Abstract: In this paper, we present a technical and an economic
assessment of several sources of renewable energy in Saudi Arabia;
mainly solar, wind, hydro and biomass. We analyze the
environmental and climatic conditions in relation to these sources
and give an overview of some of the existing clean energy
technologies. Using standardized cost and efficiency data, we carry
out a cost benefit analysis to understand the economic factors
influencing the sustainability of energy production from renewable
sources in light of the energy cost and demand in the Saudi market.
Finally, we take a look at the Saudi petroleum industry and the
existing sources of conventional energy and assess the potential of
building a successful market for renewable energy under the
constraints imposed by the flow of subsidized cheap oil. We show
that while some renewable energy resources are well suited for
distributed or grid connected generation in the kingdom, their
viability is greatly undercut by the well developed and well
capitalized oil industry.
Abstract: A novel sponge submerged membrane bioreactor
(SSMBR) was developed to effectively remove organics and
nutrients from wastewater. Sponge is introduced within the SSMBR
as a medium for the attached growth of biomass. This paper evaluates
the effects of new and acclimatized sponges for dissolved organic
carbon (DOC) removal from wastewater at different mixed liquor
suspended solids- (MLSS) concentration of the sludge. It was
observed in a series of experimental studies that the acclimatized
sponge performed better than the new sponge whilst the optimum
DOC removal could be achieved at 10g/L of MLSS with the
acclimatized sponge. Moreover, the paper analyses the relationships
between the MLSSsponge/MLSSsludge and the DOC removal efficiency
of SSMBR. The results showed a non-linear relationship between the
biomass parameters of the sponge and the sludge, and the DOC
removal efficiency of SSMBR. A second-order polynomial function
could reasonably represent these relationships.
Abstract: During the past decade, pond aeration systems have
been developed which will sustain large quantities of fish and
invertebrate biomass. Dissolved Oxygen (DO) is considered to be
among the most important water quality parameters in fish culture.
Fishponds in aquaculture farms are usually located in remote areas
where grid lines are at far distance. Aeration of ponds is required to
prevent mortality and to intensify production, especially when
feeding is practical, and in warm regions. To increase pond
production it is necessary to control dissolved oxygen. Artificial
intelligence (AI) techniques are becoming useful as alternate
approaches to conventional techniques or as components of
integrated systems. They have been used to solve complicated
practical problems in various areas and are becoming more and more
popular nowadays. This paper presents a new design of diffused
aeration system using fuel cell as a power source. Also fuzzy logic
control Technique (FLC) is used for controlling the speed of air flow
rate from the blower to air piping connected to the pond by adjusting
blower speed. MATLAB SIMULINK results show high performance
of fuzzy logic control (FLC).
Abstract: The pyrolysis characteristics and kinetics of seven marine biomass, which are fixed Enteromorpha clathrata, floating Enteromorpha clathrata, Ulva lactuca L., Zosterae Marinae L., Thallus Laminariae, Asparagus schoberioides kunth and Undaria pinnatifida (Harv.), were studied with thermogravimetric analysis method. Simultaneously, cornstalk, which is a grass biomass, and sawdust, which is a lignocellulosic biomass, were references. The basic pyrolysis characteristics were studied by using TG- DTG-DTA curves. The results showed that there were three stages (dehydration, dramatic weight loss and slow weight loss) during the whole pyrolysis process of samples. The Tmax of marine biomass was significantly lower than two kinds of terrestrial biomass. Zosterae Marinae L. had a relatively high stability of pyrolysis, but floating Enteromorpha clathrata had lowest stability of pyrolysis and a good combustion characteristics. The corresponding activation energy E and frequency factor A were obtained by Coats-Redfern method. It was found that the pyrolysis reaction mechanism functions of three kinds of biomass are different.
Abstract: Fixed-bed slow pyrolysis experiments of rice husk
have been conducted to determine the effect of pyrolysis
temperature, heating rate, particle size and reactor length on the
pyrolysis product yields. Pyrolysis experiments were performed at
pyrolysis temperature between 400 and 600°C with a constant
heating rate of 60°C/min and particle sizes of 0.60-1.18 mm. The
optimum process conditions for maximum liquid yield from the rice
husk pyrolysis in a fixed bed reactor were also identified. The highest
liquid yield was obtained at a pyrolysis temperature of 500°C,
particle size of
1.18-1.80 mm, with a heating rate of 60°C/min in a 300 mm length
reactor. The obtained yield of, liquid, gas and solid were found be in
the range of 22.57-31.78 %, 27.75-42.26 % and 34.17-42.52 % (all
weight basics) respectively at different pyrolysis conditions. The
results indicate that the effects of pyrolysis temperature and particle
size on the pyrolysis yield are more significant than that of heating
rate and reactor length. The functional groups and chemical
compositions present in the liquid obtained at optimum conditions
were identified by Fourier Transform-Infrared (FT-IR) spectroscopy
and Gas Chromatography/ Mass Spectroscopy (GC/MS) analysis
respectively.
Abstract: The equilibrium, thermodynamics and kinetics of the
biosorption of Cd (II) and Pb(II) by a Spore Forming Bacillus (MGL
75) were investigated at different experimental conditions. The
Langmuir and Freundlich, and Dubinin-Radushkevich (D-R)
equilibrium adsorption models were applied to describe the
biosorption of the metal ions by MGL 75 biomass. The Langmuir
model fitted the equilibrium data better than the other models.
Maximum adsorption capacities q max for lead (II) and cadmium (II)
were found equal to 158.73mg/g and 91.74 mg/g by Langmuir model.
The values of the mean free energy determined with the D-R equation
showed that adsorption process is a physiosorption process. The
thermodynamic parameters Gibbs free energy (ΔG°), enthalpy (ΔH°),
and entropy (ΔS°) changes were also calculated, and the values
indicated that the biosorption process was exothermic and
spontaneous. Experiment data were also used to study biosorption
kinetics using pseudo-first-order and pseudo-second-order kinetic
models. Kinetic parameters, rate constants, equilibrium sorption
capacities and related correlation coefficients were calculated and
discussed. The results showed that the biosorption processes of both
metal ions followed well pseudo-second-order kinetics.