Abstract: Developments in communication technologies
especially in wireless have enabled the progress of low-cost and lowpower
wireless sensor networks (WSNs). The features of such WSN
are holding minimal energy, weak computational capabilities,
wireless communication and an open-medium nature where sensors
are deployed. WSN is underpinned by application driven such as
military applications, the health sector, etc. Due to the intrinsic nature
of the network and application scenario, WSNs are vulnerable to
many attacks externally and internally. In this paper we have focused
on the types of internal attacks of WSNs based on OSI model and
discussed some security requirements, characterizers and challenges
of WSNs, by which to contribute to the WSN-s security research.
Abstract: This paper explores transformation of higher
education system in Kazakhstan since 1991. The research unravels
successful experience in the field and challenges. It covers issues of institutional change, faculty, research, university, funding, standards
and leadership. The paper offers recommendations in improving state of art in higher educational institutions of Kazakhstan based on
international approaches and local realities.
Abstract: This paper describes the pipeline architecture of
high-speed modified Booth multipliers. The proposed multiplier
circuits are based on the modified Booth algorithm and the pipeline
technique which are the most widely used to accelerate the
multiplication speed. In order to implement the optimally pipelined
multipliers, many kinds of experiments have been conducted. The
speed of the multipliers is greatly improved by properly deciding the
number of pipeline stages and the positions for the pipeline registers to
be inserted. We described the proposed modified Booth multiplier
circuits in Verilog HDL and synthesized the gate-level circuits using
0.13um standard cell library. The resultant multiplier circuits show
better performance than others. Since the proposed multipliers operate
at GHz ranges, they can be used in the systems requiring very high
performance.
Abstract: This paper presents the results of corrosion fatigue
crack growth behaviour of a Ni-Cr-Mn steel commonly used in
marine applications. The effect of mechanical variables such as
frequency and load ratio on fatigue crack growth rate at various
stages has been studied using compact tension (C(T)) specimens
along the rolling direction of steel plate under 3.5% saturated NaCl
aqueous environment. The significance of crack closure on corrosion
fatigue, and the validity of Elber-s empirical linear crack closure
model with the ASTM compliance offset method have been
examined.
Fatigue crack growth rate is higher and threshold stress intensities
are lower in aqueous environment compared to the lab air conditions.
It is also observed that the crack growth rate increases at lower
frequencies. The higher stress ratio promotes the crack growth. The
effect of oxidization and corrosion pit formation is very less as the
stress ratio is increased. It is observed that as stress ratios are
increased, the Elber-s crack closure model agrees well with the crack
closure estimated by the ASTM compliance offset method for tests
conducted at 5Hz frequency compared to tests conducted at 1Hz in
corrosive environment.
Abstract: In this paper, the sum of squares in linear regression is
reduced to sum of squares in semi-parametric regression. We
indicated that different sums of squares in the linear regression are
similar to various deviance statements in semi-parametric regression.
In addition to, coefficient of the determination derived in linear
regression model is easily generalized to coefficient of the
determination of the semi-parametric regression model. Then, it is
made an application in order to support the theory of the linear
regression and semi-parametric regression. In this way, study is
supported with a simulated data example.
Abstract: Laboratory experiments have been performed to investigate photocatalytic detoxification by using TiO2 photocatalyst for treating dairy effluent. Various operational parameters such as catalyst concentration, initial concentration, angle of tilt of solar flat plate reactor and flow rate were investigated. Results indicated that the photocatalytic detoxification process can efficiently treat dairy effluent. Experimental runs with dairy wastewater can be used to identify the optimum operational parameters to perform wastewater degradation on large scale for recycling purpose. Also effect of two different types of reactors on degradation process was analyzed.
Abstract: This paper aims to describe how student satisfaction is
measured for work-based learners as these are non-traditional
learners, conducting academic learning in the workplace, typically
their curricula have a high degree of negotiation, and whose
motivations are directly related to their employers- needs, as well as
their own career ambitions. We argue that while increasing WBL
participation, and use of SSD are both accepted as being of strategic
importance to the HE agenda, the use of WBL SSD is rarely
examined, and lessons can be learned from the comparison of SSD
from a range of WBL programmes, and increased visibility of this
type of data will provide insight into ways to improve and develop
this type of delivery. The key themes that emerged from the analysis
of the interview data were: learners profiles and needs, employers
drivers, academic staff drivers, organizational approach, tools for
collecting data and visibility of findings. The paper concludes with
observations on best practice in the collection, analysis and use of
WBL SSD, thus offering recommendations for both academic
managers and practitioners.
Abstract: To improve the efficiency of parametric studies or
tests planning the method is proposed, that takes into account all input parameters, but only a few simulation runs are performed to
assess the relative importance of each input parameter. For K input
parameters with N input values the total number of possible combinations of input values equals NK. To limit the number of runs,
only some (totally N) of possible combinations are taken into account. The sampling procedure Updated Latin Hypercube
Sampling is used to choose the optimal combinations. To measure the
relative importance of each input parameter, the Spearman rank
correlation coefficient is proposed. The sensitivity and the influence
of all parameters are analyzed within one procedure and the key
parameters with the largest influence are immediately identified.
Abstract: Light rail systems have proliferated in Spain in the last decade, following a tendency that is common not only in other European countries but also in other parts of the world. This paper reviews the benefits of light rail systems, both related to environmental issues and mobility issues. It analyses the evolution of light rail projects in Spain and shows that light rail systems in this country have evolved towards an extensive use of public-private partnerships. The analysis of the Spanish projects, however, does not contribute any conclusive evidence about whether public-private partnerships have been more efficient than publicly owned enterprises in building and operating light rail systems.
Abstract: An approach of design of stable of control systems with ultimately wide ranges of uncertainly disturbed parameters is offered. The method relies on using of nonlinear structurally stable functions from catastrophe theory as controllers. Theoretical part presents an analysis of designed nonlinear second-order control systems. As more important the integrators in series, canonical controllable form and Jordan forms are considered. The analysis resumes that due to added controllers systems become stable and insensitive to any disturbance of parameters. Experimental part presents MATLAB simulation of design of control systems of epidemic spread, aircrafts angular motion and submarine depth. The results of simulation confirm the efficiency of offered method of design. KeywordsCatastrophes, robust control, simulation, uncertain parameters.
Abstract: Authentication plays a vital role in many secure
systems. Most of these systems require user to log in with his or her
secret password or pass phrase before entering it. This is to ensure all
the valuables information is kept confidential guaranteeing also its
integrity and availability. However, to achieve this goal, users are
required to memorize high entropy passwords or pass phrases.
Unfortunately, this sometimes causes difficulty for user to remember
meaningless strings of data. This paper presents a new scheme which
assigns a weight to each personal question given to the user in
revealing the encrypted secrets or password. Concentration of this
scheme is to offer fault tolerance to users by allowing them to forget
the specific password to a subset of questions and still recover the
secret and achieve successful authentication. Comparison on level of
security for weight-based and weightless secret recovery scheme is
also discussed. The paper concludes with the few areas that requires
more investigation in this research.
Abstract: In this study, the reduction of Cr(VI) by use of scrap
iron, a cheap and locally available industrial waste, was investigated
in continuous system. The greater scrap iron efficiency observed for
the first two sections of the column filling indicate that most of the
reduction process was carried out in the bottom half of the column
filling. This was ascribed to a constant decrease of Cr(VI)
concentration inside the filling, as the water front passes from the
bottom to the top end of the column. While the bottom section of the
column filling was heavily passivated with secondary mineral phases,
the top section was less affected by the passivation process; therefore
the column filling would likely ensure the reduction of Cr(VI) for
time periods longer than 216 hours. The experimental results indicate
that fixed beds columns packed with scrap iron could be successfully
used for the first step of Cr(VI) polluted wastewater treatment.
However, the mass of scrap iron filling should be carefully estimated
since it significantly affects the Cr(VI) reduction efficiency.
Abstract: A numerical simulation of vortex-induced vibration of
a 2-dimensional elastic circular cylinder with two degree of freedom
under the uniform flow is calculated when Reynolds is 200.
2-dimensional incompressible Navier-Stokes equations are solved
with the space-time finite element method, the equation of the cylinder
motion is solved with the new explicit integral method and the mesh
renew is achieved by the spring moving mesh technology. Considering
vortex-induced vibration with the low reduced damping parameter, the
variety trends of the lift coefficient, the drag coefficient, the
displacement of cylinder are analyzed under different oscillating
frequencies of cylinder. The phenomena of locked-in, beat and
phases-witch were captured successfully. The evolution of vortex
shedding from the cylinder with time is discussed. There are very
similar trends in characteristics between the results of the one degree
of freedom cylinder model and that of the two degree of freedom
cylinder model. The streamwise vibrations have a certain effect on the
lateral vibrations and their characteristics.
Abstract: Numerical integration of initial boundary problem for advection equation in 3 ℜ is considered. The method used is
conditionally stable semi-Lagrangian advection scheme with high order interpolation on unstructured mesh. In order to increase time step integration the BFECC method with limiter TVD correction is used. The method is adopted on parallel graphic processor unit environment using NVIDIA CUDA and applied in Navier-Stokes solver. It is shown that the calculation on NVIDIA GeForce 8800
GPU is 184 times faster than on one processor AMDX2 4800+ CPU. The method is extended to the incompressible fluid dynamics solver. Flow over a Cylinder for 3D case is compared to the experimental data.
Abstract: Public housing is a vital factor in community
development. Successful city, housing and eco system regeneration
design is essential in providing positive community development.
This concerns work places, nice dwellings, providing premises for
child care, care of the elderly, providing qualitative premises for
different kinds of commercial service, providing a nice built
environment and housing areas and not the least activating tenants.
The public housing companies give value to society by stimulating
people, renovating socially and economically sustainable as well as
being partners to local business and authorities. By their activities the
housing companies contribute to sustainable local and regional
growth and the identity and reputation of cities. A Social, Economic
and Ecological Reputation Effect (SEERE) model for actions to
promote housing and community reputation is presented. The model
emphasizes regenerative actions to restore natural eco systems as part
of housing renewal strategies and to strengthen municipality
reputation.
Abstract: Segmentation of a color image composed of different
kinds of regions can be a hard problem, namely to compute for an
exact texture fields. The decision of the optimum number of
segmentation areas in an image when it contains similar and/or un
stationary texture fields. A novel neighborhood-based segmentation
approach is proposed. A genetic algorithm is used in the proposed
segment-pass optimization process. In this pass, an energy function,
which is defined based on Markov Random Fields, is minimized. In
this paper we use an adaptive threshold estimation method for image
thresholding in the wavelet domain based on the generalized
Gaussian distribution (GGD) modeling of sub band coefficients. This
method called Normal Shrink is computationally more efficient and
adaptive because the parameters required for estimating the threshold
depend on sub band data energy that used in the pre-stage of
segmentation. A quad tree is employed to implement the multi
resolution framework, which enables the use of different strategies at
different resolution levels, and hence, the computation can be
accelerated. The experimental results using the proposed
segmentation approach are very encouraging.
Abstract: increased competition and increased costs of
designing made it important for the firms to identify the right
products and the right methods for manufacturing the products. Firms
should focus on customers and identify customer demands directly to
design the right products. Several management methods and
techniques that are currently available improve one or more functions
or processes in an industry and do not take the complete product life
cycle into consideration. On the other hand target costing is a method
/ philosophy that takes financial, manufacturing and customer aspects
into consideration during designing phase and helps firms in making
product design decisions to increase the profit / value of the
company. It uses various techniques to identify customer demands, to
decrease costs of manufacturing and finally to achieve strategic goals.
Target Costing forms an integral part of total product design /
redesign based on strategic plans.
Abstract: The efficient use of available licensed spectrum is
becoming more and more critical with increasing demand and usage
of the radio spectrum. This paper shows how the use of spectrum as
well as dynamic spectrum management can be effectively managed
and spectrum allocation schemes in the wireless communication
systems be implemented and used, in future. This paper would be an
attempt towards better utilization of the spectrum. This research will
focus on the decision-making process mainly, with an
assumption that the radio environment has already been sensed and
the QoS requirements for the application have been specified either
by the sensed radio environment or by the secondary user itself. We
identify and study the characteristic parameters of Cognitive Radio
and use Genetic Algorithm for spectrum allocation. Performance
evaluation is done using MATLAB toolboxes.
Abstract: WiMAX and Wi-Fi are considered as the promising
broadband access solutions for wireless MAN’s and LANs,
respectively. In the recent works WiMAX is considered suitable as a
backhaul service to connect multiple dispersed Wi-Fi ‘hotspots’.
Hence a new integrated WiMAX/Wi-Fi architecture has been
proposed in literatures. In this paper the performance of an integrated
WiMAX/Wi-Fi network has been investigated by streaming a video
conference application. The difference in performance between the
two protocols is compared with respect to video conferencing. The
Heterogeneous network was simulated in the OPNET simulator.
Abstract: Process measurement is the task of empirically and objectively assigning numbers to the properties of business processes in such a way as to describe them. Desirable attributes to study and measure include complexity, cost, maintainability, and reliability. In our work we will focus on investigating process complexity. We define process complexity as the degree to which a business process is difficult to analyze, understand or explain. One way to analyze a process- complexity is to use a process control-flow complexity measure. In this paper, an attempt has been made to evaluate the control-flow complexity measure in terms of Weyuker-s properties. Weyuker-s properties must be satisfied by any complexity measure to qualify as a good and comprehensive one.