Abstract: This research was to study effect of rotational speed
and eccentric factors, which were affected on looseness of bearing.
The experiment was conducted on three rotational speeds and five
eccentric distances with 5 replications. The results showed that
influenced factor affected to looseness of bearing was rotational
speed and eccentric distance which showed statistical significant.
Higher rotational speed would cause on high looseness. Moreover,
more eccentric distance, more looseness of bearing. Using bearing at
high rotational with high eccentric of shaft would be affected
bearing fault more than lower rotational speed. The prediction
equation of looseness was generated by regression analysis. The
prediction has an effected to the looseness of bearing at 91.5%.
Abstract: The objective of this research was to study factors,
which were affected on surface roughness in high speed milling of
hardened tool steel. Material used in the experiment was tool steel JIS
SKD 61 that hardened on 60 ±2 HRC. Full factorial experimental
design was conducted on 3 factors and 3 levels (3
3
designs) with 2
replications. Factors were consisted of cutting speed, feed rate, and
depth of cut. The results showed that influenced factor affected to
surface roughness was cutting speed, feed rate and depth of cut which
showed statistical significant. Higher cutting speed would cause on
better surface quality. On the other hand, higher feed rate would cause
on poorer surface quality. Interaction of factor was found that cutting
speed and depth of cut were significantly to surface quality. The
interaction of high cutting speed associated with low depth of cut
affected to better surface quality than low cutting speed and high depth
of cut.