Abstract: The three phase system drives produce the problem of more torque pulsations and harmonics. This issue prevents the smooth operation of the drives and it also induces the amount of heat generated thus resulting in an increase in power loss. Higher phase system offers smooth operation of the machines with greater power capacity. Five phase variable-speed induction motor drives are commonly used in various industrial and commercial applications like tractions, electrical vehicles, ship propulsions and conveyor belt drive system. In this work, a comparative analysis of the different modulation schemes applied on the five-level five-phase Packed U Cell (PUC) inverter fed induction motor drives is presented. The performance of the inverter is greatly affected with the modulation schemes applied. The system is modeled, designed, and implemented in MATLAB®/Simulink environment. Experimental validation is done for the prototype of single phase, whereas five phase experimental validation is proposed in the future works.
Abstract: Apple bruise damage from harvesting, handling, transporting and sorting is considered to be the major source of reduced fruit quality, resulting in loss of profits for the entire fruit industry. The three factors which can physically cause fruit bruising are vibration, compression load and impact, the latter being the most common source of bruise damage. Therefore, prediction of the level of damage, stress distribution and deformation of the fruits under external force has become a very important challenge. In this study, experimental and numerical methods were used to better understand the impact caused when an apple is dropped from different heights onto a plastic surface and a conveyor belt. Results showed that the extent of fruit damage is significantly higher for plastic surface, being dependent on the height. In order to support the development of a biomimetic electronic device for the determination of fruit damage, the mechanical properties of the apple fruit were determined using mechanical tests. Preliminary results showed different values for the Young’s modulus according to the zone of the apple tested. Along with the mechanical characterization of the apple fruit, the development of the first two prototypes is discussed and the integration of the results obtained to construct the final element model of the apple is presented. This work will help to reduce significantly the bruise damage of fruits or vegetables during the entire processing which will allow the introduction of exportation destines and consequently an increase in the economic profits in this sector.
Abstract: The “conveyor belt" as a product represents a
complex high performance component with a wide range of different
applications. Further development of these highly complex
components demands an integration of new technologies and new
enhanced materials. In this context nanostructured fillers appear to
have a more promising effect on the performance of the conveyor
belt composite than conventional micro-scaled fillers.
Within the project “DotTrans" nanostructured fillers, for example
silicon dioxide, are used to optimize performance parameters of
conveyor belt systems. The objective of the project includes
operating parameters like energy consumption or friction
characteristics as well as adaptive parameters like cut or wear
resistance.
Abstract: This paper presents a solution for a robotic
manipulation problem. We formulate the problem as combining
target identification, tracking and interception. The task in our
solution is sensing a target on a conveyor belt and then intercepting
robot-s end-effector at a convenient rendezvous point. We used
an object recognition method which identifies the target and finds
its position from visualized scene picture, then the robot system
generates a solution for rendezvous problem using the target-s initial
position and belt velocity . The interception of the target and the
end-effector is executed at a convenient rendezvous point along the
target-s calculated trajectory. Experimental results are obtained using
a real platform with an industrial robot and a vision system over it.
Abstract: In this paper, a solution is presented for a robotic
manipulation problem in industrial settings. The problem is sensing
objects on a conveyor belt, identifying the target, planning and
tracking an interception trajectory between end effector and the
target. Such a problem could be formulated as combining object
recognition, tracking and interception. For this purpose, we integrated
a vision system to the manipulation system and employed tracking
algorithms. The control approach is implemented on a real industrial
manipulation setting, which consists of a conveyor belt, objects
moving on it, a robotic manipulator, and a visual sensor above the
conveyor. The trjectory for robotic interception at a rendezvous point
on the conveyor belt is analytically calculated. Test results show that
tracking the raget along this trajectory results in interception and
grabbing of the target object.