Abstract: In this study, workplace environmental monitoring
systems were established using USN(Ubiquitous Sensor Networks)
and LabVIEW. Although existing direct sampling methods enable
finding accurate values as of the time points of measurement, those
methods are disadvantageous in that continuous management and
supervision are difficult and costs for are high when those methods are
used. Therefore, the efficiency and reliability of workplace
management by supervisors are relatively low when those methods are
used. In this study, systems were established so that information on
workplace environmental factors such as temperatures, humidity and
noises is measured and transmitted to the PC in real time to enable
supervisors to monitor workplaces through LabVIEW on the PC.
When any accidents have occurred in workplaces, supervisors can
immediately respond through the monitoring system and this system
enables integrated workplace management and the prevention of
safety accidents. By introducing these monitoring systems, safety
accidents due to harmful environmental factors in workplaces can be
prevented and these monitoring systems will be also helpful in finding
out the correlation between safety accidents and occupational diseases
by comparing and linking databases established by this monitoring
system with existing statistical data.
Abstract: The paper presents a compressor anti-surge control
system, that results in maximizing compressor throughput with
pressure standard deviation reduction, increased safety margin
between design point and surge limit line and avoiding possible
machine surge. Alternative control strategies are presented.
Abstract: The most common result of analysis of highthroughput
data in molecular biology represents a global list of
genes, ranked accordingly to a certain score. The score can be a
measure of differential expression. Recent work proposed a new
method for selecting a number of genes in a ranked gene list from
microarray gene expression data such that this set forms the
Optimally Functionally Enriched Network (OFTEN), formed by
known physical interactions between genes or their products. Here
we present calculation results of relative connectivity of genes from
META-OFTEN network and tentative biological interpretation of the
most reproducible signal. The relative connectivity and
inbetweenness values of genes from META-OFTEN network were
estimated.
Abstract: In order to provide and maintain effective pedagogy for the burgeoning virtual reality community, it is vital to have trained faculty in the institutions of higher education who will teach these courses and be able to make full use of their academic knowledge and expertise. As the number of online courses continues to grow, there is a need for these institutions to establish mentoring programs that will support the novice online instructor. The environment in which this takes place and the factors that ensure its success are critical to the adoption of the new instructional delivery format taught by both seasoned educators and adjunct instructors. Effective one-on-one mentoring promotes a professional, compassionate and collegial faculty who will provide a consistent and rigorous academic program for students online.
Abstract: We report on the development of a model to
understand why the range of experience with respect to HIV
infection is so diverse, especially with respect to the latency period.
To investigate this, an agent-based approach is used to extract highlevel
behaviour which cannot be described analytically from the set
of interaction rules at the cellular level. A network of independent
matrices mimics the chain of lymph nodes. Dealing with massively
multi-agent systems requires major computational effort. However,
parallelisation methods are a natural consequence and advantage of
the multi-agent approach and, using the MPI library, are here
implemented, tested and optimized. Our current focus is on the
various implementations of the data transfer across the network.
Three communications strategies are proposed and tested, showing
that the most efficient approach is communication based on the
natural lymph-network connectivity.
Abstract: When a high DC voltage is applied to a capacitor with
strongly asymmetrical electrodes, it generates a mechanical force that
affects the whole capacitor. This is caused by the motion of ions generated around the smaller of the two electrodes and their subsequent interaction with the surrounding medium. If one of the electrodes is heated, it changes the conditions around the capacitor
and influences the process of ionisation, thus changing the value of the generated force. This paper describes these changes and gives
reasons behind them. Further the experimental results are given as proof of the ionic mechanism of the phenomenon.
Abstract: Neural networks offer an alternative approach both
for identification and control of nonlinear processes in process
engineering. The lack of software tools for the design of controllers
based on neural network models is particularly pronounced in this
field. SIMULINK is properly a widely used graphical code
development environment which allows system-level developers to
perform rapid prototyping and testing. Such graphical based
programming environment involves block-based code development
and offers a more intuitive approach to modeling and control task in
a great variety of engineering disciplines. In this paper a
SIMULINK based Neural Tool has been developed for analysis and
design of multivariable neural based control systems. This tool has
been applied to the control of a high purity distillation column
including non linear hydrodynamic effects. The proposed control
scheme offers an optimal response for both theoretical and practical
challenges posed in process control task, in particular when both,
the quality improvement of distillation products and the operation
efficiency in economical terms are considered.
Abstract: The liberalization and privatization processes have
forced public utility companies to face new competitive challenges,
implementing strategies to gain market share and, at the same time,
keep the old customers. To this end, many companies have carried
out mergers, acquisitions and conglomerations in order to diversify
their business. This paper focuses on companies operating in the free
energy market in Italy. In the last decade, this sector has undergone
profound changes that have radically changed the competitive
scenario and have led companies to implement diversification
strategies of the business. Our work aims to evaluate the economic
and financial performances obtained by energy companies, following
the beginning of the liberalization process, verifying the possible
relationship with the implemented diversification strategies.
Abstract: This work evaluated the effect of temperature on headspace solid-phase microextraction of volatile and furanic compounds in coated fish sticks. The major goal was the analysis of the samples as consumed, to reproduce volatile compounds people feel when consuming those products. Extraction at 37 ºC (the human body temperature) throughout the HS-SPME analysis of volatile and furanic compounds in coated fish was compared with higher extraction temperatures, which are frequently used for this kind of determinations. The profile of volatile compounds found in deepfried (F) and non-fried (NF) coated fish at 37 and 50 ºC was different from that obtained at 80 ºC. Concerning furan and its derivatives, an extra formation of these compounds was observed at higher extraction temperatures. The analysis of volatile and furanic compounds in fish coated sticks simulating the cooking and eating conditions can be reliably carried out setting the headspace absorption temperature at 37 ºC.
Abstract: Biodiesel as an alternative fuel for diesel engines has been developed for some three decades now. While it is gaining wide acceptance in Europe, USA and some parts of Asia, the same cannot be said of Africa. With more than 35 countries in the continent depending on imported crude oil, it is necessary to look for alternative fuels which can be produced from resources available locally within any country. Hence this study presents performance of single cylinder diesel engine using blends of shea butter biodiesel. Shea butter was transformed into biodiesel by transesterification process. Tests are conducted to compare the biodiesel with baseline diesel fuel in terms of engine performance and exhaust emission characteristics. The results obtained showed that the addition of biodiesel to diesel fuel decreases the brake thermal efficiency (BTE) and increases the brake specific fuel consumption (BSFC). These results are expected due to the lower energy content of biodiesel fuel. On the other hand while the NOx emissions increased with increase in biodiesel content in the fuel blends, the emissions of carbon monoxide (CO), un-burnt hydrocarbon (UHC) and smoke opacity decreased. The engine performance which indicates that the biodiesel has properties and characteristics similar to diesel fuel and the reductions in exhaust emissions make shea butter biodiesel a viable additive or substitute to diesel fuel.
Abstract: This paper explores the opportunity of using tri-axial
wireless accelerometers for supervised monitoring of sports
movements. A motion analysis system for the upper extremities of
lawn bowlers in particular is developed. Accelerometers are placed
on parts of human body such as the chest to represent the shoulder
movements, the back to capture the trunk motion, back of the hand,
the wrist and one above the elbow, to capture arm movements. These
sensors placement are carefully designed in order to avoid restricting
bowler-s movements. Data is acquired from these sensors in soft-real
time using virtual instrumentation; the acquired data is then
conditioned and converted into required parameters for motion
regeneration. A user interface was also created to facilitate in the
acquisition of data, and broadcasting of commands to the wireless
accelerometers. All motion regeneration in this paper deals with the
motion of the human body segment in the X and Y direction, looking
into the motion of the anterior/ posterior and lateral directions
respectively.
Abstract: In today-s turbulent environment, companies are faced with two principal challenges. On the one hand, it is necessary to produce ever more cost-effectively to remain competitive. On the other hand, factories need to be transformable in order to manage unpredictable changes in the corporate environment. To deal with these different challenges, companies use the philosophy of lean production in the first case, in the second case the philosophy of transformability. To a certain extent these two approaches follow different directions. This can cause conflicts when designing factories. Therefore, the Institute of Production Systems and Logistics (IFA) of the Leibniz University of Hanover has developed a procedure to allow companies to evaluate and design their factories with respect to the requirements of both philosophies.
Abstract: Bone remodeling occurs by the balanced action of
bone resorbing osteoclasts (OC) and bone-building osteoblasts.
Increased bone resorption by excessive OC activity contributes
to malignant and non-malignant diseases including osteoporosis.
To study OC differentiation and function, OC formed in
in vitro cultures are currently counted manually, a tedious
procedure which is prone to inter-observer differences. Aiming
for an automated OC-quantification system, classification of
OC and precursor cells was done on fluorescence microscope
images based on the distinct appearance of fluorescent nuclei.
Following ellipse fitting to nuclei, a combination of eight
features enabled clustering of OC and precursor cell nuclei.
After evaluating different machine-learning techniques, LOGREG
achieved 74% correctly classified OC and precursor cell
nuclei, outperforming human experts (best expert: 55%). In
combination with the automated detection of total cell areas,
this system allows to measure various cell parameters and most
importantly to quantify proteins involved in osteoclastogenesis.
Abstract: Subdivision is a method to create a smooth surface from a coarse mesh by subdividing the entire mesh. The conventional ways to compute and render surfaces are inconvenient both in terms of memory and computational time as the number of meshes will increase exponentially. An adaptive subdivision is the way to reduce the computational time and memory by subdividing only certain selected areas. In this paper, a new adaptive subdivision method for triangle meshes is introduced. This method defines a new adaptive subdivision rules by considering the properties of each triangle's neighbors and is embedded in a traditional Loop's subdivision. It prevents some undesirable side effects that appear in the conventional adaptive ways. Models that were subdivided by our method are compared with other adaptive subdivision methods
Abstract: A satellite is being integrated and tested by BISEE (Beijing Institute of Spacecraft Environment Engineering). This paper describes the infrared lamp array simulation technology used for satellite thermal balance and thermal vacuum test. These tests were performed in KM6 space environmental simulator in Beijing, China. New software and hardware developed by BISEE, along with enhanced heat flux uniformity, provided for well accomplished thermal balance and thermal vacuum tests. The flux uniformity of lamp array was satisfied with test requirement. Monitored background radiometer offered reliable heat flux measurements with remarkable repeatability. Simulation software supplied accurate thermal flux distribution predictions.
Abstract: In this paper a non-parametric statistical pattern recognition algorithm for the problem of credit scoring will be presented. The proposed algorithm is based on a clustering k- means algorithm and allows for the determination of subclasses of homogenous elements in the data. The algorithm will be tested on two benchmark datasets and its performance compared with other well known pattern recognition algorithm for credit scoring.
Abstract: Despite the fact that B2c eCommerce has become
important in numerous economies, its adoption varies from country to
country. This paper aims to identify the factors affecting (enabling or
inhibiting) B2c eCommerce and to determine their quantitative
impact on the diffusion of online sales across countries. A dynamic
panel model analyzing the relationship between 13 factors
(Macroeconomic, Demographic, Socio-Cultural, Infrastructural and
Offer related) stemming from a complete literature analysis and the
B2c eCommerce value in 45 countries over 9 years has been
developed. Having a positive correlation coefficient, GDP, mobile
penetration, Internet user penetration and credit card penetration
resulted as enabling drivers of the B2c eCommerce value across
countries, whereas, having a negative correlation coefficient,equal
distribution of income and the development of traditional retailing
network act as inhibiting factors.
Abstract: In this paper, we study the stability of a fractional order delayed predator-prey model. By using the Laplace transform, we introduce a characteristic equation for the above system. It is shown that if all roots of the characteristic equation have negative parts, then the equilibrium of the above fractional order predator-prey system is Lyapunov globally asymptotical stable. An example is given to show the effectiveness of the approach presented in this paper.