome problems associated with intensity
inhomogeneities. Level sets are part of an important class of methods
that utilize partial differential equations (PDEs) and have been extensively applied in image segmentation. A kernel function in the
level set formulation aids the suppression of noise in the extracted
regions of interest and then guides the motion of the evolving contour
for the detection of weak boundaries. The speed of curve evolution
has been significantly improved with a resulting decrease in segmentation time compared with previous implementations of level
sets, and are shown to be more effective than other approaches in
coping with intensity inhomogeneities. We have applied the Courant
Friedrichs Levy (CFL) condition as stability criterion for our algorithm.
Abstract: This paper presents a boarding on biometric
authentication through the Keystrokes Dynamics that it intends to
identify a person from its habitual rhythm to type in conventional
keyboard. Seven done experiments: verifying amount of prototypes,
threshold, features and the variation of the choice of the times of the
features vector. The results show that the use of the Keystroke
Dynamics is simple and efficient for personal authentication, getting
optimum resulted using 90% of the features with 4.44% FRR and 0%
FAR.