Abstract: Building inspection is one of the key components of building maintenance. The primary purpose of performing a building inspection is to evaluate the building-s condition. Without inspection, it is difficult to determine a built asset-s current condition, so failure to inspect can contribute to the asset-s future failure. Traditionally, a longhand survey description has been widely used for property condition reports. Surveys that employ ratings instead of descriptions are gaining wide acceptance in the industry because they cater to the need for numerical analysis output. These kinds of surveys are also in keeping with the new RICS HomeBuyer Report 2009. In this paper, we propose a new assessment method, derived from the current rating systems, for assessing the specifically smart school building-s condition and rating the seriousness of each defect identified. These two assessment criteria are then multiplied to find the building-s score, which we called the Condition Survey Protocol (CSP) 1 Matrix. Instead of a longhand description of a building-s defects, this matrix requires concise explanations about the defects identified, thus saving on-site time during a smart school building inspection. The full score is used to give the building an overall rating: Good, Fair or Dilapidated.
Abstract: The stability characteristics of water lubricated journal bearings having three axial grooves are obtained theoretically. In this lubricant (water) is fed under pressure from one end of the bearing, through the 3-axial grooves (groove angles may vary). These bearings can use the process fluid as the lubricant, as in the case of feed water pumps. The Reynolds equation is solved numerically by the finite difference method satisfying the boundary conditions. The stiffness and damping coefficient for various bearing number and eccentricity ratios, assuming linear pressure drop along the groove, shows that smaller groove angles better results.
Abstract: The recommendation of the committee on corporate
governance for public companies in Nigeria, that the position of the
CEO be separated from board chair has generated serious debate
among scholars and practitioners. They have questioned the
appropriateness of implementing corporate governance model that is
based on Anglo-Saxon agency problem characterized by dispersed
ownership structure; where markets for corporate control, legal
regulation, and contractual incentives are the key governance
mechanisms. This paper strives to resolve the argument by adopting
an institutional perspective in testing the agency theory on board
duality. The study developed a theoretical and empirical model to
better understand how ownership structure influences agency conflict
and how such affects firm performance. Hence, the study examines
the relationship between CEO duality and firm performance using
two institutional ownership structures – dispersed ownership and
concentrated ownership structures. The empirical results show that
CEO duality is negatively correlated with firm performance in
Nigeria irrespective of the firm-s ownership structure. The findings
give credence to the recommendation of the Peterside Commission
on the need to separate the position of CEO from board chair.
Abstract: Mathematical models can be used to describe the
dynamics of the spread of infectious disease between susceptibles
and infectious populations. Dengue fever is a re-emerging disease in
the tropical and subtropical regions of the world. Its incidence has
increased fourfold since 1970 and outbreaks are now reported quite
frequently from many parts of the world. In dengue endemic regions,
more cases of dengue infection in pregnancy and infancy are being
found due to the increasing incidence. It has been reported that
dengue infection was vertically transmitted to the infants. Primary
dengue infection is associated with mild to high fever, headache,
muscle pain and skin rash. Immune response includes IgM antibodies
produced by the 5th day of symptoms and persist for 30-60 days. IgG
antibodies appear on the 14th day and persist for life. Secondary
infections often result in high fever and in many cases with
hemorrhagic events and circulatory failure. In the present paper, a
mathematical model is proposed to simulate the succession of dengue
disease transmission in pregnancy and infancy. Stability analysis of
the equilibrium points is carried out and a simulation is given for the
different sets of parameter. Moreover, the bifurcation diagrams of our
model are discussed. The controlling of this disease in infant cases is
introduced in the term of the threshold condition.
Abstract: The two agro-ecological zones became the focus of
the study because of violent nature of the incessant conflict in the
zones. The available register of farmers association was the sampling
frame work where ten percent (61) farmers per state were randomly
sampled. Data were collected and analysed using z-test. The research
findings revealed tree crops and grains production enterprises ranked
higher in Osun (rain fed zones) and Taraba states (savannah zones)
respectively. Osun state entrepreneur felt the effect of the conflict on
their enterprises more than Tarba state. The reasons adduced for
severity of the conflict on enterprises are majority (77.0%) migrated
and (75.5%) of them were not allowed to enter their farms during and
when conflict deescalated unlike situation in Taraba state. The
different in enterprises production level between the two agroecological
zone was statistically significant at p
Abstract: Carriers scattering in the inversion channel of n-
MOSFET dominates the drain current. This paper presents an effective
electron mobility model for the pocket implanted nano scale
n-MOSFET. The model is developed by using two linear pocket
profiles at the source and drain edges. The channel is divided into
three regions at source, drain and central part of the channel region.
The total number of inversion layer charges is found for these three
regions by numerical integration from source to drain ends and the
number of depletion layer charges is found by using the effective
doping concentration including pocket doping effects. These two
charges are then used to find the effective normal electric field,
which is used to find the effective mobility model incorporating the
three scattering mechanisms, such as, Coulomb, phonon and surface
roughness scatterings as well as the ballistic phenomena for the
pocket implanted nano-scale n-MOSFET. The simulation results show
that the derived mobility model produces the same results as found
in the literatures.
Abstract: The spreading characteristics of acoustically excited
swirling double-concentric jets were studied experimentally. The
central jet was acoustically excited at low and high pulsation
intensities. A smoke wire flow visualization and a hot-wire
anemometer velocity measurement results show that excitation forces
a vortex ring to roll-up from the edge of the central tube during each
excitation period. At low pulsation intensities, the vortex ring evolves
downstream, and eventually breaks up into turbulent eddies. At high
pulsation intensities, the primary vortex ring evolves and a series of
trailing vortex rings form during the same period of excitation. The
trailing vortex rings accelerate while evolving downstream and
overtake the primary vortex ring within the same cycle. In the
process, the primary vortex ring becomes unstable and breaks up
early. The effect of the fast traveling trailing vortex rings combined
with the swirl motion of the annular flow improve jet spreading
compared with the naturally evolving jets.
Abstract: Low-carbon economy means the energy conservation and emission reduction. How to measure and evaluate the regional low-carbon economy is an important problem which should be solved immediately. This paper proposed the eco-efficiency ratio based on the ecological efficiency to evaluate the current situation of the low-carbon economy in Jiangsu province and to analyze the efficiency of the low-carbon economy in Jiangsu and other provinces, compared both advantages and disadvantages. And then this paper put forward some advices for the government to formulate the correct development policy of low-carbon economy, to improve the technology innovation capacity and the efficiency of resource allocation.
Abstract: Propranolol is worldwide hypertension drug that is active in S-isomer. Patients must use this drug throughout their lives, and this action employsa significant level of expenditure. A simpler synthesis and lower cost can reduce the price for the patient. A sis pathway of S-propranolol starting from protection of (R,S)-propranolol with di-t-butyldicarbonate and then the product is oxidized with pyridiniumchlorochromate. The selective reduction of ketone occurrs with sodiumborohydride in the presence of metal chloride provided S-propranolol.
Abstract: A novel low-cost flight simulator with the development
goals cost effectiveness and high performance has been realized for
meeting the huge pilot training needs of airlines. The simulator
consists of an aircraft dynamics model, a sophisticated designed
low-profile electrical driven motion system with a subsided cabin, a
mixed reality based semi-virtual cockpit system, a control loading
system and some other subsystems. It shows its advantages over
traditional flight simulator by its features achieved with open
architecture, software solutions and low-cost hardware.
Abstract: Along with increasing development of generation of supersonic planes especially fighters and request for increasing the performance and maneuverability scientists and engineers suggested the delta and double delta wing design. One of the areas which was necessary to be researched, was the Aerodynamic review of this type of wings in high angles of attack at low speeds that was very important in landing and takeoff the planes and maneuvers. Leading Edges of the wings,cause the separation flow from wing surface and then formation of powerful vortex with high rotational speed which studing the mechanism and location of formation and also the position of the vortex breakdown in high angles of attack is very important. In this research, a double delta wing with 76o/45o sweep angles at high angle of attack in steady state and incompressible flow were numerically analyzed with Fluent software. With analaysis of the numerical results, we arrived the most important characteristic of the double delta wings which is keeping of lift at high angles of attacks.
Abstract: To understand the seismic behavior of the offshore
structures, the dynamic interaction of the water-structure-soil should
be assessed. In this regard the role of the water dynamic properties in
magnifying or reducing of the effects of earthquake induced motions
on offshore structures haven't been investigated in precise manner in
available literature. In this paper the sea water level fluctuations
effects on the seismic behavior of a sample of offshore structures has
been investigated by emphasizing on the water-structure interaction
phenomenon. For this purpose a two dimensional finite element
model of offshore structures as well as surrounded water has been
developed using ANSYS software. The effect of soil interaction with
embedded pile foundation has been imposed by using a series of
nonlinear springs in horizontal and vertical directions in soil-piles
contact points. In the model, the earthquake induced motions have
been applied on springs and consequently the motions propagated
upward to the structure and surrounded water. As a result of
numerical study, the horizontal deformations of the offshore deck as
well as internal force and buckling coefficient in structural elements
have been recorded and controlled with and without water presence.
In part of study a parametric study has been accomplished on sea
water level fluctuations and effect of this parameter has been studied
on the aforementioned numerical results.
Abstract: This study aims to specify to what extent students
understand topology during the lesson and to determine possible
misconceptions. 14 teacher trainees registered at Secondary School
Mathematics education department were observed in the topology
lessons throughout a semester and data collected at the first topology
lesson is presented here. Students- knowledge was evaluated using a
written test right before and after the topology lesson. Thus, what the
students learnt in terms of the definition and examples of topologic
space were specified as well as possible misconceptions. The
findings indicated that students did not fully comprehend the topic
and misunderstandings were due to insufficient pre-requisite
knowledge of abstract mathematical topics and mathematical
notation.
Abstract: High power laser – total emissivity method (HPL-TE method) for determination of coatings relative total emissivity dependent on the temperature is introduced. Method principle, experimental and evaluation parts of the method are described. Computer model of HPL-TE method is employed to perform the sensitivity analysis of the effect of method parameters on the sample surface temperature in the positions where the surface temperature and radiation heat flux are measured.
Abstract: Linear convolutive filters are fast in calculation and in application, and thus, often used for real-time processing of continuous data streams. In the case of transient signals, a filter has not only to detect the presence of a specific waveform, but to estimate its arrival time as well. In this study, a measure is presented which indicates the performance of detectors in achieving both of these tasks simultaneously. Furthermore, a new sub-class of linear filters within the class of filters which minimize the quadratic response is proposed. The proposed filters are more flexible than the existing ones, like the adaptive matched filter or the minimum power distortionless response beamformer, and prove to be superior with respect to that measure in certain settings. Simulations of a real-time scenario confirm the advantage of these filters as well as the usefulness of the performance measure.
Abstract: This paper reports a new application of material accounting techniques to characterise and quantify material stocks and flows at the “neighbourhood" scale. The study area is the main campus of the University of New South Wales in Sydney, Australia. The system boundary is defined by the urban structural unit (USU), a typological construct devised to facilitate assessment of the metabolism of urban systems. A streamlined material flow analysis (MFA) was applied to quantify the stocks and flows of key construction materials within the campus USU over time, drawing on empirical data from a major campus development project. The results are reviewed to assess the efficacy of the method in supporting urban environmental evaluation and design practice, for example to facilitate estimation of significant impacts such as greenhouse gas emissions. It is concluded that linking a service (in this case, teaching students) enabled by a given product (university buildings) to the amount of materials used in creating that product offers a potential way to reduce the environmental impact of that service, through more efficient use of materials.
Abstract: This study experimentally investigates the heat transfer effects of forced convection and natural convection under different substrate openings design. A computational fluid dynamics (CFD) model was established and implemented to verify and explain the experimental results and heat transfer behavior. It is found that different opening position will destroy the growth of the boundary layer on substrates to alter the cooling ability for both forced under low Reynolds number and natural convection. Nevertheless, having too many opening may reduce heat conduction and affect the overall heat transfer performance. This study provides future researchers with a guideline on designing and electronic package manufacturing.
Abstract: The static stability analysis of stiffened functionally
graded cylindrical shells by isotropic rings and stringers subjected to
axial compression is presented in this paper. The Young's modulus of
the shell is taken to be function of the thickness coordinate. The
fundamental relations, the equilibrium and stability equations are
derived using the Sander's assumption. Resulting equations are
employed to obtain the closed-form solution for the critical axial
loads. The effects of material properties, geometric size and different
material coefficient on the critical axial loads are examined. The
analytical results are compared and validated using the finite element
model.
Abstract: In recent years, though, the concept of fit has been
now in widespread used in strategic management research, it is in its
infancy for applying fit concept to service innovation issue. Therefore,
drawing on the concept of fit, this present research proposed an
innovation service fit model within service innovation, market
orientation, marketing strategy, and IT adoption are coexisted. The
perspective of fit as covariation will be employed to test the hypothesis
and identify the effects of fit. We contend that the fit among these four
factors will contribution to business performance. Finally, according
to the empirical data collected from manufacturing, service, and
financial industry in Taiwan, meaningful findings and conclusions
will be proposed and discussed.
Abstract: Researchers have long had trouble in measurement of
Exchangeable Sodium Ratio (ESR) at salt-affected soils. this
parameter are often determined using laborious and time consuming
laboratory tests, but it may be more appropriate and economical to
develop a method which uses a more simple soil salinity index. The
aim of this study was to determine the relationship between
exchangeable sodium ratio (ESR) and sodium adsorption ratio (SAR)
in some salt-affected soils of Khuzestan plain. To this purpose, two
experimental areas (S1, S2) of Khuzestan province-IRAN were
selected and four treatments with three replications by series of
double rings were applied. The treatments were included 25cm,
50cm, 75cm and 100cm water application. The statistical results of
the study indicated that in order to predict soil ESR based on soil
SAR the linear regression model ESR=0.2048+0.0066 SAR
(R2=0.53) & ESR=0.0564+0.0171 SAR (R2=0.76) can be
recommended in Pilot S1 and S2 respectively.