Abstract: Power transformers are the most crucial part of power electrical system, distribution and transmission grid. This part is maintained using predictive or condition-based maintenance approach. The diagnosis of power transformer condition is performed based on Dissolved Gas Analysis (DGA). There are five main methods utilized for analyzing these gases. These methods are International Electrotechnical Commission (IEC) gas ratio, Key Gas, Roger gas ratio, Doernenburg, and Duval Triangle. Moreover, due to the importance of the transformers, there is a need for an accurate technique to diagnose and hence predict the transformer condition. The main objective of this technique is to avoid the transformer faults and hence to maintain the power electrical system, distribution and transmission grid. In this paper, the DGA was utilized based on the data collected from the transformer records available in the General Electricity Company of Libya (GECOL) which is located in Benghazi-Libya. The Fuzzy Logic (FL) technique was implemented as a diagnostic approach based on IEC gas ratio method. The FL technique gave better results and approved to be used as an accurate prediction technique for power transformer faults. Also, this technique is approved to be a quite interesting for the readers and the concern researchers in the area of FL mathematics and power transformer.
Abstract: This study investigated the integrated removal of heavy metals, organic matter and nitrogen from landfill leachate using a novel laboratory scale constructed wetland system. The main objectives of this study were: (i) to assess the overall effectiveness of the constructed wetland system for treating landfill leachate; (ii) to examine the interactions and impact of key leachate constituents (heavy metals, organic matter and nitrogen) on the overall removal dynamics and efficiency. The constructed wetland system consisted of four stages operated in tidal flow and anoxic conditions. Results obtained from 215 days of operation have demonstrated extraordinary heavy metals removal up to 100%. Analysis of the physico- chemical data reveal that the controlling factors for metals removal were the anoxic condition and the use of the novel media (dewatered ferric sludge which is a by-product of drinking water treatment process) as the main substrate in the constructed wetland system. Results show that the use of the ferric sludge enhanced heavy metals removal and brought more flexibility to simultaneous nitrification and denitrification which occurs within the microbial flocs. Furthermore, COD and NH4-N were effectively removed in the system and this coincided with enhanced aeration in the 2nd and 3rd stages of the constructed wetland system. Overall, the results demonstrated that the ferric dewatered sludge constructed wetland system would be an effective solution for integrated removal of pollutants from landfill leachates.
Abstract: In the present study, mixed convection in a horizontal
rectangular duct using Al2O3 is numerically investigated. The effects
of different Rayleigh number, Reynolds number and radiation on
flow and heat transfer characteristics are studied in detail. This study
covers Rayleigh number in the range of 2 × 10^6 ≤ Ra ≤ 2 × 10^7 and
Reynolds number in the range of 100 ≤ Re ≤ 1100. Results reveal that
the Nusselt number increases as Reynolds and Rayleigh numbers
increase. It is also found that the dimensionless temperature
distribution increases as Rayleigh number increases.
Abstract: This work assessed some properties of three pedons on a toposequence in Ijah-Gbagyi district in Niger State, Nigeria. The pedons were designated as JG1, JG2 and JG3 representing the upper, middle and lower slopes respectively. The surface soil was characterized by dark yellowish brown (10YR3/4) color at the JG1 and JG2 and very dark grayish brown (10YR3/2) color at JG3. Sand dominated the mineral fraction and its content in the surface horizon decreased down the slope, whereas silt content increased down the slope due to sorting by geological and pedogenic processes. Although organic carbon (OC), total nitrogen (TN) and available phosphorus (P) were rated high, TN and available P decreased down the slope. High cation exchange capacity (CEC) was an indication that the soils have high potential for plant nutrients retention. The pedons were classified as Typic Haplustepts/ Haplic Cambisols (Eutric), Plinthic Petraquepts/ Petric Plinthosols (Abruptic) and Typic Endoaquepts/ Endogleyic Cambisols (Endoclayic).
Abstract: In this study the extracts of the Iraqi herb Tribulus
terrestris (Al-Hassage or Al-Kutub) was done by using of polar and
non polar solvents, then the biological activity of these extractants
was studied in three fields, First, the antibacterial activity (in vitro)
on gram positive bacteria (Staphylococcus aureus), and gram
negative bacteria (E. coli, Proteus vulgaris, Pseudomonas
aerugiuosa, and Klebsiella), all extracts showed considerable activity
against all bacteria. Second, the effect of extracts on free serum
testosterone level in male mice (in vivo), the alcoholic, and
acetonitrilic extracts showed significant (P < 0.05) increase in free
serum testosterone level, and we found that the extracts contained
compounds with less genotoxic effects in mice germ cells. 3rd, was to
study the effect of methanolic extract of T. terrestris in diabetes
management.
Abstract: The present study was carried out to evaluate the
nutritional value of sorghum flour during processing of injera
(unleavened thick bread). The proximate composition of sorghum
flour before and after fermentation and that of injera was determined.
Compared to the raw flour and fermented one, injera had low protein
(11.55%), ash (1.57%) and fat (2.40%) contents but high in fiber
content. Moreover, injera was found to have significantly (P ≤ 0.05)
higher energy (389.08 Kcal/100g) compared to raw and fermented
sorghum flour. Injera contained lower levels of anti-nutritional
factors (polyphenols, phytate and tannins) compared to raw and
fermented sorghum. Also it was found to be rich in Ca
(4.75mg/100g), Fe (3.95 mg/100g), and Cu (0.7 mg/100g) compared
to that of raw and fermented flour. Moreover, both the extractable
minerals and protein digestibility were high for injera due to low
amount of anti-nutrients. Injera was found to contain an appreciable
amount of amino acids except arginine and tyrosine.
Abstract: In this paper, an intelligent algorithm for optimal
document archiving is presented. It is kown that electronic archives
are very important for information system management. Minimizing
the size of the stored data in electronic archive is a main issue to
reduce the physical storage area. Here, the effect of different types of
Arabic fonts on electronic archives size is discussed. Simulation
results show that PDF is the best file format for storage of the Arabic
documents in electronic archive. Furthermore, fast information
detection in a given PDF file is introduced. Such approach uses fast
neural networks (FNNs) implemented in the frequency domain. The
operation of these networks relies on performing cross correlation in
the frequency domain rather than spatial one. It is proved
mathematically and practically that the number of computation steps
required for the presented FNNs is less than that needed by
conventional neural networks (CNNs). Simulation results using
MATLAB confirm the theoretical computations.
Abstract: This paper presents part of a research into the small
scale modelling of masonry. Small scale testing of masonry has been
carried out by many authors, but few have attempted a systematic
determination of the parameters that affect masonry at a small scale.
The effect of increasing mortar strength and different sand gradings
under compression were investigated. The results show masonry
strength at small scale is influenced by increasing mortar strength and
different sand gradings.
Abstract: Analytical procedure was carried out in this paper to
calculate the ultimate load capacity of reinforced concrete corbels
strengthened or repaired externally with CFRP sheets. Strut and tie
method and shear friction method proposed earlier for analyzing
reinforced concrete corbels were modified to incorporate the effect of
external CFRP sheets bonded to the corbel. The points of weakness
of any method that lead to an inaccuracy, especially when
overestimating test results were checked and discussed. Comparison
of prediction with the test data indicates that the ratio of test /
calculated ultimate load is 0.82 and 1.17 using strut and tie method
and shear friction method, respectively. If the limits of maximum
shear stress is followed, the calculated ultimate load capacity using
shear friction method was found to underestimates test data
considerably.
Abstract: In this work we develop an object extraction method
and propose efficient algorithms for object motion characterization.
The set of proposed tools serves as a basis for development of objectbased
functionalities for manipulation of video content. The
estimators by different algorithms are compared in terms of quality
and performance and tested on real video sequences. The proposed
method will be useful for the latest standards of encoding and
description of multimedia content – MPEG4 and MPEG7.
Abstract: This paper investigates experimental and numerical study of the airflow characteristics for vortex, round and square ceiling diffusers and its effect on the thermal comfort in a ventilated room. Three different thermal comfort criteria namely; Mean Age of the Air (MAA), ventilation effectiveness (E), and Effective Draft Temperature (EDT) have been used to predict the thermal comfort zone inside the room. In experimental work, a sub-scale room is set-up to measure the temperature field in the room. In numerical analysis, unstructured grids have been used to discretize the numerical domain. Conservation equations are solved using FLUENT commercial flow solver. The code is validated by comparing the numerical results obtained from three different turbulence models with the available experimental data. The comparison between the various numerical models shows that the standard k-ε turbulence model can be used to simulate these cases successfully. After validation of the code, effect of supply air velocity on the flow and thermal field could be investigated and hence the thermal comfort. The results show that the pressure coefficient created by the square diffuser is 1.5 times greater than that created by the vortex diffuser. The velocity decay coefficient is nearly the same for square and round diffusers and is 2.6 times greater than that for the vortex diffuser.