Abstract: The various applications of VLSI circuits in highperformance
computing, telecommunications, and consumer
electronics has been expanding progressively, and at a very hasty
pace. This paper describes a new model for partitioning a circuit
using DBSCAN and fuzzy ARTMAP neural network. The first step
is concerned with feature extraction, where we had make use
DBSCAN algorithm. The second step is the classification and is
composed of a fuzzy ARTMAP neural network. The performance of
both approaches is compared using benchmark data provided by
MCNC standard cell placement benchmark netlists. Analysis of the
investigational results proved that the fuzzy ARTMAP with
DBSCAN model achieves greater performance then only fuzzy
ARTMAP in recognizing sub-circuits with lowest amount of
interconnections between them The recognition rate using fuzzy
ARTMAP with DBSCAN is 97.7% compared to only fuzzy
ARTMAP.
Abstract: The comparisons of two typical fluidic thrust vectoring exhaust nozzles including two-dimensional(2-D) nozzle and axisymmetric nozzle on aerodynamic characteristics was presented by numerical simulation. The results show: the thrust vector angles increased with the increasing secondary flow but decreased with the nozzle pressure ratio (NPR) increasing. With the same secondary flow and NPR, the thrust vector angles of 2-D nozzle were higher than the axisymmetric nozzle-s. So with the lower NPR and more secondary weight flow, the much higher thrust vector angle was caused by 2-D fluidic nozzle. And with the higher NPR and less secondary weight flow, there was not much difference in angular dimension between two nozzles.
Abstract: The events of October 2010, where terrorists managed to get explosive devices onboard of three passenger aircrafts and two air freighters, demonstrated weaknesses of the international air cargo and airmail security. Ever since, postal security has gained interest among policymakers and authorities. This study augments the limited body of academic literature on the topic bydemarcating areas of postal security, identifying relevant stakeholders in each area, and investigating why these stakeholders engage in postal security. Research is based on a case study on Swiss Post’s mail service.
Abstract: Factor analysis was applied to two stages biogas
production from banana stem waste allowing a screening of the
experimental variables second stage temperature (T), organic loading
rates (OLR) and hydraulic retention times (HRT). Biogas production
was found to be strongly influenced by all the above experimental
variables. Results from factorial analysis have shown that all
variables which were HRT, OLR and T have significant effect to
biogas production. Increased in HRT and OLR could increased the
biogas yield. The performance was tested under the conditions of
various T (35oC-60oC), OLR (0.3 g TS/l.d–1.9 gTS/l.d), and HRT (3
d–15 d). Conditions for temperature, OLR and HRT in this study
were based on the best range obtained from literature review.
Abstract: Group key management is an important functional
building block for any secure multicast architecture.
Thereby, it has been extensively studied in the literature.
In this paper we present relevant group key management
protocols. Then, we compare them against some pertinent
performance criteria.
Abstract: In this paper the development of a software to
encrypt messages with asymmetric cryptography is presented. In
particular, is used the RSA (Rivest, Shamir and Adleman) algorithm
to encrypt alphanumeric information. The software allows to
generate different public keys from two prime numbers provided by
the user, the user must then select a public-key to generate the
corresponding private-key. To encrypt the information, the user must
provide the public-key of the recipient as well as the message to be
encrypted. The generated ciphertext can be sent through an insecure
channel, so that would be very difficult to be interpreted by an
intruder or attacker. At the end of the communication, the recipient
can decrypt the original message if provide his/her public-key and
his/her corresponding private-key.
Abstract: Human Resource (HR) applications can be used to
provide fair and consistent decisions, and to improve the
effectiveness of decision making processes. Besides that, among
the challenge for HR professionals is to manage organization
talents, especially to ensure the right person for the right job at the
right time. For that reason, in this article, we attempt to describe
the potential to implement one of the talent management tasks i.e.
identifying existing talent by predicting their performance as one of
HR application for talent management. This study suggests the
potential HR system architecture for talent forecasting by using
past experience knowledge known as Knowledge Discovery in
Database (KDD) or Data Mining. This article consists of three
main parts; the first part deals with the overview of HR
applications, the prediction techniques and application, the general
view of Data mining and the basic concept of talent management
in HRM. The second part is to understand the use of Data Mining
technique in order to solve one of the talent management tasks, and
the third part is to propose the potential HR system architecture for
talent forecasting.
Abstract: SIP (Session Initiation Protocol), using HTML based
call control messaging which is quite simple and efficient, is being
replaced for VoIP networks recently. As for authentication and
authorization purposes there are many approaches and considerations
for securing SIP to eliminate forgery on the integrity of SIP
messages. On the other hand Elliptic Curve Cryptography has
significant advantages like smaller key sizes, faster computations on
behalf of other Public Key Cryptography (PKC) systems that obtain
data transmission more secure and efficient. In this work a new
approach is proposed for secure SIP authentication by using a public
key exchange mechanism using ECC. Total execution times and
memory requirements of proposed scheme have been improved in
comparison with non-elliptic approaches by adopting elliptic-based
key exchange mechanism.
Abstract: Mixed-traffic (e.g., pedestrians, bicycles, and vehicles)
data at an intersection is one of the essential factors for intersection
design and traffic control. However, some data such as pedestrian
volume cannot be directly collected by common detectors (e.g.
inductive loop, sonar and microwave sensors). In this paper, a video
based detection algorithm is proposed for mixed-traffic data collection
at intersections using surveillance cameras. The algorithm is derived
from Gaussian Mixture Model (GMM), and uses a mergence time
adjustment scheme to improve the traditional algorithm. Real-world
video data were selected to test the algorithm. The results show that
the proposed algorithm has the faster processing speed and more
accuracy than the traditional algorithm. This indicates that the
improved algorithm can be applied to detect mixed-traffic at
signalized intersection, even when conflicts occur.
Abstract: Despite extensive study on wireless sensor network
security, defending internal attacks and finding abnormal behaviour
of the sensor are still difficult and unsolved task. The conventional
cryptographic technique does not give the robust security or detection
process to save the network from internal attacker that cause by
abnormal behavior. The insider attacker or abnormally behaved
sensor identificationand location detection framework using false
massage detection and Time difference of Arrival (TDoA) is
presented in this paper. It has been shown that the new framework
can efficiently identify and detect the insider attacker location so that
the attacker can be reprogrammed or subside from the network to
save from internal attack.
Abstract: Ten simply supported grossly underreinforced
tapered concrete beams of full size were tested upto complete
collapse under flexural effect .Out of 10 beams, 5 beams were
nonfibrous and the remaining beams contained fibres. The beams
had a variation in the tapered angle as 2°, 4°, 6°, 8° and 10°. The
concrete mix, conventional steel and the type of fibre used were
held constant. Flat corrugated steel fibres were utilized as
secondary reinforcement. The strength and stability parameters
were measured. It is established that the fibrous tapered beams can
be used economically in earthquake prone areas.
Abstract: The use of neural networks is popular in various
building applications such as prediction of heating load, ventilation
rate and indoor temperature. Significant is, that only few papers deal
with indoor carbon dioxide (CO2) prediction which is a very good
indicator of indoor air quality (IAQ). In this study, a data-driven
modelling method based on multilayer perceptron network for indoor
air carbon dioxide in an apartment building is developed.
Temperature and humidity measurements are used as input variables
to the network. Motivation for this study derives from the following
issues. First, measuring carbon dioxide is expensive and sensors
power consumptions is high and secondly, this leads to short
operating times of battery-powered sensors. The results show that
predicting CO2 concentration based on relative humidity and
temperature measurements, is difficult. Therefore, more additional
information is needed.
Abstract: Recently, the RFID (Radio Frequency
Identification) technology attracts the world market attention as
essential technology for ubiquitous environment. The RFID
market has focused on transponders and reader development.
But that concern has shifted to RFID software like as
high-valued e-business applications, RFID middleware and
related development tools. However, due to the high sensitivity
of data and service transaction within the RFID network,
security consideration must be addressed. In order to guarantee
trusted e-business based on RFID technology, we propose a
security enhanced RFID middleware system. Our proposal is
compliant with EPCglobal ALE (Application Level Events),
which is standard interface for middleware and its clients. We
show how to provide strengthened security and trust by
protecting transported data between middleware and its client,
and stored data in middleware. Moreover, we achieve the
identification and service access control against illegal service
abuse. Our system enables secure RFID middleware service
and trusted e-business service.
Abstract: The problem of frequent itemset mining is considered in this paper. One new technique proposed to generate frequent patterns in large databases without time-consuming candidate generation. This technique is based on focusing on transaction instead of concentrating on itemset. This algorithm based on take intersection between one transaction and others transaction and the maximum shared items between transactions computed instead of creating itemset and computing their frequency. With applying real life transactions and some consumption is taken from real life data, the significant efficiency acquire from databases in generation association rules mining.
Abstract: A comprehensive discussion of feasible strategies for sustainable energy supply is urgently needed to achieve a turnaround of the current energy situation. The necessary fundamentals required for the development of a long term energy vision are lacking to a great extent due to the absence of reasonable long term scenarios that fulfill the requirements of climate protection and sustainable energy use. The contribution of the study is based on a search for sustainable energy paths in the long run for Austria. The analysis makes use of secondary data predominantly. The measures developed to avoid CO2 emissions and other ecological risk factors vary to a great extent among all economic sectors. This is shown by the calculation of CO2 cost of abatement curves. In this study it is demonstrated that the most effective technical measures with the lowest CO2 abatement costs yield solutions to the current energy problems. Various scenarios are presented concerning the question how the technological and environmental options for a sustainable energy system for Austria could look like in the long run. It is shown how sustainable energy can be supplied even with today-s technological knowledge and options available. The scenarios developed include an evaluation of the economic costs and ecological impacts. The results are not only applicable to Austria but demonstrate feasible and cost efficient ways towards a sustainable future.
Abstract: The number of intrusions and attacks against critical
infrastructures and other information networks is increasing rapidly.
While there is no identified evidence that terrorist organizations are
currently planning a coordinated attack against the vulnerabilities of
computer systems and network connected to critical infrastructure,
and origins of the indiscriminate cyber attacks that infect computers
on network remain largely unknown. The growing trend toward the
use of more automated and menacing attack tools has also
overwhelmed some of the current methodologies used for tracking
cyber attacks. There is an ample possibility that this kind of cyber
attacks can be transform to cyberterrorism caused by illegal purposes.
Cyberterrorism is a matter of vital importance to national welfare.
Therefore, each countries and organizations have to take a proper
measure to meet the situation and consider effective legislation about
cyberterrorism.
Abstract: Ferroresonance is an electrical phenomenon in
nonlinear character, which frequently occurs in power system due to
transmission line faults and single or more-phase switching on the
lines as well as usage of the saturable transformers. In this study, the
ferroresonance phenomena are investigated under the modeling of the
West Anatolian Electric Power Network of 380 kV in Turkey. The
ferroresonance event is observed as a result of removing the loads at
the end of the lines. In this sense, two different cases are considered.
At first, the switching is applied at 2nd second and the ferroresonance
affects are observed between 2nd and 4th seconds in the voltage
variations of the phase-R. Hence the ferroresonance and nonferroresonance
parts of the overall data are compared with each
others using the Fourier transform techniques to show the
ferroresonance affects.
Abstract: In this era of competitiveness, there is a growing need for supply chains also to become competitive enough to handle pressures like varying customer’s expectations, low cost high quality products to be delivered at the minimum time and the most important is throat cutting competition at world wide scale. In the recent years, supply chain competitiveness has been, therefore, accepted as one of the most important philosophies in the supply chain literature. Various researchers and practitioners have tried to identify and implement strategies in supply chains which can bring competitiveness in the supply chains i.e. supply chain competitiveness. The purpose of this paper is to suggest select strategies for supply chain competitiveness in the Indian manufacturing sector using an integrated approach of literature review and exploratory interviews with eminent professionals from the supply chain area in various industries, academia and research. The aim of the paper is to highlight the important area of competitiveness in the supply chain and to suggest recommendations to the industry and managers of manufacturing sector.
Abstract: Most of the losses in a power system relate to
the distribution sector which always has been considered.
From the important factors which contribute to increase losses
in the distribution system is the existence of radioactive flows.
The most common way to compensate the radioactive power
in the system is the power to use parallel capacitors. In
addition to reducing the losses, the advantages of capacitor
placement are the reduction of the losses in the release peak of
network capacity and improving the voltage profile. The point
which should be considered in capacitor placement is the
optimal placement and specification of the amount of the
capacitor in order to maximize the advantages of capacitor
placement.
In this paper, a new technique has been offered for the
placement and the specification of the amount of the constant
capacitors in the radius distribution network on the basis of
Genetic Algorithm (GA). The existing optimal methods for
capacitor placement are mostly including those which reduce
the losses and voltage profile simultaneously. But the
retaliation cost and load changes have not been considered as
influential UN the target function .In this article, a holistic
approach has been considered for the optimal response to this
problem which includes all the parameters in the distribution
network: The price of the phase voltage and load changes. So,
a vast inquiry is required for all the possible responses. So, in
this article, we use Genetic Algorithm (GA) as the most
powerful method for optimal inquiry.
Abstract: Currently, there has been a 3G mobile networks data
traffic explosion due to the large increase in the number of smartphone
users. Unlike a traditional wired infrastructure, 3G mobile networks
have limited wireless resources and signaling procedures for complex
wireless resource management. And mobile network security for
various abnormal and malicious traffic technologies was not ready. So
Malicious or potentially malicious traffic originating from mobile
malware infected smart devices can cause serious problems to the 3G
mobile networks, such as DoS and scanning attack in wired networks.
This paper describes the DoS security threat in the 3G mobile network
and proposes a detection technology.