Abstract: The world-s largest Pre-stressed Concrete Cylinder
Pipe (PCCP) water supply project had a series of pipe failures which
occurred between 1999 and 2001. This has led the Man-Made River
Authority (MMRA), the authority in charge of the implementation
and operation of the project, to setup a rehabilitation plan for the
conveyance system while maintaining the uninterrupted flow of
water to consumers. At the same time, MMRA recognized the need
for a long term management tool that would facilitate repair and
maintenance decisions and enable taking the appropriate preventive
measures through continuous monitoring and estimation of the
remaining life of each pipe. This management tool is known as the
Pipe Risk Management System (PRMS) and now in operation at
MMRA. Both the rehabilitation plan and the PRMS require the
availability of complete and accurate pipe construction and
manufacturing data
This paper describes a systematic approach of data collection,
analysis, evaluation and correction for the construction and
manufacturing data files of phase I pipes which are the platform for
the PRMS database and any other related decision support system.
Abstract: Telecommuting has become an increasingly popular
work arrangement. However, little research has examined the impact
of telecommuting on the relationship between employees and the
organization. This study aims to shed light on this aspect by
comparing the loyalty of telecommuters and non telecommuters as it
can be viewed from three angles: organizational loyalty, peer loyalty,
and professional loyalty. Furthermore, this paper will explore the
dynamics among employee loyalty, productivity, and job
satisfaction. Whereas previous studies had looked on employees that
are not fully telecommuting, the current study concentrates on
employees that are exclusively working from home.
Abstract: Octree compression techniques have been used
for several years for compressing large three dimensional data
sets into homogeneous regions. This compression technique
is ideally suited to datasets which have similar values in
clusters. Oil engineers represent reservoirs as a three dimensional
grid where hydrocarbons occur naturally in clusters. This
research looks at the efficiency of storing these grids using
octree compression techniques where grid cells are broken
into active and inactive regions. Initial experiments yielded
high compression ratios as only active leaf nodes and their
ancestor, header nodes are stored as a bitstream to file on
disk. Savings in computational time and memory were possible
at decompression, as only active leaf nodes are sent to the
graphics card eliminating the need of reconstructing the original
matrix. This results in a more compact vertex table, which can
be loaded into the graphics card quicker and generating shorter
refresh delay times.
Abstract: the aim of this study was to analyze ethnopsychological content of “Aitys" as a process of creative competition in Kazakh traditional folklore by means of Transaction analysis (three types of Ego states are Parent, Adult and Child). “Aitys" is as sources of Kazakh national self-consciousness and form of oral Kazakh national creativity. Comparative psychological analysis of classical and modern “aityses" is carried out. Empirical proved that the victory in “Aitys" is provided with a position of egostate “Adult".
Abstract: The aim of this paper is to provide an empirical
evidence about the effects that the management of continuous
training have on employability (or employment stability) in the
Spanish labour market. With this purpose a binary logit model with
interaction effect is been used. The dependent variable includes two
situations of the active workers: continuous and discontinuous
employability. To distinguish between them an Employability Index
Stability (ESI) was calculated taking into account two factors: time
worked and job security. Various aspects of the continuous training
and personal workers data are used as independent variables. The
data obtained from a survey of a sample of 918 employed have
revealed a relationship between the likelihood of continuous
employability and continuous training received. The empirical results
support the positive and significant relationship between various
aspects of the training provided by firms and employability
likelihood of the workers, postulate alike from a theoretical point of
view.
Abstract: In this paper, a new probability density function (pdf)
is proposed to model the statistics of wavelet coefficients, and a
simple Kalman-s filter is derived from the new pdf using Bayesian
estimation theory. Specifically, we decompose the speckled image
into wavelet subbands, we apply the Kalman-s filter to the high
subbands, and reconstruct a despeckled image from the modified
detail coefficients. Experimental results demonstrate that our method
compares favorably to several other despeckling methods on test
synthetic aperture radar (SAR) images.
Abstract: In this work, we study the impact of dynamically changing link slowdowns on the stability properties of packetswitched networks under the Adversarial Queueing Theory framework. Especially, we consider the Adversarial, Quasi-Static Slowdown Queueing Theory model, where each link slowdown may take on values in the two-valued set of integers {1, D} with D > 1 which remain fixed for a long time, under a (w, p)-adversary. In this framework, we present an innovative systematic construction for the estimation of adversarial injection rate lower bounds, which, if exceeded, cause instability in networks that use the LIS (Longest-in- System) protocol for contention-resolution. In addition, we show that a network that uses the LIS protocol for contention-resolution may result in dropping its instability bound at injection rates p > 0 when the network size and the high slowdown D take large values. This is the best ever known instability lower bound for LIS networks.
Abstract: Whole genome duplication (WGD) increased the
number of yeast Saccharomyces cerevisiae chromosomes from 8 to
16. In spite of retention the number of chromosomes in the genome
of this organism after WGD to date, chromosomal rearrangement
events have caused an evolutionary distance between current genome
and its ancestor. Studies under evolutionary-based approaches on
eukaryotic genomes have shown that the rearrangement distance is an
approximable problem. In the case of S. cerevisiae, we describe that
rearrangement distance is accessible by using dedoubled adjacency
graph drawn for 55 large paired chromosomal regions originated
from WGD. Then, we provide a program extracted from a C program
database to draw a dedoubled genome adjacency graph for S.
cerevisiae. From a bioinformatical perspective, using the duplicated
blocks of current genome in S. cerevisiae, we infer that genomic
organization of eukaryotes has the potential to provide valuable
detailed information about their ancestrygenome.
Abstract: The paper presents the potential of fuzzy logic (FL-I)
and neural network techniques (ANN-I) for predicting the
compressive strength, for SCC mixtures. Six input parameters that is
contents of cement, sand, coarse aggregate, fly ash, superplasticizer
percentage and water-to-binder ratio and an output parameter i.e. 28-
day compressive strength for ANN-I and FL-I are used for modeling.
The fuzzy logic model showed better performance than neural
network model.
Abstract: Estimation of voltage stability based on optimal
filtering method is presented. PV curve is used as a tool for voltage stability analysis. Dynamic voltage stability estimation is done by
using particle filter method. Optimum value (nose point) of PV curve can be estimated by estimating parameter of PV curve equation
optimal value represents critical voltage and
condition at specified point of measurement. Voltage stability is then estimated by analyzing loading margin condition c stimating equation. This
maximum loading
ecified dynamically.
Abstract: A steady two-dimensional magnetohydrodynamics
flow and heat transfer over a stretching vertical sheet influenced by
radiation and porosity is studied. The governing boundary layer
equations of partial differential equations are reduced to a system of
ordinary differential equations using similarity transformation. The
system is solved numerically by using a finite difference scheme
known as the Keller-box method for some values of parameters,
namely the radiation parameter N, magnetic parameter M, buoyancy
parameter l , Prandtl number Pr and permeability parameter K. The
effects of the parameters on the heat transfer characteristics are
analyzed and discussed. It is found that both the skin friction
coefficient and the local Nusselt number decrease as the magnetic
parameter M and permeability parameter K increase. Heat transfer
rate at the surface decreases as the radiation parameter increases.
Abstract: Power cables are vulnerable to failure due to aging or
defects that occur with the passage of time under continuous
operation and loading stresses. PD detection and characterization
provide information on the location, nature, form and extent of the
degradation. As a result, PD monitoring has become an important
part of condition based maintenance (CBM) program among power
utilities. Online partial discharge (PD) localization of defect sources
in power cable system is possible using the time of flight method.
The information regarding the time difference between the main and
reflected pulses and cable length can help in locating the partial
discharge source along the cable length. However, if the length of
the cable is not known and the defect source is located at the extreme
ends of the cable or in the middle of the cable, then double ended
measurement is required to indicate the location of PD source. Use of
multiple sensors can also help in discriminating the cable PD or local/
external PD. This paper presents the experience and results from
online partial discharge measurements conducted in the laboratory
and the challenges in partial discharge source localization.
Abstract: Chicken fat was employed as a feedstock for
producing of biodiesel by trasesterification reaction with methanol
and alkali catalyst (KOH). In this study chicken fat biodiesel with
1.4% free fatty acid, methanol and various amount of potassium
hydroxide for 2 hour were studied. The progression of reaction and
conversion of triglycerides to methyl ester were checked by IR
spectrum method.
Abstract: In this study, effects of premixed and equivalence
ratios on CO and HC emissions of a dual fuel HCCI engine are
investigated. Tests were conducted on a single-cylinder engine with
compression ratio of 17.5. Premixed gasoline is provided by a
carburetor connected to intake manifold and equipped with a screw
to adjust premixed air-fuel ratio, and diesel fuel is injected directly
into the cylinder through an injector at pressure of 250 bars. A heater
placed at inlet manifold is used to control the intake charge
temperature. Optimal intake charge temperature results in better
HCCI combustion due to formation of a homogeneous mixture,
therefore, all tests were carried out over the optimum intake
temperature of 110-115 ºC. Timing of diesel fuel injection has a great
effect on stratification of in-cylinder charge and plays an important
role in HCCI combustion phasing. Experiments indicated 35 BTDC
as the optimum injection timing. Varying the coolant temperature in
a range of 40 to 70 ºC, better HCCI combustion was achieved at 50
ºC. Therefore, coolant temperature was maintained 50 ºC during all
tests. Simultaneous investigation of effective parameters on HCCI
combustion was conducted to determine optimum parameters
resulting in fast transition to HCCI combustion. One of the
advantages of the method studied in this study is feasibility of easy
and fast transition of typical diesel engine to a dual fuel HCCI
engine. Results show that increasing premixed ratio, while keeping
EGR rate constant, increases unburned hydrocarbon (UHC)
emissions due to quenching phenomena and trapping of premixed
fuel in crevices, but CO emission decreases due to increase in CO to
CO2 reactions.
Abstract: In the recent years multimedia traffic and in particular
VoIP services are growing dramatically. We present a new algorithm
to control the resource utilization and to optimize the voice codec
selection during SIP call setup on behalf of the traffic condition
estimated on the network path.
The most suitable methodologies and the tools that perform realtime
evaluation of the available bandwidth on a network path have
been integrated with our proposed algorithm: this selects the best
codec for a VoIP call in function of the instantaneous available
bandwidth on the path. The algorithm does not require any explicit
feedback from the network, and this makes it easily deployable over
the Internet. We have also performed intensive tests on real network
scenarios with a software prototype, verifying the algorithm
efficiency with different network topologies and traffic patterns
between two SIP PBXs.
The promising results obtained during the experimental validation
of the algorithm are now the basis for the extension towards a larger
set of multimedia services and the integration of our methodology
with existing PBX appliances.
Abstract: Since the 80s huge efforts have been made to utilize
renewable energy sources to generate electric power. This paper
reports some aspects of integration of the distributed generators into
the low voltage distribution networks. An assessment of impact of the
distributed generators on the reliability indices of low voltage
network is performed. Results obtained from case study using low
voltage network, are presented and discussed.
Abstract: A diamond-like carbon (DLC) based solid-lubricant
film was designed and DLC films were successfully prepared using a
microwave plasma enhanced magnetron sputtering deposition
technology. Post-test characterizations including Raman
spectrometry, X-ray diffraction, nano-indentation test, adhesion test,
friction coefficient test were performed to study the influence of
substrate bias voltage on the mechanical properties of the W- and
S-doped DLC films. The results indicated that the W- and S-doped
DLC films also had the typical structure of DLC films and a better
mechanical performance achieved by the application of a substrate
bias of -200V.
Abstract: Optimization of filter banks based on the knowledge of input statistics has been of interest for a long time. Finite impulse response (FIR) Compaction filters are used in the design of optimal signal adapted orthonormal FIR filter banks. In this paper we discuss three different approaches for the design of interpolated finite impulse response (IFIR) compaction filters. In the first method, the magnitude squared response satisfies Nyquist constraint approximately. In the second and third methods Nyquist constraint is exactly satisfied. These methods yield FIR compaction filters whose response is comparable with that of the existing methods. At the same time, IFIR filters enjoy significant saving in the number of multipliers and can be implemented efficiently. Since eigenfilter approach is used here, the method is less complex. Design of IFIR filters in the least square sense is presented.
Abstract: Due to growing environmental concerns of the cement
industry, alternative cement technologies have become an area of
increasing interest. It is now believed that new binders are
indispensable for enhanced environmental and durability
performance. Self-compacting Geopolymer concrete is an innovative
method and improved way of concreting operation that does not
require vibration for placing it and is produced by complete
elimination of ordinary Portland cement.
This paper documents the assessment of the compressive strength
and workability characteristics of low-calcium fly ash based selfcompacting
geopolymer concrete. The essential workability
properties of the freshly prepared Self-compacting Geopolymer
concrete such as filling ability, passing ability and segregation
resistance were evaluated by using Slump flow, V-funnel, L-box and
J-ring test methods. The fundamental requirements of high
flowability and segregation resistance as specified by guidelines on
Self Compacting Concrete by EFNARC were satisfied. In addition,
compressive strength was determined and the test results are included
here. This paper also reports the effect of extra water, curing time and
curing temperature on the compressive strength of self-compacting
geopolymer concrete. The test results show that extra water in the
concrete mix plays a significant role. Also, longer curing time and
curing the concrete specimens at higher temperatures will result in
higher compressive strength.
Abstract: An innovative tri-axes micro-power receiver is
proposed. The tri-axes micro-power receiver consists of two sets 3-D
micro-solenoids and one set planar micro-coils in which iron core is
embedded. The three sets of micro-coils are designed to be orthogonal
to each other. Therefore, no matter which direction the flux is present
along, the magnetic energy can be harvested and transformed into
electric power. Not only dead space of receiving power is mostly
reduced, but also transformation efficiency of electromagnetic energy
to electric power can be efficiently raised. By employing commercial
software, Ansoft Maxwell, the preliminary simulation results verify
that the proposed micro-power receiver can efficiently pick up the
energy transmitted by magnetic power source.
As to the fabrication process, the isotropic etching technique is
employed to micro-machine the inverse-trapezoid fillister so that the
copper wire can be successfully electroplated. The adhesion between
micro-coils and fillister is much enhanced.