Abstract: A fault detection and identification (FDI) technique is
presented to create a fault tolerant control system (FTC). The fault
detection is achieved by monitoring the position of the light source
using an array of light sensors. When a decision is made about the
presence of a fault an identification process is initiated to locate the
faulty component and reconfigure the controller signals. The signals
provided by the sensors are predictable; therefore the existence of a
fault is easily identified. Identification of the faulty sensor is based on
the dynamics of the frame. The technique is not restricted to a
particular type of controllers and the results show consistency.
Abstract: Radiolabeled cyclic RGD peptides targeting integrin αvβ3 are reported as promising agents for the early diagnosis of metastatic tumors. With an aim to improve tumor uptake and retention of the peptide, cyclic RGD peptide dimer E[c (RGDfK)] 2 (E = Glutamic acid, f = phenyl alanine, K = lysine) coupled to the bifunctional chelator DOTA was custom synthesized and radiolabelled with 68Ga. Radiolabelling of cyclic RGD peptide dimer with 68Ga was carried out using HEPES buffer and biological evaluation of the complex was done in nude mice bearing HT29 tumors.
Abstract: In this paper, a framework is presented trying to make
the most secure web system out of the available generic and web
security technology which can be used as a guideline for
organizations building their web sites. The framework is designed to
provide necessary security services, to address the known security
threats, and to provide some cover to other security problems
especially unknown threats. The requirements for the design are
discussed which guided us to the design of secure web system. The
designed security framework is then simulated and various quality of
service (QoS) metrics are calculated to measure the performance of
this system.
Abstract: Reverse Engineering is a very important process in
Software Engineering. It can be performed backwards from system
development life cycle (SDLC) in order to get back the source data
or representations of a system through analysis of its structure,
function and operation. We use reverse engineering to introduce an
automatic tool to generate system requirements from its program
source codes. The tool is able to accept the Cµ programming source
codes, scan the source codes line by line and parse the codes to
parser. Then, the engine of the tool will be able to generate system
requirements for that specific program to facilitate reuse and
enhancement of the program. The purpose of producing the tool is to
help recovering the system requirements of any system when the
system requirements document (SRD) does not exist due to
undocumented support of the system.
Abstract: Wind catchers are traditional natural ventilation
systems attached to buildings in order to ventilate the indoor air. The
most common type of wind catcher is four sided one which is
capable to catch wind in all directions. CFD simulation is the perfect
way to evaluate the wind catcher performance. The accuracy of CFD
results is the issue of concern, so sensitivity analyses is crucial to
find out the effect of different settings of CFD on results. This paper
presents a series of 3D steady RANS simulations for a generic
isolated four-sided wind catcher attached to a room subjected to wind
direction ranging from 0º to 180º with an interval of 45º. The CFD
simulations are validated with detailed wind tunnel experiments. The
influence of an extensive range of computational parameters is
explored in this paper, including the resolution of the computational
grid, the size of the computational domain and the turbulence model.
This study found that CFD simulation is a reliable method for wind
catcher study, but it is less accurate in prediction of models with non
perpendicular wind directions.
Abstract: In this paper, a novel method for a biometric system based on the ECG signal is proposed, using spectral coefficients computed through linear predictive coding (LPC). ECG biometric systems have traditionally incorporated characteristics of fiducial points of the ECG signal as the feature set. These systems have been shown to contain loopholes and thus a non-fiducial system allows for tighter security. In the proposed system, incorporating non-fiducial features from the LPC spectrum produced a segment and subject recognition rate of 99.52% and 100% respectively. The recognition rates outperformed the biometric system that is based on the wavelet packet decomposition (WPD) algorithm in terms of recognition rates and computation time. This allows for LPC to be used in a practical ECG biometric system that requires fast, stringent and accurate recognition.
Abstract: Turbulent heat transfer to fluid flow through channel with triangular ribs of different angles are presented in this paper. Ansys 14 ICEM and Ansys 14 Fluent are used for meshing process and solving Navier stokes equations respectively. In this investigation three angles of triangular ribs with the range of Reynolds number varied from 20000 to 60000 at constant surface temperature are considered. The results show that the Nusselt number increases with the increase of Reynolds number for all cases at constant surface temperature. According to the profile of local Nusselt number on ribs walled of channel, the peak is at the midpoint between the two ribs. The maximum value of average Nusselt number is obtained for triangular ribs of angel 60°and at Reynolds number of 60000 compared to the Nusselt number for the ribs of angel 90° and 45° and at same Reynolds number. The recirculation regions generated by the ribs corresponding to the velocity streamline show the largest recirculation region at triangular ribs of angle 60° which also provides the highest enhancement of heat transfer.
Abstract: Seasonal variability of nutrients concentration in the Baltic Sea using the 3D ecosystem numerical model 3D-CEMBS has been investigated. Additionally this study shows horizontal and vertical distribution of nutrients in the Baltic Sea. Model domain is an extended Baltic Sea area divided into 600x640 horizontal grid cells. Aside from standard hydrodynamic parameters 3D-CEMBS produces modeled ecological variables such as: three types of phytoplankton, two detrital classes, dissolved oxygen and the nutrients (nitrate, ammonium, phosphate and silicate). The presented model allows prediction of parameters that describe distribution of nutrients concentration and phytoplankton biomass. 3D-CEMBS can be used to study the effect of different hydrodynamic and biogeochemical processes on distributions of these variables in a larger scale.
Abstract: Streamribbon is used to visualize the rotation of the
fluid flow. The rotation of flow is useful in fluid mechanics,
engineering and geophysics. This paper introduces the construction
technique of streamribbon using the streamline which is generated
based on the law of mass conservation. The accuracy of constructed
streamribbons is shown through two examples.
Abstract: This study uses natural water and the surface properties of powdered activated carbon to acclimatize organics, forming biofilms on the surface of powdered activated carbon. To investigate the influence of different hydraulic retention times on the removal efficacy of trace organics in raw water, and to determine the optimal hydraulic retention time of a biological powdered activated carbon system, this study selects ozone-treated water processed by Feng-shan Advanced Water Purification Plant in southern Taiwan for the experiment. The evaluation indicators include assimilable organic carbon, dissolved organic carbon, and total organic carbon. The results of this study can improve the quality of drinking water treated using advanced water purification procedures.
Abstract: There are extensive applications of lithium
bromide-water absorption chillers in industry, but the heat exchangers
corrosion and refrigerating capacity loss are very difficult to be solved.
In this paper, an experiment was conducted by using plastic heat
transfer tubes instead of copper tubes. As an example, for a lithium
bromide-water absorption chiller of refrigerating capacity of 35kW,
the correlative performance of the lithium bromide-water absorption
chiller using plastic heat transfer tubes was compared with the
traditional lithium bromide-water absorption chiller. And then the
following three aspects, i.e., heat transfer area, pipe resistance, and
safety strength, are analyzed. The results show that plastic heat
transfer tubes can be used on lithium bromide-water absorption
chillers, and its prospect is very optimistic.
Abstract: The main purpose of the research is to address the role of psychological harassment behaviors (mobbing) to which employees are exposed and personality characteristics over work alienation. Research population was composed of the employees of Provincial Special Administration. A survey with four sections was created to measure variables and reach out the basic goals of the research. Correlation and step-wise regression analyses were performed to investigate the separate and overall effects of sub-dimensions of psychological harassment behaviors and personality characteristic on work alienation of employees. Correlation analysis revealed significant but weak relationships between work alienation and psychological harassment and personality characteristics. Step-wise regression analysis revealed also significant relationships between work alienation variable and assault to personality, direct negative behaviors (sub dimensions of mobbing) and openness (sub-dimension of personality characteristics). Each variable was introduced into the model step by step to investigate the effects of significant variables in explaining the variations in work alienation. While the explanation ratio of the first model was 13%, the last model including three variables had an explanation ratio of 24%.
Abstract: Let T and S be a subspace of Cn and Cm, respectively.
Then for A ∈ Cm×n satisfied AT ⊕ S = Cm, the generalized
inverse A(2)
T,S is given by A(2)
T,S = (PS⊥APT )†. In this paper, a
finite formulae is presented to compute generalized inverse A(2)
T,S
under the concept of restricted inner product, which defined as <
A,B >T,S=< PS⊥APT,B > for the A,B ∈ Cm×n. By this
iterative method, when taken the initial matrix X0 = PTA∗PS⊥, the
generalized inverse A(2)
T,S can be obtained within at most mn iteration
steps in absence of roundoff errors. Finally given numerical example
is shown that the iterative formulae is quite efficient.
Abstract: Membrane distillation (MD) is a rising technology for
seawater or brine desalination process. In this work, an air gap
membrane distillation (AGMD) performance was investigated for
aqueous NaCl solution along with natural ground water and seawater.
In order to enhance the performance of the AGMD process in
desalination, that is, to get more flux, it is necessary to study the
effect of operating parameters on the yield of distillate water. The
influence of operational parameters such as feed flow rate, feed
temperature, feed salt concentration, coolant temperature and air gap
thickness on the membrane distillation (MD) permeation flux have
been investigated for low and high salt solution. the natural
application of ground water and seawater over 90 h continuous
operation, scale deposits observed on the membrane surface and
reduction in flux represents 23% for ground water and 60% for
seawater, in 90 h. This reduction was eliminated (less than 14 %) by
acidification of feed water. Hence, promote the research attention in
apply of AGMD for the ground water as well as seawater
desalination over today-s conventional RO operation.
Abstract: By means of Mawhin’s continuation theorem, we study a kind of third-order p-Laplacian functional differential equation with distributed delay in the form: ϕp(x (t)) = g t, 0 −τ x(t + s) dα(s) + e(t), some criteria to guarantee the existence of periodic solutions are obtained.
Abstract: The world wide web coupled with the ever-increasing
sophistication of online technologies and software applications puts
greater emphasis on the need of even more sophisticated and
consistent quality requirements modeling than traditional software
applications. Web sites and Web applications (WebApps) are
becoming more information driven and content-oriented raising the
concern about their information quality (InQ). The consistent and
consolidated modeling of InQ requirements for WebApps at different
stages of the life cycle still poses a challenge. This paper proposes an
approach to specify InQ requirements for WebApps by reusing and
extending the ISO 25012:2008(E) data quality model. We also
discuss learnability aspect of information quality for the WebApps.
The proposed ISO 25012 based InQ framework is a step towards a
standardized approach to evaluate WebApps InQ.
Abstract: As the performance of the filtering system depends
upon the accuracy of the noise detection scheme, in this paper, we
present a new scheme for impulse noise detection based on two
levels of decision. In this scheme in the first stage we coarsely
identify the corrupted pixels and in the second stage we finally
decide whether the pixel under consideration is really corrupt or not.
The efficacy of the proposed filter has been confirmed by extensive
simulations.
Abstract: One of the common problems encountered in software
engineering is addressing and responding to the changing nature of
requirements. While several approaches have been devised to address
this issue, ranging from instilling resistance to changing requirements
in order to mitigate impact to project schedules, to developing an
agile mindset towards requirements, the approach discussed in this
paper is one of conceptualizing the delta in requirement and
modeling it, in order to plan a response to it. To provide some
context here, change is first formally identified and categorized as
either formal change or informal change. While agile methodology
facilitates informal change, the approach discussed in this paper
seeks to develop the idea of facilitating formal change. To collect,
document meta-requirements that represent the phenomena of change
would be a pro-active measure towards building a realistic cognition
of the requirements entity that can further be harnessed in the
software engineering process.
Abstract: The aim of this study was to develop a storm water quality improvement strategy plan (WQISP) which assists managers and decision makers of local city councils in enhancing their activities to improve regional water quality. City of Gosnells in Western Australia has been considered as a case study. The procedure on developing the WQISP consists of reviewing existing water quality data, identifying water quality issues in the study areas and developing a decision making tool for the officers, managers and decision makers. It was found that land use type is the main factor affecting the water quality. Therefore, activities, sources and pollutants related to different land use types including residential, industrial, agricultural and commercial are given high importance during the study. Semi-structured interviews were carried out with coordinators of different management sections of the regional councils in order to understand the associated management framework and issues. The issues identified from these interviews were used in preparing the decision making tool. Variables associated with the defined “value versus threat" decision making tool are obtained from the intensive literature review. The main recommendations provided for improvement of water quality in local city councils, include non-structural, structural and management controls and potential impacts of climate change.
Abstract: In this paper, Land Marks for Unique Addressing( LMUA) algorithm is develped to generate unique ID for each and every node which leads to the formation of overlapping/Non overlapping clusters based on unique ID. To overcome the draw back of the developed LMUA algorithm, the concept of clustering is introduced. Based on the clustering concept a Land Marks for Unique Addressing and Clustering(LMUAC) Algorithm is developed to construct strictly non-overlapping clusters and classify those nodes in to Cluster Heads, Member Nodes, Gate way nodes and generating the Hierarchical code for the cluster heads to operate in the level one hierarchy for wireless communication switching. The expansion of the existing network can be performed or not without modifying the cost of adding the clusterhead is shown. The developed algorithm shows one way of efficiently constructing the