Abstract: This paper presents a signal analysis process for
improving energy completeness based on the Hilbert-Huang
Transform (HHT). Firstly, the vibration signal of a DC Motor obtained
by employing an accelerometer is the model used to analyze the
signal. Secondly, the intrinsic mode functions (IMFs) and Hilbert
spectrum of the decomposed signal are obtained by applying HHT.
The results of the IMFs constituent and the original signal are
compared and the process of energy loss is discussed. Finally, the
differences between Wavelet Transform (WT) and HHT in analyzing
the signal are compared. The simulated results reveal the analysis
process based on HHT is advantageous for the enhancement of energy
completeness.
Abstract: The anomalous generation of plasma blocks by
interaction of petawatt-picosecond laser pulses permits side-on
ignition of uncompressed solid fusion fuel following an improved
application of the hydrodynamic Chu-model for deuterium-tritium.
The new possibility of side-on laser ignition depends on accelerated
ions and produced ions beams of high energy particles by the
nonlinear ponderomotive force of the laser pulse in the plasma block,
a re-evaluation of the early hydrodynamic analysis for ignition of
inertial fusion by including inhibition factor, collective effect of
stopping power of alpha particles and the energy loss rate
reabsorption to plasma by the protons of plasma blocks being
reduced by about a factor 40.
Abstract: The major part of light weight timber constructions
consists of insulation. Mineral wool is the most commonly used
insulation due to its cost efficiency and easy handling. The fiber
orientation and porosity of this insulation material enables flowthrough.
The air flow resistance is low. If leakage occurs in the
insulated bay section, the convective flow may cause energy losses
and infiltration of the exterior wall with moisture and particles. In
particular the infiltrated moisture may lead to thermal bridges and
growth of health endangering mould and mildew. In order to prevent
this problem, different numerical calculation models have been
developed. All models developed so far have a potential for
completion. The implementation of the flow-through properties of
mineral wool insulation may help to improve the existing models.
Assuming that the real pressure difference between interior and
exterior surface is larger than the prescribed pressure difference in the
standard test procedure for mineral wool ISO 9053 / EN 29053,
measurements were performed using the measurement setup for
research on convective moisture transfer “MSRCMT".
These measurements show, that structural inhomogeneities of
mineral wool effect the permeability only at higher pressure
differences, as applied in MSRCMT. Additional microscopic
investigations show, that the location of a leak within the
construction has a crucial influence on the air flow-through and the
infiltration rate. The results clearly indicate that the empirical values
for the acoustic resistance of mineral wool should not be used for the
calculation of convective transfer mechanisms.
Abstract: Solar Cells are destined to supply electric energy beginning from primary resources. It can charge a battery up to 12V dc. For residential use an inverter for 12V dc to 220Vac conversion is desired. For this a static DC-AC converter is necessarily inserted between the solar cells and the distribution network. This paper describes a new P.W.M. strategy for a voltage source inverter. This modulation strategy reduces the energy losses and harmonics in the P.W.M. voltage source inverter. This technique allows the P.W.M. voltage source inverter to become a new feasible solution for solar home application.