Abstract: Extensive rainfall disaggregation approaches have been developed and applied in climate change impact studies such as flood risk assessment and urban storm water management.In this study, five rainfall models that were capable ofdisaggregating daily rainfall data into hourly one were investigated for the rainfall record in theChangi Airport, Singapore. The objectives of this study were (i) to study the temporal characteristics of hourly rainfall in Singapore, and (ii) to evaluate the performance of variousdisaggregation models. The used models included: (i) Rectangular pulse Poisson model (RPPM), (ii) Bartlett-Lewis Rectangular pulse model (BLRPM), (iii) Bartlett-Lewis model with 2 cell types (BL2C), (iv) Bartlett-Lewis Rectangular with cell depth distribution dependent on duration (BLRD), and (v) Neyman-Scott Rectangular pulse model (NSRPM). All of these models werefitted using hourly rainfall data ranging from 1980 to 2005 (which was obtained from Changimeteorological station).The study results indicated that the weight scheme of inversely proportional variance could deliver more accurateoutputs for fitting rainfall patterns in tropical areas, and BLRPM performedrelatively better than other disaggregation models.
Abstract: Active vibration isolation systems are less commonly
used than passive systems due to their associated cost and power
requirements. In principle, semi-active isolation systems can deliver
the versatility, adaptability and higher performance of fully active
systems for a fraction of the power consumption. Various semi-active
control algorithms have been suggested in the past. This paper
studies the 4DOF model of semi-active suspension performance
controlled by on–off and continuous skyhook damping control
strategy. The frequency and transient responses of model are
evaluated in terms of body acceleration, roll angle and tire deflection
and are compared with that of a passive damper. The results show
that the semi-active system controlled by skyhook strategy always
provides better isolation than a conventional passively damped
system except at tire natural frequencies.
Abstract: A synchronous network-on-chip using wormhole packet switching
and supporting guaranteed-completion best-effort with low-priority (LP)
and high-priority (HP) wormhole packet delivery service is presented in
this paper. Both our proposed LP and HP message services deliver a good
quality of service in term of lossless packet completion and in-order message
data delivery. However, the LP message service does not guarantee minimal
completion bound. The HP packets will absolutely use 100% bandwidth of
their reserved links if the HP packets are injected from the source node with
maximum injection. Hence, the service are suitable for small size messages
(less than hundred bytes). Otherwise the other HP and LP messages, which
require also the links, will experience relatively high latency depending on the
size of the HP message. The LP packets are routed using a minimal adaptive
routing, while the HP packets are routed using a non-minimal adaptive routing
algorithm. Therefore, an additional 3-bit field, identifying the packet type,
is introduced in their packet headers to classify and to determine the type
of service committed to the packet. Our NoC prototypes have been also
synthesized using a 180-nm CMOS standard-cell technology to evaluate the
cost of implementing the combination of both services.
Abstract: Retinoic acid is like a steroid hormone that plays a
role in embryo formation, proliferation of spermatogonia cells,
ephitelial cells differentiation and organogenesis. Retinoic acid can
influences seminiferous tubule formation during embryonic testis
development and also play a role in the regulation of ovarian function
and female reproductive tract by suppressing the hormones FSH
receptor expression. The excessive use of retinoic acid caused
abnormalities in the fetus. The result showed that there is the
influence of retinoic acid on the developmet of mice fetal testes, for
examples disruption of the formation of seminiferous tubules and
tubules seemed to be hollow, spermatogonia cells are relatively few
in number and caused Leydig cells count relatively more. While in
the female fetus does not caused the formation of primordial follicles
and disrupted the development of germinal ephitelial cells of fetal
ovaries of female mice (mus musculus) Swiss Webster.
Abstract: In this research, the flow pattern influence on
performance of a micro PEMFC was investigated
experimentally. The investigation focused on the impacts of
bend angels and rib/channel dimensions of serpentine flow
channel pattern on the performance and investigated how they
improve the performance. The fuel cell employed for these
experiments was a micro single PEMFC with a membrane of
1.44 cm2 Nafion NRE-212. The results show that 60° and 120°
bend angles can provide the better performances at 20 and 40
sccm inlet flow rates comparing to that the conventional design.
Additionally, wider channel with narrower rib spacing gives
better performance. These results may be applied to develop
universal heuristics for the design of flow pattern of micro
PEMFC.
Abstract: This work aims to reduce the read power consumption
as well as to enhance the stability of the SRAM cell during the read
operation. A new 10-transisor cell is proposed with a new read
scheme to minimize the power consumption within the memory core.
It has separate read and write ports, thus cell read stability is
significantly improved. A 16Kb SRAM macro operating at 1V
supply voltage is demonstrated in 65 nm CMOS process. Its read
power consumption is reduced to 24% of the conventional design.
The new cell also has lower leakage current due to its special bit-line
pre-charge scheme. As a result, it is suitable for low-power mobile
applications where power supply is restricted by the battery.
Abstract: A novel adaptive fuzzy trajectory tracking algorithm of Stewart platform based motion platform is proposed to compensate path deviation and degradation of controller-s performance due to actuator torque limit. The algorithm can be divided into two parts: the real-time trajectory shaping part and the joint space adaptive fuzzy controller part. For a reference trajectory in task space whenever any of the actuators is saturated, the desired acceleration of the reference trajectory is modified on-line by using dynamic model of motion platform. Meanwhile an additional action with respect to the difference between the nominal and modified trajectories is utilized in the non-saturated region of actuators to reduce the path error. Using modified trajectory as input, the joint space controller incorporates compute torque controller, leg velocity observer and fuzzy disturbance observer with saturation compensation. It can ensure stability and tracking performance of controller in present of external disturbance and position only measurement. Simulation results verify the effectiveness of proposed control scheme.
Abstract: Environmental responsibility includes improvement of environmental performance in order to reduce environmental impact. This paper gives a short review of some important environmental objectives, targets and actions that modern shipping company should follow.
Abstract: Unlike the best effort service provided by the internet
today, next-generation wireless networks will support real-time
applications. This paper proposes an adaptive early packet discard
(AEPD) policy to improve the performance of the real time TCP
traffic over ATM networks and avoid the fragmentation problem.
Three main aspects are incorporated in the proposed policy. First,
providing quality-of-service (QoS) guaranteed for real-time
applications by implementing a priority scheduling. Second,
resolving the partially corrupted packets problem by differentiating
the buffered cells of one packet from another. Third, adapting a
threshold dynamically using Fuzzy logic based on the traffic
behavior to maintain a high throughput under a variety of load
conditions. The simulation is run for two priority classes of the input
traffic: real time and non-real time classes. Simulation results show
that the proposed AEPD policy improves throughput and fairness
over that using static threshold under the same traffic conditions.
Abstract: Agricultural waste is mainly composed of cellulose
and hemicelluloses which can be converted to sugars. The
inexpensive reducing sugar from durian peel was obtained by
hydrolysis with HCl concentration at 0.5-2.0% (v/v). The hydrolysis
range of time was for 15-60 min when the mixture was autoclaved at
121 °C. The result showed that acid hydrolysis efficiency (AHE)
highest to 80.99% at condition is 2.0%concentration for 15 min.
Reducing sugar highest to 56.07 g/litre at condition is 2.0%
concentration for 45min. Total sugar highest to 59.83 g/litre at
condition is 2.0%concentration for 45min, which was not significant
(p < 0.05) with condition 2.0% concentration for 30 min and 1.5 %
concentration for 45 and 60 min. The increase in concentration
increased AHE, reducing sugar and total sugar. The hydrolysis time
had no effect on AHE, reducing sugar and total sugar. The maximum
reducing sugars of each concentration were at hydrolysis time 45
min .The hydrolysated were analysis by HPLC, the results revealed
that the principle of sugar were glucose, fructose and xylose.
Abstract: In this paper, we propose a side-peak cancellation
scheme for code acquisition of composite binary offset carrier
(CBOC) signals. We first model the family of CBOC signals in a
generic form, and then, propose a side-peak cancellation scheme
by combining correlation functions between the divided sub-carrier
and received signals. From numerical results, it is shown that the
proposed scheme removes the side-peak completely, and moreover,
the resulting correlation function demonstrates the better power ratio
performance than the CBOC autocorrelation.
Abstract: The spreading characteristics of acoustically excited
swirling double-concentric jets were studied experimentally. The
central jet was acoustically excited at low and high pulsation
intensities. A smoke wire flow visualization and a hot-wire
anemometer velocity measurement results show that excitation forces
a vortex ring to roll-up from the edge of the central tube during each
excitation period. At low pulsation intensities, the vortex ring evolves
downstream, and eventually breaks up into turbulent eddies. At high
pulsation intensities, the primary vortex ring evolves and a series of
trailing vortex rings form during the same period of excitation. The
trailing vortex rings accelerate while evolving downstream and
overtake the primary vortex ring within the same cycle. In the
process, the primary vortex ring becomes unstable and breaks up
early. The effect of the fast traveling trailing vortex rings combined
with the swirl motion of the annular flow improve jet spreading
compared with the naturally evolving jets.
Abstract: We have applied new accelerated algorithm for linear
discriminate analysis (LDA) in face recognition with support vector
machine. The new algorithm has the advantage of optimal selection
of the step size. The gradient descent method and new algorithm has
been implemented in software and evaluated on the Yale face
database B. The eigenfaces of these approaches have been used to
training a KNN. Recognition rate with new algorithm is compared
with gradient.
Abstract: The knee bracing steel frame (KBF) is a new kind of energy dissipating frame, which combines excellent ductility and lateral stiffness. In this framing system, a special form of diagonal brace connected to a knee element instead of beam-column joint, is investigated. Recently, a similar system was proposed and named as chevron knee bracing system (CKB) which in comparison with the former system has a better energy absorption characteristic and at the same time retains the elastic nature of the structures. Knee bracing can provide a stiffer bracing system but reduces the ductility of the steel frame. Chevron knee bracing can be employed to provide the desired ductility level for a design. In this article, relation between seismic performance and structural parameters of the two above mentioned systems are investigated and compared. Frames with similar dimensions but various heights in both systems are designed according to Iranian code of practice for seismic resistant design of building, and then based on a non-linear push over static analysis; the seismic parameters such as behavior factor and performance levels are compared.
Abstract: Cellular automata have been used for design of cryptosystems. Recently some secret sharing schemes based on linear memory cellular automata have been introduced which are used for both text and image. In this paper, we illustrate that these secret sharing schemes are vulnerable to dishonest participants- collusion. We propose a cheating model for the secret sharing schemes based on linear memory cellular automata. For this purpose we present a novel uniform model for representation of all secret sharing schemes based on cellular automata. Participants can cheat by means of sending bogus shares or bogus transition rules. Cheaters can cooperate to corrupt a shared secret and compute a cheating value added to it. Honest participants are not aware of cheating and suppose the incorrect secret as the valid one. We prove that cheaters can recover valid secret by removing the cheating value form the corrupted secret. We provide methods of calculating the cheating value.
Abstract: The principal purpose of this article is to present a new method based on Adaptive Neural Network Fuzzy Inference System (ANFIS) to generate additional artificial earthquake accelerograms from presented data, which are compatible with specified response spectra. The proposed method uses the learning abilities of ANFIS to develop the knowledge of the inverse mapping from response spectrum to earthquake records. In addition, wavelet packet transform is used to decompose specified earthquake records and then ANFISs are trained to relate the response spectrum of records to their wavelet packet coefficients. Finally, an interpretive example is presented which uses an ensemble of recorded accelerograms to demonstrate the effectiveness of the proposed method.
Abstract: With the exponentially increasing demand for
wireless communications the capacity of current cellular systems will
soon become incapable of handling the growing traffic. Since radio
frequencies are diminishing natural resources, there seems to be a
fundamental barrier to further capacity increase. The solution can be
found in smart antenna systems.
Smart or adaptive antenna arrays consist of an array of antenna
elements with signal processing capability, that optimize the
radiation and reception of a desired signal, dynamically. Smart
antennas can place nulls in the direction of interferers via adaptive
updating of weights linked to each antenna element. They thus cancel
out most of the co-channel interference resulting in better quality of
reception and lower dropped calls. Smart antennas can also track the
user within a cell via direction of arrival algorithms. This implies that
they are more advantageous than other antenna systems. This paper
focuses on few issues about the smart antennas in mobile radio
networks.
Abstract: Because of architectural condition and structure application, sometimes mass source and stiffness source are not coincidence, and the structure is irregular. The structure is also might be asymmetric as an asymmetric bracing in plan which leads to unbalance distribution of stiffness or because of unbalance distribution of the mass. Both condition lead to eccentricity and torsion in the structure. The deficiency of ordinary code to evaluate the performance of steel structures against earthquake has been caused designing based on performance level or capacity spectrum be used. By using the mentioned methods it is possible to design a structure that its behavior against different earthquakes be predictive. In this article 5- story buildings with different percentage of asymmetric which is because of stiffness changes and kind of bracing (x and chevron bracing) have been designed. The static and dynamic nonlinear analysis under three acceleration recording has been done. Finally performance level of the structure has been evaluated.
Abstract: The main objective of the present paper is to derive an easy numerical technique for the analysis of the free vibration through the stepped regions of plates. Based on the utilities of the step by step integration initial values IV and Finite differences FD methods, the present improved Initial Value Finite Differences (IVFD) technique is achieved. The first initial conditions are formulated in convenient forms for the step by step integrations while the upper and lower edge conditions are expressed in finite difference modes. Also compatibility conditions are created due to the sudden variation of plate thickness. The present method (IVFD) is applied to solve the fourth order partial differential equation of motion for stepped plate across two different panels under the sudden step compatibility in addition to different types of end conditions. The obtained results are examined and the validity of the present method is proved showing excellent efficiency and rapid convergence.