Abstract: The conventional GA combined with a local search
algorithm, such as the 2-OPT, forms a hybrid genetic algorithm(HGA)
for the traveling salesman problem (TSP). However, the geometric
properties which are problem specific knowledge can be used to
improve the search process of the HGA. Some tour segments (edges)
of TSPs are fine while some maybe too long to appear in a short tour.
This knowledge could constrain GAs to work out with fine tour
segments without considering long tour segments as often.
Consequently, a new algorithm is proposed, called intelligent-OPT
hybrid genetic algorithm (IOHGA), to improve the GA and the 2-OPT
algorithm in order to reduce the search time for the optimal solution.
Based on the geometric properties, all the tour segments are assigned
2-level priorities to distinguish between good and bad genes. A
simulation study was conducted to evaluate the performance of the
IOHGA. The experimental results indicate that in general the IOHGA
could obtain near-optimal solutions with less time and better accuracy
than the hybrid genetic algorithm with simulated annealing algorithm
(HGA(SA)).
Abstract: Recently, genetic algorithms (GA) and particle swarm optimization (PSO) technique have attracted considerable attention among various modern heuristic optimization techniques. Since the two approaches are supposed to find a solution to a given objective function but employ different strategies and computational effort, it is appropriate to compare their performance. This paper presents the application and performance comparison of PSO and GA optimization techniques, for Thyristor Controlled Series Compensator (TCSC)-based controller design. The design objective is to enhance the power system stability. The design problem of the FACTS-based controller is formulated as an optimization problem and both the PSO and GA optimization techniques are employed to search for optimal controller parameters. The performance of both optimization techniques in terms of computational time and convergence rate is compared. Further, the optimized controllers are tested on a weakly connected power system subjected to different disturbances, and their performance is compared with the conventional power system stabilizer (CPSS). The eigenvalue analysis and non-linear simulation results are presented and compared to show the effectiveness of both the techniques in designing a TCSC-based controller, to enhance power system stability.
Abstract: Nowadays, driving support systems, such as car
navigation systems, are getting common, and they support drivers in
several aspects. It is important for driving support systems to detect
status of driver's consciousness. Particularly, detecting driver's
drowsiness could prevent drivers from collisions caused by drowsy
driving. In this paper, we discuss the various artificial detection
methods for detecting driver's drowsiness processing technique. This
system is based on facial images analysis for warning the driver of
drowsiness or in attention to prevent traffic accidents.
Abstract: This paper presents an overview of the multiobjective shortest path problem (MSPP) and a review of essential and recent issues regarding the methods to its solution. The paper further explores a multiobjective evolutionary algorithm as applied to the MSPP and describes its behavior in terms of diversity of solutions, computational complexity, and optimality of solutions. Results show that the evolutionary algorithm can find diverse solutions to the MSPP in polynomial time (based on several network instances) and can be an alternative when other methods are trapped by the tractability problem.
Abstract: Asynchronous Transfer Mode (ATM) is widely used
in telecommunications systems to send data, video and voice at a
very high speed. In ATM network optimizing the bandwidth through
dynamic routing is an important consideration. Previous research
work shows that traditional optimization heuristics result in suboptimal
solution. In this paper we have explored non-traditional
optimization technique. We propose comparison of two such
algorithms - Genetic Algorithm (GA) and Tabu search (TS), based on
non-traditional Optimization approach, for solving the dynamic
routing problem in ATM networks which in return will optimize the
bandwidth. The optimized bandwidth could mean that some
attractive business applications would become feasible such as high
speed LAN interconnection, teleconferencing etc. We have also
performed a comparative study of the selection mechanisms in GA
and listed the best selection mechanism and a new initialization
technique which improves the efficiency of the GA.
Abstract: Wireless Sensor Networks consist of small battery
powered devices with limited energy resources. once deployed, the
small sensor nodes are usually inaccessible to the user, and thus
replacement of the energy source is not feasible. Hence, One of the
most important issues that needs to be enhanced in order to improve
the life span of the network is energy efficiency. to overcome this
demerit many research have been done. The clustering is the one of
the representative approaches. in the clustering, the cluster heads
gather data from nodes and sending them to the base station. In this
paper, we introduce a dynamic clustering algorithm using genetic
algorithm. This algorithm takes different parameters into
consideration to increase the network lifetime. To prove efficiency of
proposed algorithm, we simulated the proposed algorithm compared
with LEACH algorithm using the matlab
Abstract: Information hiding for authenticating and verifying the content integrity of the multimedia has been exploited extensively in the last decade. We propose the idea of using genetic algorithm and non-deterministic dependence by involving the un-watermarkable coefficients for digital image authentication. Genetic algorithm is used to intelligently select coefficients for watermarking in a DCT based image authentication scheme, which implicitly watermark all the un-watermarkable coefficients also, in order to thwart different attacks. Experimental results show that such intelligent selection results in improvement of imperceptibility of the watermarked image, and implicit watermarking of all the coefficients improves security against attacks such as cover-up, vector quantization and transplantation.
Abstract: In this paper, an innovative watermarking scheme for audio signal based on genetic algorithms (GA) in the discrete wavelet transforms is proposed. It is robust against watermarking attacks, which are commonly employed in literature. In addition, the watermarked image quality is also considered. We employ GA for the optimal localization and intensity of watermark. The watermark detection process can be performed without using the original audio signal. The experimental results demonstrate that watermark is inaudible and robust to many digital signal processing, such as cropping, low pass filter, additive noise.
Abstract: This study has investigated a vehicle Lumped
Parameter Model (LPM) in frontal crash. There are several ways for
determining spring and damper characteristics and type of problem
shall be considered as system identification. This study use Genetic
Algorithm (GA) procedure, being an effective procedure in case of
optimization issues, for optimizing errors, between target data
(experimental data) and calculated results (being obtained by
analytical solving). In this study analyzed model in 5-DOF then
compared our results with 5-DOF serial model. Finally, the response
of model due to external excitement is investigated.
Abstract: This paper addresses modeling and optimization of process parameters in powder mixed electrical discharge machining (PMEDM). The process output characteristics include metal removal rate (MRR) and electrode wear rate (EWR). Grain size of Aluminum powder (S), concentration of the powder (C), discharge current (I) pulse on time (T) are chosen as control variables to study the process performance. The experimental results are used to develop the regression models based on second order polynomial equations for the different process characteristics. Then, a genetic algorithm (GA) has been employed to determine optimal process parameters for any desired output values of machining characteristics.
Abstract: Sharing the manufacturing facility through remote
operation and monitoring of a machining process is challenge for
effective use the production facility. Several automation tools in term
of hardware and software are necessary for successfully remote
operation of a machine. This paper presents a prototype of workpiece
holding attachment for remote operation of milling process by self
configuration the workpiece setup. The prototype is designed with
mechanism to reorient the work surface into machining spindle
direction with high positioning accuracy. Variety of parts geometry
is hold by attachment to perform single setup machining. Pin type
with array pattern additionally clamps the workpiece surface from
two opposite directions for increasing the machining rigidity.
Optimum pins configuration for conforming the workpiece geometry
with minimum deformation is determined through hybrid algorithms,
Genetic Algorithms (GA) and Particle Swarm Optimization (PSO).
Prototype with intelligent optimization technique enables to hold
several variety of workpiece geometry which is suitable for
machining low of repetitive production in remote operation.
Abstract: In this paper, a new hybrid of genetic algorithm (GA)
and simulated annealing (SA), referred to as GSA, is presented. In
this algorithm, SA is incorporated into GA to escape from local
optima. The concept of hierarchical parallel GA is employed to
parallelize GSA for the optimization of multimodal functions. In
addition, multi-niche crowding is used to maintain the diversity in
the population of the parallel GSA (PGSA). The performance of the
proposed algorithms is evaluated against a standard set of multimodal
benchmark functions. The multi-niche crowding PGSA and normal
PGSA show some remarkable improvement in comparison with the
conventional parallel genetic algorithm and the breeder genetic
algorithm (BGA).
Abstract: The multiple traveling salesman problem (mTSP) can be used to model many practical problems. The mTSP is more complicated than the traveling salesman problem (TSP) because it requires determining which cities to assign to each salesman, as well as the optimal ordering of the cities within each salesman's tour. Previous studies proposed that Genetic Algorithm (GA), Integer Programming (IP) and several neural network (NN) approaches could be used to solve mTSP. This paper compared the results for mTSP, solved with Genetic Algorithm (GA) and Nearest Neighbor Algorithm (NNA). The number of cities is clustered into a few groups using k-means clustering technique. The number of groups depends on the number of salesman. Then, each group is solved with NNA and GA as an independent TSP. It is found that k-means clustering and NNA are superior to GA in terms of performance (evaluated by fitness function) and computing time.
Abstract: In this paper, real-coded genetic algorithm (RCGA) optimization technique has been applied for large-scale linear dynamic multi-input-multi-output (MIMO) system. The method is based on error minimization technique where the integral square error between the transient responses of original and reduced order models has been minimized by RCGA. The reduction procedure is simple computer oriented and the approach is comparable in quality with the other well-known reduction techniques. Also, the proposed method guarantees stability of the reduced model if the original high-order MIMO system is stable. The proposed approach of MIMO system order reduction is illustrated with the help of an example and the results are compared with the recently published other well-known reduction techniques to show its superiority.
Abstract: Since the actuator capacity is limited, in the real
application of active control systems under sever earthquakes it is
conceivable that the actuators saturate, hence the actuator saturation
should be considered as a constraint in design of optimal controllers.
In this paper optimal design of active controllers for nonlinear
structures by considering actuator saturation, has been studied. The
proposed method for designing optimal controllers is based on
defining an optimization problem which the objective has been to
minimize the maximum displacement of structure when a limited
capacity for actuator has been used. To this end a single degree of
freedom (SDF) structure with a bilinear hysteretic behavior has been
simulated under a white noise ground acceleration of different
amplitudes. Active tendon control mechanism, comprised of prestressed
tendons and an actuator, and extended nonlinear Newmark
method based instantaneous optimal control algorithm have been
used. To achieve the best results, the weights corresponding to
displacement, velocity, acceleration and control force in the
performance index have been optimized by the Distributed Genetic
Algorithm (DGA). Results show the effectiveness of the proposed
method in considering actuator saturation. Also based on the
numerical simulations it can be concluded that the actuator capacity
and the average value of required control force are two important
factors in designing nonlinear controllers which consider the actuator
saturation.
Abstract: In the recent past Learning Classifier Systems have
been successfully used for data mining. Learning Classifier System
(LCS) is basically a machine learning technique which combines
evolutionary computing, reinforcement learning, supervised or
unsupervised learning and heuristics to produce adaptive systems. A
LCS learns by interacting with an environment from which it
receives feedback in the form of numerical reward. Learning is
achieved by trying to maximize the amount of reward received. All
LCSs models more or less, comprise four main components; a finite
population of condition–action rules, called classifiers; the
performance component, which governs the interaction with the
environment; the credit assignment component, which distributes the
reward received from the environment to the classifiers accountable
for the rewards obtained; the discovery component, which is
responsible for discovering better rules and improving existing ones
through a genetic algorithm. The concatenate of the production rules
in the LCS form the genotype, and therefore the GA should operate
on a population of classifier systems. This approach is known as the
'Pittsburgh' Classifier Systems. Other LCS that perform their GA at
the rule level within a population are known as 'Mitchigan' Classifier
Systems. The most predominant representation of the discovered
knowledge is the standard production rules (PRs) in the form of IF P
THEN D. The PRs, however, are unable to handle exceptions and do
not exhibit variable precision. The Censored Production Rules
(CPRs), an extension of PRs, were proposed by Michalski and
Winston that exhibit variable precision and supports an efficient
mechanism for handling exceptions. A CPR is an augmented
production rule of the form: IF P THEN D UNLESS C, where
Censor C is an exception to the rule. Such rules are employed in
situations, in which conditional statement IF P THEN D holds
frequently and the assertion C holds rarely. By using a rule of this
type we are free to ignore the exception conditions, when the
resources needed to establish its presence are tight or there is simply
no information available as to whether it holds or not. Thus, the IF P
THEN D part of CPR expresses important information, while the
UNLESS C part acts only as a switch and changes the polarity of D
to ~D. In this paper Pittsburgh style LCSs approach is used for
automated discovery of CPRs. An appropriate encoding scheme is
suggested to represent a chromosome consisting of fixed size set of
CPRs. Suitable genetic operators are designed for the set of CPRs
and individual CPRs and also appropriate fitness function is proposed
that incorporates basic constraints on CPR. Experimental results are
presented to demonstrate the performance of the proposed learning
classifier system.