Abstract: Quality control charts are very effective in detecting
out of control signals but when a control chart signals an out of
control condition of the process mean, searching for a special cause
in the vicinity of the signal time would not always lead to prompt
identification of the source(s) of the out of control condition as the
change point in the process parameter(s) is usually different from the
signal time. It is very important to manufacturer to determine at what
point and which parameters in the past caused the signal. Early
warning of process change would expedite the search for the special
causes and enhance quality at lower cost. In this paper the quality
variables under investigation are assumed to follow a multivariate
normal distribution with known means and variance-covariance
matrix and the process means after one step change remain at the new
level until the special cause is being identified and removed, also it is
supposed that only one variable could be changed at the same time.
This research applies artificial neural network (ANN) to identify the
time the change occurred and the parameter which caused the change
or shift. The performance of the approach was assessed through a
computer simulation experiment. The results show that neural
network performs effectively and equally well for the whole shift
magnitude which has been considered.
Abstract: Image convolution similar to the receptive fields
found in mammalian visual pathways has long been used in
conventional image processing in the form of Gabor masks.
However, no VLSI implementation of parallel, multi-layered pulsed
processing has been brought forward which would emulate this
property. We present a technical realization of such a pulsed image
processing scheme. The discussed IC also serves as a general testbed
for VLSI-based pulsed information processing, which is of interest
especially with regard to the robustness of representing an analog
signal in the phase or duration of a pulsed, quasi-digital signal, as
well as the possibility of direct digital manipulation of such an
analog signal. The network connectivity and processing properties
are reconfigurable so as to allow adaptation to various processing
tasks.
Abstract: The purpose of this study was to explore the
relationship between Burnout, Negative Affectivity, and
Organizational Citizenship Behavior (OCB) for social service
workers at two agencies serving homeless populations. Thirty two
subjects completed surveys. Significant correlations between major
variables and subscales were found.
Abstract: Automatic segmentation of skin lesions is the first step
towards development of a computer-aided diagnosis of melanoma.
Although numerous segmentation methods have been developed,
few studies have focused on determining the most discriminative
and effective color space for melanoma application. This paper
proposes a novel automatic segmentation algorithm using color space
analysis and clustering-based histogram thresholding, which is able to
determine the optimal color channel for segmentation of skin lesions.
To demonstrate the validity of the algorithm, it is tested on a set of 30
high resolution dermoscopy images and a comprehensive evaluation
of the results is provided, where borders manually drawn by four
dermatologists, are compared to automated borders detected by the
proposed algorithm. The evaluation is carried out by applying three
previously used metrics of accuracy, sensitivity, and specificity and
a new metric of similarity. Through ROC analysis and ranking the
metrics, it is shown that the best results are obtained with the X and
XoYoR color channels which results in an accuracy of approximately
97%. The proposed method is also compared with two state-ofthe-
art skin lesion segmentation methods, which demonstrates the
effectiveness and superiority of the proposed segmentation method.
Abstract: A human verification system is presented in this
paper. The system consists of several steps: background subtraction,
thresholding, line connection, region growing, morphlogy, star
skelatonization, feature extraction, feature matching, and decision
making. The proposed system combines an advantage of star
skeletonization and simple statistic features. A correlation matching
and probability voting have been used for verification, followed by a
logical operation in a decision making stage. The proposed system
uses small number of features and the system reliability is
convincing.
Abstract: Several models have been introduced so far for single
electron box, SEB, which all of them were restricted to DC response
and or low temperature limit. In this paper we introduce a new time
dependent, high temperature analytical model for SEB for the first
time. DC behavior of the introduced model will be verified against
SIMON software and its time behavior will be verified against a
newly published paper regarding step response of SEB.
Abstract: Lanthanum oxide is to be recovered from monazite,
which contains about 13.44% lanthanum oxide. The principal
objective of this study is to be able to extract lanthanum oxide from
monazite of Moemeik Myitsone Area. The treatment of monazite in
this study involves three main steps; extraction of lanthanum
hydroxide from monazite by using caustic soda, digestion with nitric
acid and precipitation with ammonium hydroxide and calcination of
lanthanum oxalate to lanthanum oxide.
Abstract: Recently, Cassava has been the driving force of many
developing countries- economic progress. To attain this level,
prerequisites were put in place enabling cassava sector to become an
industrial and a highly competitive crop. Cameroon can achieve the
same results. Moreover, it can upgrade the living conditions of both
rural and urban dwellers and stimulate the development of the whole
economy. Achieving this outcome calls for agricultural policy
reforms. The adoption and implementation of adequate policies go
along with efficient strategies. To choose effective strategies, an indepth
investigation of the sector-s problems is highly recommended.
This paper uses gap analysis method to evaluate cassava sector in
Cameroon. It studies the present situation (where it is now),
interrogates the future (where it should be) and finally proposes
solutions to fill the gap.
Abstract: Detection of incipient abnormal events is important to
improve safety and reliability of machine operations and reduce losses
caused by failures. Improper set-ups or aligning of parts often leads to
severe problems in many machines. The construction of prediction
models for predicting faulty conditions is quite essential in making
decisions on when to perform machine maintenance. This paper
presents a multivariate calibration monitoring approach based on the
statistical analysis of machine measurement data. The calibration
model is used to predict two faulty conditions from historical reference
data. This approach utilizes genetic algorithms (GA) based variable
selection, and we evaluate the predictive performance of several
prediction methods using real data. The results shows that the
calibration model based on supervised probabilistic principal
component analysis (SPPCA) yielded best performance in this work.
By adopting a proper variable selection scheme in calibration models,
the prediction performance can be improved by excluding
non-informative variables from their model building steps.
Abstract: This article proposes an Ant Colony Optimization
(ACO) metaheuristic to minimize total makespan for scheduling a set
of jobs and assign workers for uniformly related parallel machines.
An algorithm based on ACO has been developed and coded on a
computer program Matlab®, to solve this problem. The paper
explains various steps to apply Ant Colony approach to the problem
of minimizing makespan for the worker assignment & jobs
scheduling problem in a parallel machine model and is aimed at
evaluating the strength of ACO as compared to other conventional
approaches. One data set containing 100 problems (12 Jobs, 03
machines and 10 workers) which is available on internet, has been
taken and solved through this ACO algorithm. The results of our
ACO based algorithm has shown drastically improved results,
especially, in terms of negligible computational effort of CPU, to
reach the optimal solution. In our case, the time taken to solve all 100
problems is even lesser than the average time taken to solve one
problem in the data set by other conventional approaches like GA
algorithm and SPT-A/LMC heuristics.
Abstract: Falls are the primary cause of accidents in people over
the age of 65, and frequently lead to serious injuries. Since the early
detection of falls is an important step to alert and protect the aging
population, a variety of research on detecting falls was carried out
including the use of accelerators, gyroscopes and tilt sensors. In
exiting studies, falls were detected using an accelerometer with
errors. In this study, the proposed method for detecting falls was to
use two accelerometers to reject wrong falls detection. As falls are
accompanied by the acceleration of gravity and rotational motion, the
falls in this study were detected by using the z-axial acceleration
differences between two sites. The falls were detected by calculating
the difference between the analyses of accelerometers placed on two
different positions on the chest of the subject. The parameters of the
maximum difference of accelerations (diff_Z) and the integration of
accelerations in a defined region (Sum_diff_Z) were used to form the
fall detection algorithm. The falls and the activities of daily living
(ADL) could be distinguished by using the proposed parameters
without errors in spite of the impact and the change in the positions
of the accelerometers. By comparing each of the axial accelerations,
the directions of falls and the condition of the subject afterwards
could be determined.In this study, by using two accelerometers
without errors attached to two sites to detect falls, the usefulness of
the proposed fall detection algorithm parameters, diff_Z and
Sum_diff_Z, were confirmed.
Abstract: We consider the development of an eight order Adam-s
type method, with A-stability property discussed by expressing them
as a one-step method in higher dimension. This makes it suitable
for solving variety of initial-value problems. The main method and
additional methods are obtained from the same continuous scheme
derived via interpolation and collocation procedures. The methods
are then applied in block form as simultaneous numerical integrators
over non-overlapping intervals. Numerical results obtained using the
proposed block form reveals that it is highly competitive with existing
methods in the literature.
Abstract: Rapid enlargement and physical development of cities
have facilitated the emergence of a number of city life crises and
decrease of environment quality. Subsequently, the need for noticing
the concept of quality and its improvement in urban environments,
besides quantitative issues, is obviously recognized. In the domain of
urban ideas the importance of taking these issues into consideration
is obvious not only in accordance to sustainable development
concepts and improvement of public environment quality, but also in
the enhancement of social and behavioral models.
The major concern of present article is to study the nature of urban
environment quality in urban development plans, which is important
not only in the concept and the aim of projects but also in their
execution procedure. As a result, this paper is going to utilize
planning capacities caused by environmental virtues in the planning
procedure of Moft Abad neighborhood. Thus, at the first step,
applying the Analytical Hierarchy Process (AHP), it has assessed
quantitative environmental issues. The present conditions of Moft
Abad state that “the neighborhood is generally suffering from the
lack of qualitative parameters, and the previously formed planning
procedures could not take the sustainable and developmental paths
which are aimed at environment quality virtues." The diminution of
economical and environmental virtues has resulted in the diminution
of residential and social virtues. Therefore, in order to enhance the
environment quality in Moft Abad, the present paper has tried to
supply the subject plans in order to make a safe, healthy, and lively
neighborhood.
Abstract: In the past years a lot of effort has been made in the
field of face detection. The human face contains important features
that can be used by vision-based automated systems in order to
identify and recognize individuals. Face location, the primary step of
the vision-based automated systems, finds the face area in the input
image. An accurate location of the face is still a challenging task.
Viola-Jones framework has been widely used by researchers in order
to detect the location of faces and objects in a given image. Face
detection classifiers are shared by public communities, such as
OpenCV. An evaluation of these classifiers will help researchers to
choose the best classifier for their particular need. This work focuses
of the evaluation of face detection classifiers minding facial
landmarks.
Abstract: Multi-residue analysis method for penicillins was
developed and validated in bovine muscle, chicken, milk, and flatfish.
Detection was based on liquid chromatography tandem mass
spectrometry (LC/MS/MS). The developed method was validated for
specificity, precision, recovery, and linearity. The analytes were
extracted with 80% acetonitrile and clean-up by a single
reversed-phase solid-phase extraction step. Six penicillins presented
recoveries higher than 76% with the exception of Amoxicillin
(59.7%). Relative standard deviations (RSDs) were not more than
10%. LOQs values ranged from 0.1 and to 4.5 ug/kg. The method was
applied to 128 real samples. Benzylpenicillin was detected in 15
samples and Cloxacillin was detected in 7 samples. Oxacillin was
detected in 2 samples. But the detected levels were under the MRL
levels for penicillins in samples.
Abstract: Optimal reactive power flow is an optimization problem
with one or more objective of minimizing the active power losses for
fixed generation schedule. The control variables are generator bus
voltages, transformer tap settings and reactive power output of the
compensating devices placed on different bus bars. Biogeography-
Based Optimization (BBO) technique has been applied to solve
different kinds of optimal reactive power flow problems subject
to operational constraints like power balance constraint, line flow
and bus voltages limits etc. BBO searches for the global optimum
mainly through two steps: Migration and Mutation. In the present
work, BBO has been applied to solve the optimal reactive power
flow problems on IEEE 30-bus and standard IEEE 57-bus power
systems for minimization of active power loss. The superiority of the
proposed method has been demonstrated. Considering the quality of
the solution obtained, the proposed method seems to be a promising
one for solving these problems.
Abstract: A 7-step method (with 25 sub-steps) to assess risk of
air pollutants is introduced. These steps are: pre-considerations,
sampling, statistical analysis, exposure matrix and likelihood, doseresponse
matrix and likelihood, total risk evaluation, and discussion
of findings. All mentioned words and expressions are wellunderstood;
however, almost all steps have been modified, improved,
and coupled in such a way that a comprehensive method has been
prepared. Accordingly, the SADRA (Statistical Analysis-Driven Risk
Assessment) emphasizes extensive and ongoing application of
analytical statistics in traditional risk assessment models. A Sulfur
Dioxide case study validates the claim and provides a good
illustration for this method.
Abstract: A numerical study on the influence of electroosmotic flow on analyte preconcentration by isotachophoresis ( ITP) is made. We consider that the double layer induced electroosmotic flow ( EOF) counterbalance the electrophoretic velocity and a stationary ITP stacked zones results. We solve the Navier-Stokes equations coupled with the Nernst-Planck equations to determine the local convective velocity and the preconcentration dynamics of ions. Our numerical algorithm is based on a finite volume method along with a secondorder upwind scheme. The present numerical algorithm can capture the the sharp boundaries of step-changes ( plateau mode) or zones of steep gradients ( peak mode) accurately. The convection of ions due to EOF reduces the resolution of the ITP transition zones and produces a dispersion in analyte zones. The role of the electrokinetic parameters which induces dispersion is analyzed. A one-dimensional model for the area-averaged concentrations based on the Taylor-Aristype effective diffusivity is found to be in good agreement with the computed solutions.
Abstract: A one-step conservative level set method, combined with a global mass correction method, is developed in this study to simulate the incompressible two-phase flows. The present framework do not need to solve the conservative level set scheme at two separated steps, and the global mass can be exactly conserved. The present method is then more efficient than two-step conservative level set scheme. The dispersion-relation-preserving schemes are utilized for the advection terms. The pressure Poisson equation solver is applied to GPU computation using the pCDR library developed by National Center for High-Performance Computing, Taiwan. The SMP parallelization is used to accelerate the rest of calculations. Three benchmark problems were done for the performance evaluation. Good agreements with the referenced solutions are demonstrated for all the investigated problems.
Abstract: Previous studies mass evacuation route network does
not fully reflect the step-by-step behavior and evacuees make routing
decisions. Therefore, they do not work as expected when applied to the
evacuation route planning is valid. This article describes where
evacuees may have to make a direction to select all areas were
identified as guiding points to improve evacuation routes network.
This improved route network can be used as a basis for the layout can
be used to guide the signs indicate that provides the required
evacuation direction. This article also describes that combines
simulation and artificial bee colony algorithm to provide the proposed
routing solutions, to plan an integrated routing mode. The improved
network and the model used is the cinema as a case study to assess the
floor. The effectiveness of guidance solution in the total evacuation
time is significant by verification.