Abstract: The Build-Then-Sell (BTS) is a novel system
implemented in Malaysia after a number of complaints have been
received from buyers in the preceding Sell-Then-Build (STB) system.
When the government announced the implementation of the BTS in
2007, proponents of BTS have asserted that the new system will
provide houses with low level of defects. Their argument however is
not supported by any empirical data. Hence, this study is conducted
to evaluate the housing defects in BTS houses. Six BTS residential
areas have been surveyed to collect the defects data. Questionnaires
were administered directly to the occupiers in each of the BTS houses
through door-to-door visits. The result has shown that the rate of
defects for the six residential areas is ranged from minor to slight,
which only affect the aesthetic value of the house.
Abstract: In this study, the dispersion of heavy particles line in
an isotropic and incompressible three-dimensional turbulent flow has
been studied using the Kinematic Simulation techniques to find out
the evolution of the line fractal dimension. The fractal dimension of
the line is found in the case of different particle gravity (in practice,
different values of particle drift velocity) in the presence of small
particle inertia with a comparison with that obtained in the diffusion
case of material line at the same Reynolds number. It can be
concluded for the dispersion of heavy particles line in turbulent flow
that the particle gravity affect the fractal dimension of the line for
different particle gravity velocities in the range 0.2 < W < 2. With
the increase of the particle drift velocity, the fractal dimension of the
line decreases which may be explained as the particles pass many
scales in their journey in the direction of the gravity and the particles
trajectories do not affect by these scales at high particle drift
velocities.
Abstract: The paper presents the case study of hazard
identification and sensitivity of potential resource of emergency
water supply as part of the application of methodology classifying
the resources of drinking water for emergency supply of population.
The case study has been carried out on a selected resource of
emergency water supply in one region of the Czech Republic. The
hazard identification and sensitivity of potential resource of
emergency water supply is based on a unique procedure and
developed general registers of selected types of hazards and
sensitivities. The registers have been developed with the help of the
“Fault Tree Analysis” method in combination with the “What if
method”. The identified hazards for the assessed resource include
hailstorms and torrential rains, drought, soil erosion, accidents of
farm machinery, and agricultural production. The developed registers
of hazards and vulnerabilities and a semi-quantitative assessment of
hazards for individual parts of hydrological structure and
technological elements of presented drilled wells are the basis for a
semi-quantitative risk assessment of potential resource of emergency
supply of population and the subsequent classification of such
resource within the system of crisis planning.
Abstract: In this paper, a new dependable algorithm based on an adaptation of the standard variational iteration method (VIM) is used for analyzing the transition from steady convection to chaos for lowto-intermediate Rayleigh numbers convection in porous media. The solution trajectories show the transition from steady convection to chaos that occurs at a slightly subcritical value of Rayleigh number, the critical value being associated with the loss of linear stability of the steady convection solution. The VIM is treated as an algorithm in a sequence of intervals for finding accurate approximate solutions to the considered model and other dynamical systems. We shall call this technique as the piecewise VIM. Numerical comparisons between the piecewise VIM and the classical fourth-order Runge–Kutta (RK4) numerical solutions reveal that the proposed technique is a promising tool for the nonlinear chaotic and nonchaotic systems.
Abstract: From environmental aspect purification of ammonia
containing wastewater is expected. High efficiency ammonia
desorption can be done from the water by air on proper temperature.
After the desorption process, ammonia can be recovered and used in
another technology. The calculation method described below give
some methods to find either the minimum column height or ammonia
rich solution of the effluent.
Abstract: This paper describes the design and development of pico-hydro generation system using consuming water distributed to houses. Water flow in the domestic pipes has kinetic energy that potential to generate electricity for energy storage purposes in addition to the routine activities such as laundry, cook and bathe. The inherent water pressure and flow inside the pipe from utility-s main tank that used for those usual activities is also used to rotate small scale hydro turbine to drive a generator for electrical power generation. Hence, this project is conducted to develop a small scale hydro generation system using consuming water distributed to houses as an alternative electrical energy source for residential use.
Abstract: Clustering algorithms are attractive for the task of class identification in spatial databases. However, the application to large spatial databases rises the following requirements for clustering algorithms: minimal requirements of domain knowledge to determine the input parameters, discovery of clusters with arbitrary shape and good efficiency on large databases. The well-known clustering algorithms offer no solution to the combination of these requirements. In this paper, a density based clustering algorithm (DCBRD) is presented, relying on a knowledge acquired from the data by dividing the data space into overlapped regions. The proposed algorithm discovers arbitrary shaped clusters, requires no input parameters and uses the same definitions of DBSCAN algorithm. We performed an experimental evaluation of the effectiveness and efficiency of it, and compared this results with that of DBSCAN. The results of our experiments demonstrate that the proposed algorithm is significantly efficient in discovering clusters of arbitrary shape and size.
Abstract: Narratives are invaluable assets of human lives. Due to
the distinct features of narratives, they are useful for supporting human
reasoning processes. However, many useful narratives become
residuals in organizations or human minds nowadays. Researchers
have contributed effort to investigate and improve narrative generation
processes. This paper attempts to contemplate essential components in
narratives and explore a computational approach to acquire and extract
knowledge to generate narratives. The methodology and significant
benefit for decision support are presented.
Abstract: This paper presents the utilizing of ferroelectric
material on antenna application. There are two different ferroelectric
had been used on the proposed antennas which include of Barium
Strontium Titanate (BST) and Bismuth Titanate (BiT), suitable for
Access Points operating in the WLAN IEEE 802.11 b/g and WiMAX
IEEE 802.16 within the range of 2.3 GHz to 2.5 GHz application.
BST, which had been tested to own a dielectric constant of εr = 15
while BiT has a dielectric constant that higher than BST which is εr =
21 and both materials are in rectangular shaped. The influence of
various parameters on antenna characteristics were investigated
extensively using commercial electromagnetic simulations software
by Communication Simulation Technology (CST). From theoretical
analysis and simulation results, it was demonstrated that ferroelectric
material used have not only improved the directive emission but also
enhanced the radiation efficiency.
Abstract: The Automatic Speech Recognition (ASR) applied to
Arabic language is a challenging task. This is mainly related to the
language specificities which make the researchers facing multiple
difficulties such as the insufficient linguistic resources and the very
limited number of available transcribed Arabic speech corpora. In
this paper, we are interested in the development of a HMM-based
ASR system for Standard Arabic (SA) language. Our fundamental
research goal is to select the most appropriate acoustic parameters
describing each audio frame, acoustic models and speech recognition
unit. To achieve this purpose, we analyze the effect of varying frame
windowing (size and period), acoustic parameter number resulting
from features extraction methods traditionally used in ASR, speech
recognition unit, Gaussian number per HMM state and number of
embedded re-estimations of the Baum-Welch Algorithm. To evaluate
the proposed ASR system, a multi-speaker SA connected-digits
corpus is collected, transcribed and used throughout all experiments.
A further evaluation is conducted on a speaker-independent continue
SA speech corpus. The phonemes recognition rate is 94.02% which is
relatively high when comparing it with another ASR system
evaluated on the same corpus.
Abstract: Due to their high power-to-weight ratio and low cost,
pneumatic actuators are attractive for robotics and automation
applications; however, achieving fast and accurate control of their
position have been known as a complex control problem. A
methodology for obtaining high position accuracy with a linear
pneumatic actuator is presented. During experimentation with a
number of PID classical control approaches over many operations of
the pneumatic system, the need for frequent manual re-tuning of the
controller could not be eliminated. The reason for this problem is
thermal and energy losses inside the cylinder body due to the
complex friction forces developed by the piston displacements.
Although PD controllers performed very well over short periods, it
was necessary in our research project to introduce some form of
automatic gain-scheduling to achieve good long-term performance.
We chose a fuzzy logic system to do this, which proved to be an
easily designed and robust approach. Since the PD approach showed
very good behaviour in terms of position accuracy and settling time,
it was incorporated into a modified form of the 1st order Tagaki-
Sugeno fuzzy method to build an overall controller. This fuzzy gainscheduler
uses an input variable which automatically changes the PD
gain values of the controller according to the frequency of repeated
system operations. Performance of the new controller was
significantly improved and the need for manual re-tuning was
eliminated without a decrease in performance. The performance of
the controller operating with the above method is going to be tested
through a high-speed web network (GRID) for research purposes.
Abstract: The study of the generated defects on manufactured
parts shows the difficulty to maintain parts in their positions during
the machining process and to estimate them during the pre-process
plan. This work presents a contribution to the development of 3D
models for the optimization of the manufacturing tolerances. An
experimental study allows the measurement of the defects of part
positioning for the determination of ε and the choice of an optimal
setup of the part. An approach of 3D tolerance based on the small
displacements method permits the determination of the
manufacturing errors upstream. A developed tool, allows an
automatic generation of the tolerance intervals along the three axes.
Abstract: Because today-s media centric students have adopted
digital as their native form of communication, teachers are having
increasingly difficult time motivating reluctant readers to read and
write. Our research has shown these text-averse individuals can learn
to understand the importance of reading and writing if the instruction
is based on digital narratives. While these students are naturally
attracted to story, they are better at consuming them than creating
them. Therefore, any intervention that utilizes story as its basis needs
to include instruction on the elements of story making. This paper
presents a series of digitally-based tools to identify potential
weaknesses of visually impaired visual learners and to help motivate
these and other media-centric students to select and complete books
that are assigned to them
Abstract: Gas hydrates form when a number of factors co-exist:
free water, hydrocarbon gas, cold temperatures and high pressures are typical of the near mud-line conditions in a deepwater drilling
operation. Subsequently, when drilling with water based muds, particularly on exploration wells, the risk of hydrate formation
associated with a gas influx is high. The consequences of gas hydrate
formation while drilling are severe, and as such, every effort should be made to ensure the risk of hydrate formation is either eliminated
or significantly reduced. Thermodynamic inhibitors are used to reduce the free water content of a drilling mud, and thus suppress the
hydrate formation temperature. Very little experimental work has
been performed by oil and gas research companies on the evaluation
of gas hydrate formation in a water-based drilling mud. The main
objective of this paper is to investigate the experimental gas hydrate
formation for a mixture of methane, carbon dioxide & nitrogen in a
water-based drilling mud with or without presence of different
concentrations of thermodynamic inhibitors including pure salt and a
combination of salt with methanol or ethylene glycol at different
concentrations in a static loop apparatus. The experiments were
performed using a static loop apparatus consisting of a 2.4307 cm
inside diameter and 800 cm long pipe. All experiments were conducted at 2200 psia. The temperature in the loop was decreased at
a rate of 3.33 °F/h from initial temperature of 80 °F.
Abstract: Most of the nonlinear equation solvers do not converge always or they use the derivatives of the function to approximate the
root of such equations. Here, we give a derivative-free algorithm that guarantees the convergence. The proposed two-step method, which
is to some extent like the secant method, is accompanied with some
numerical examples. The illustrative instances manifest that the rate of convergence in proposed algorithm is more than the quadratically
iterative schemes.
Abstract: This article is dedicated to the question of regionalism
and regionalization in contemporary international relations, with a
specific focus on Central Asia. The article addresses the question of
whether or not Central Asia can be referred to as a true geopolitical
region. In addressing this question, the authors examine particular
factors that are essential for the formation of a region, including those
tied to the economy, energy, culture, and labor migration.
Abstract: A two-dimensional moving mesh algorithm is developed to simulate the general motion of two rotating bodies with relative translational motion. The grid includes a background grid and two sets of grids around the moving bodies. With this grid arrangement rotational and translational motions of two bodies are handled separately, with no complications. Inter-grid boundaries are determined based on their distances from two bodies. In this method, the overset concept is applied to hybrid grid, and flow variables are interpolated using a simple stencil. To evaluate this moving mesh algorithm unsteady Euler flow is solved for different cases using dual-time method of Jameson. Numerical results show excellent agreement with experimental data and other numerical results. To demonstrate the capability of present algorithm for accurate solution of flow fields around moving bodies, some benchmark problems have been defined in this paper.
Abstract: This study was conducted to evaluate the antifungal
activities of Cinnamomum zeylanicum and Origanum vulgare L.
essential oil against Aspergillus flavus in culture media and tomato
paste. 200 ppm of cinnamon and 500 ppm of oregano completely
inhibited A. flavus growth in culture media, while in tomato paste 300
ppm of cinnamon and 200 ppm of oregano had the same effect. Test
panel evaluations revealed that samples with 100 and 200 ppm
cinnamon were acceptable. The results may suggest the potential use
of Cinnamomum zeylanicum essential oil as natural preservative in
tomato paste.
Abstract: In this paper the direct kinematic model of a multiple
applications three degrees of freedom industrial manipulator, was
developed using the homogeneous transformation matrices and the
Denavit - Hartenberg parameters, likewise the inverse kinematic
model was developed using the same method, verifying that in the
workload border the inverse kinematic presents considerable errors,
therefore a genetic algorithm was implemented to optimize the model
improving greatly the efficiency of the model.
Abstract: Support vector machines (SVMs) are considered to be
the best machine learning algorithms for minimizing the predictive
probability of misclassification. However, their drawback is that for
large data sets the computation of the optimal decision boundary is a
time consuming function of the size of the training set. Hence several
methods have been proposed to speed up the SVM algorithm. Here
three methods used to speed up the computation of the SVM
classifiers are compared experimentally using a musical genre
classification problem. The simplest method pre-selects a random
sample of the data before the application of the SVM algorithm. Two
additional methods use proximity graphs to pre-select data that are
near the decision boundary. One uses k-Nearest Neighbor graphs and
the other Relative Neighborhood Graphs to accomplish the task.