Abstract: Deep Brain Stimulation or DBS is the second solution
for Parkinson's Disease. Its three parameters are: frequency, pulse
width and voltage. They must be optimized to achieve successful
treatment. Nowadays it is done clinically by neurologists and there is
not certain numerical method to detect them. The aim of this research
is to introduce simulation and modeling of Parkinson's Disease
treatment as a computational procedure to select optimum voltage.
We recorded finger tremor signals of some Parkinsonian patients
under DBS treatment at constant frequency and pulse width but
variable voltages; then, we adapted a new model to fit these data. The
optimum voltages obtained by data fitting results were the same as
neurologists- commented voltages, which means modeling can be
used as an engineering method to select optimum stimulation
voltages.
Abstract: Software security testing is an important means to ensure software security and trustiness. This paper first mainly discusses the definition and classification of software security testing, and investigates methods and tools of software security testing widely. Then it analyzes and concludes the advantages and disadvantages of various methods and the scope of application, presents a taxonomy of security testing tools. Finally, the paper points out future focus and development directions of software security testing technology.
Abstract: An on-demand routing protocol for wireless ad hoc
networks is one that searches for and attempts to discover a route to
some destination node only when a sending node originates a data
packet addressed to that node. In order to avoid the need for such a
route discovery to be performed before each data packet is sent, such
routing protocols must cache routes previously discovered. This
paper presents an analysis of the effect of intelligent caching in a non
clustered network, using on-demand routing protocols in wireless ad
hoc networks. The analysis carried out is based on the Dynamic
Source Routing protocol (DSR), which operates entirely on-demand.
DSR uses the cache in every node to save the paths that are learnt
during route discovery procedure. In this implementation, caching
these paths only at intermediate nodes and using the paths from these
caches when required is tried. This technique helps in storing more
number of routes that are learnt without erasing the entries in the
cache, to store a new route that is learnt.
The simulation results on DSR have shown that this technique
drastically increases the available memory for caching the routes
discovered without affecting the performance of the DSR routing
protocol in any way, except for a small increase in end to end delay.
Abstract: Medical image registration is the key technology in image guided radiation therapy (IGRT) systems. On the basis of the previous work on our IGRT prototype with a biorthogonal x-ray imaging system, we described a method focused on the 2D/2D rigid-body registration using multiresolution pyramid based mutual information in this paper. Three key steps were involved in the method ： firstly, four 2D images were obtained including two x-ray projection images and two digital reconstructed radiographies（DRRs ） as the input for the registration ； Secondly, each pair of the corresponding x-ray image and DRR image were matched using multiresolution pyramid based mutual information under the ITK registration framework ； Thirdly, we got the final couch offset through a coordinate transformation by calculating the translations acquired from the two pairs of the images. A simulation example of a parotid gland tumor case and a clinical example of an anthropomorphic head phantom were employed in the verification tests. In addition, the influence of different CT slice thickness were tested. The simulation results showed that the positioning errors were 0.068±0.070, 0.072±0.098, 0.154±0.176mm along three axes which were lateral, longitudinal and vertical. The clinical test indicated that the positioning errors of the planned isocenter were 0.066, 0.07, 2.06mm on average with a CT slice thickness of 2.5mm. It can be concluded that our method with its verified accuracy and robustness can be effectively used in IGRT systems for patient setup.
Abstract: This paper describes the authorization system
architecture for Pervasive Grid environment. It discusses the
characteristics of classical authorization system and requirements of
the authorization system in pervasive grid environment as well.
Based on our analysis of current systems and taking into account the
main requirements of such pervasive environment, we propose new
authorization system architecture as an extension of the existing grid
authorization mechanisms. This architecture not only supports user
attributes but also context attributes which act as a key concept for
context-awareness thought. The architecture allows authorization of
users dynamically when there are changes in the pervasive grid
environment. For this, we opt for hybrid authorization method that
integrates push and pull mechanisms to combine the existing grid
authorization attributes with dynamic context assertions. We will
investigate the proposed architecture using a real testing environment
that includes heterogeneous pervasive grid infrastructures mapped
over multiple virtual organizations. Various scenarios are described
in the last section of the article to strengthen the proposed mechanism
with different facilities for the authorization procedure.
Abstract: This paper present a new way to find the aerodynamic characteristic equation of missile for the numerical trajectories prediction more accurate. The goal is to obtain the polynomial equation based on two missile characteristic parameters, angle of attack (α ) and flight speed (╬¢ ). First, the understudied missile is modeled and used for flow computational model to compute aerodynamic force and moment. Assume that performance range of understudied missile where range -10< α
Abstract: Alcohol and water extracts of Cymbopogon citratus
was investigated for anti-bacterial properties and phytochemical
constituents. The extract was screened against four gram-negative
bacteria Escherichia coli, Klebsiella pneumoniae, Pseudomonas
aeruginosa, Proteus vulgaris) and two grampositive bacteria Bacillus
subtilis and Staphylococcus aureus at four different concentrations
(1:1, 1:5, 1:10 and 1:20) using disc diffusion method. The antibacterial
examination was by disc diffusion techniques, while the
photochemical constituents were investigated using standard
chemical methods. Results showed that the extracts inhibited the
growth of standard and local strains of the organisms used. The
treatments were significantly different (P = 0.05). The minimum
inhibitory concentration of the extracts against the tested
microorganisms ranged between 150mg/ml and 50mg/ml. The
alcohol extracts were found to be generally more effective than the
water extract. The photochemical analysis revealed the presence of
alkaloids and phenol but absence of cardiac and cyanogenic
glycosides. The presence of alkaloid and phenols were inferred as
being responsible for the anti-bacterial properties of the extracts.
Abstract: The cup method is applied for the measurement of water vapor transport properties of porous materials worldwide. However, in practical applications the experimental results are often used without taking into account some secondary effects which can play an important role under specific conditions. In this paper, the effect of temperature on water vapor transport properties of cellular concrete is studied, together with the influence of sample thickness. At first, the bulk density, matrix density, total open porosity and sorption and desorption isotherms are measured for material characterization purposes. Then, the steady state cup method is used for determination of water vapor transport properties, whereas the measurements are performed at several temperatures and for three different sample thicknesses.
Abstract: There are various overlay structures that provide
efficient and scalable solutions for point and range query in a peer-topeer
network. Overlay structure based on m-Binary Search Tree
(BST) is one such popular technique. It deals with the division of the
tree into different key intervals and then assigning the key intervals to
a BST. The popularity of the BST makes this overlay structure
vulnerable to different kinds of attacks. Here we present four such
possible attacks namely index poisoning attack, eclipse attack,
pollution attack and syn flooding attack. The functionality of BST is
affected by these attacks. We also provide different security
techniques that can be applied against these attacks.
Abstract: This article is dedicated to development of
mathematical models for determining the dynamics of
concentration of hazardous substances in urban turbulent
atmosphere. Development of the mathematical models implied
taking into account the time-space variability of the fields of
meteorological items and such turbulent atmosphere data as vortex
nature, nonlinear nature, dissipativity and diffusivity. Knowing the
turbulent airflow velocity is not assumed when developing the
model. However, a simplified model implies that the turbulent and
molecular diffusion ratio is a piecewise constant function that
changes depending on vertical distance from the earth surface.
Thereby an important assumption of vertical stratification of urban
air due to atmospheric accumulation of hazardous substances
emitted by motor vehicles is introduced into the mathematical
model. The suggested simplified non-linear mathematical model of
determining the sought exhaust concentration at a priori unknown
turbulent flow velocity through non-degenerate transformation is
reduced to the model which is subsequently solved analytically.
Abstract: Intrusion Detection System is significant in network
security. It detects and identifies intrusion behavior or intrusion
attempts in a computer system by monitoring and analyzing the
network packets in real time. In the recent year, intelligent algorithms
applied in the intrusion detection system (IDS) have been an
increasing concern with the rapid growth of the network security.
IDS data deals with a huge amount of data which contains irrelevant
and redundant features causing slow training and testing process,
higher resource consumption as well as poor detection rate. Since the
amount of audit data that an IDS needs to examine is very large even
for a small network, classification by hand is impossible. Hence, the
primary objective of this review is to review the techniques prior to
classification process suit to IDS data.
Abstract: Performance of a limited Round-Robin (RR) rule is
studied in order to clarify the characteristics of a realistic sharing
model of a processor. Under the limited RR rule, the processor
allocates to each request a fixed amount of time, called a quantum, in a
fixed order. The sum of the requests being allocated these quanta is
kept below a fixed value. Arriving requests that cannot be allocated
quanta because of such a restriction are queued or rejected. Practical
performance measures, such as the relationship between the mean
sojourn time, the mean number of requests, or the loss probability and
the quantum size are evaluated via simulation. In the evaluation, the
requested service time of an arriving request is converted into a
quantum number. One of these quanta is included in an RR cycle,
which means a series of quanta allocated to each request in a fixed
order. The service time of the arriving request can be evaluated using
the number of RR cycles required to complete the service, the number
of requests receiving service, and the quantum size. Then an increase
or decrease in the number of quanta that are necessary before service is
completed is reevaluated at the arrival or departure of other requests.
Tracking these events and calculations enables us to analyze the
performance of our limited RR rule. In particular, we obtain the most
suitable quantum size, which minimizes the mean sojourn time, for the
case in which the switching time for each quantum is considered.
Abstract: Robot manipulators are highly coupled nonlinear
systems, therefore real system and mathematical model of dynamics
used for control system design are not same. Hence, fine-tuning of
controller is always needed. For better tuning fast simulation speed
is desired. Since, Matlab incorporates LAPACK to increase the speed
and complexity of matrix computation, dynamics, forward and
inverse kinematics of PUMA 560 is modeled on Matlab/Simulink in
such a way that all operations are matrix based which give very less
simulation time. This paper compares PID parameter tuning using
Genetic Algorithm, Simulated Annealing, Generalized Pattern Search
(GPS) and Hybrid Search techniques. Controller performances for all
these methods are compared in terms of joint space ITSE and
cartesian space ISE for tracking circular and butterfly trajectories.
Disturbance signal is added to check robustness of controller. GAGPS
hybrid search technique is showing best results for tuning PID
controller parameters in terms of ITSE and robustness.
Abstract: This paper describes the architectural design
considerations for building a new class of application, a Personal
Knowledge Integrator and a particular example a Knowledge Theatre.
It then supports this description by describing a scenario of a child
acquiring knowledge and how this process could be augmented by
the proposed architecture and design of a Knowledge Theatre. David
Merrill-s first “principles of instruction" are kept in focus to provide
a background to view the learning potential.
Abstract: The stereophotogrammetry modality is gaining more widespread use in the clinical setting. Registration and visualization of this data, in conjunction with conventional 3D volumetric image modalities, provides virtual human data with textured soft tissue and internal anatomical and structural information. In this investigation computed tomography (CT) and stereophotogrammetry data is acquired from 4 anatomical phantoms and registered using the trimmed iterative closest point (TrICP) algorithm. This paper fully addresses the issue of imaging artifacts around the stereophotogrammetry surface edge using the registered CT data as a reference. Several iterative algorithms are implemented to automatically identify and remove stereophotogrammetry surface edge outliers, improving the overall visualization of the combined stereophotogrammetry and CT data. This paper shows that outliers at the surface edge of stereophotogrammetry data can be successfully removed automatically.
Abstract: Application-Specific Instruction (ASI ) set Processors
(ASIP) have become an important design choice for embedded
systems due to runtime flexibility, which cannot be provided by
custom ASIC solutions. One major bottleneck in maximizing ASIP
performance is the limitation on the data bandwidth between the
General Purpose Register File (GPRF) and ASIs. This paper presents
the Implicit Registers (IRs) to provide the desirable data bandwidth.
An ASI Input/Output model is proposed to formulate the overheads of
the additional data transfer between the GPRF and IRs, therefore,
an IRs allocation algorithm is used to achieve the better performance
by minimizing the number of extra data transfer instructions. The
experiment results show an up to 3.33x speedup compared to the
results without using IRs.
Abstract: In order to guarantee secure communication for wireless sensor networks (WSNs), many user authentication schemes have successfully drawn researchers- attention and been studied widely. In 2012, He et al. proposed a robust biometric-based user authentication scheme for WSNs. However, this paper demonstrates that He et al.-s scheme has some drawbacks: poor reparability problem, user impersonation attack, and sensor node impersonate attack.
Abstract: Hyperglycemia-mediated accumulation of advanced glycation end-products (AGEs) play a pivotal role in the development of diabetic complications by inducing inflammation. In the present study, we evaluated the possible effects of water/ethanol (1/1, v/v) extracts (WEE) and its fractions from Canarium album Raeusch. (Chinese olive) which is a fruit used on AGEs-stimulated oxidative stress and inflammation in monocytes and vascular endothelial cells. Co-incubation of EA.hy926 endothelial cells with WEE and its fractions for 24h resulted in a significant decrease of monocyte–endothelial cell adhesion, the expression of ICAM-1, generation of intracellular ROS and depletion of GSH induced by AGEs. Chinese olive fruit extracts also reduced the expression of pro-inflammatory mediates, such as TNF-α, IL-1β and IL-6 in THP-1 cells. These findings suggested that Chinese olive fruit was able to protect vascular endothelium from dysfunction induced by AGEs.
Abstract: In this paper we proposed comparison of four content based objective metrics with results of subjective tests from 80 video sequences. We also include two objective metrics VQM and SSIM to our comparison to serve as “reference” objective metrics because their pros and cons have already been published. Each of the video sequence was preprocessed by the region recognition algorithm and then the particular objective video quality metric were calculated i.e. mutual information, angular distance, moment of angle and normalized cross-correlation measure. The Pearson coefficient was calculated to express metrics relationship to accuracy of the model and the Spearman rank order correlation coefficient to represent the metrics relationship to monotonicity. The results show that model with the mutual information as objective metric provides best result and it is suitable for evaluating quality of video sequences.
Abstract: In this paper, a system level behavioural model for RF
power amplifier, which exhibits memory effects, and based on multibranch
system is proposed. When higher order terms are included,
the memory polynomial model (MPM) exhibits numerical
instabilities. A set of memory orthogonal polynomial model
(OMPM) is introduced to alleviate the numerical instability problem
associated to MPM model. A data scaling and centring algorithm was
applied to improve the power amplifier modeling accuracy.
Simulation results prove that the numerical instability can be greatly
reduced, as well as the model precision improved with nonlinear
model.