The Effects of SCMs on the Mechanical Properties and Durability of Fibre Cement Plates

Fibre cement plates, often used in construction, generally are made using quartz as an inert material, cement as a binder and cellulose as a fibre. This paper, first of all, investigates the mechanical properties and durability of fibre cement plates when quartz is both partly and fully replaced with diatomite. Diatomite does not only have lower density compared to quartz but also has high pozzolanic activity. The main objective of this paper is the investigation of the effects of supplementary cementing materials (SCMs) on the short and long term mechanical properties and durability characteristics of fibre cement plates prepared using diatomite. Supplementary cementing materials such as ground granulated blast furnace slug (GGBS) and fly ash (FA) are used in this study. Volume proportions of 10, 20, 30 and 40% of GGBS and FA are used as partial replacement materials to cement. Short and long term mechanical properties such as compressive and flexural strengths as well as sorptivity characteristics and mass were investigated. Consistency and setting time at each replacement levels of SCMs were also recorded. The effects of using supplementary cementing materials on the carbonation and sulphate resistance of fibre cement plates were then experimented. The results, first of all, show that the use of diatomite as a full or partial replacement to quartz resulted in a systematic decrease in total mass of the fibre cement plates. The reduction of mass was largely due to the lower density and finer particle size of diatomite compared to quartz. The use of diatomite did not only reduce the mass of these plates but also increased the compressive strength significantly as a result of its high pozzolanic activity. The replacement levels of both GGBS and FA resulted in a systematic decrease in short term compressive strength with increasing replacement levels. This was essentially expected as the total rate of hydration is much lower in GGBS and FA than that of cement. Long term results however, indicated that the compressive strength of fibre cement plates prepared using both GGBS and FA increases with time and hence the compressive strength of plates prepared using SCMs is either equivalent or more than the compressive strength of plates prepared using cement alone. Durability characteristics of fibre cement plates prepared using SCMs were enhanced significantly. Measurements of sopritivty characteristics were also indicated that the plates prepared using SCMs has much lower water absorption capacities compared to plates prepared cement alone. Much higher resistance to carbonation and sulphate attach were observed with plates prepared using SCMs. The results presented in this paper show that the use of SCMs does not only support the production of more sustainable construction materials but also enhances the mechanical properties and durability characteristics of fibre cement plates.

Authors:

• Ceren Ince
• Berkay Z. Erdem
• Shahram Derogar
• Nabi Yuzer

Keywords:

• Diatomite
• fibre
• strength
• supplementary cementing materials.

References:

[1] R. Shen, Z. Lin, Y. Zhang, “The development of non-asbestos fibre
cement products in China,” 10th International Inorganic-Bonded Fibre
Composites Conference, 68-78, (2006).
[2] C.G. Hoyos, E. Cristia and A. Vazquez, “Effect of cellulose
microcrystalline particles on properties of cement based composites,”
Materials and Design, 51, 810-818, (2013).
[3] R. Jarabo, E. Fuente, M.C. Monte, H. Savastano Jr, P. Mutje and C.
Negro, “Use of cellulose fibres from hemp core in fibre cement
production. Effect on flocculation, retention, drainage and product
properties,” Industrial Crops and Products, 39, 89-96, (2012).
[4] M. Bentchikou, A. Guidoum, K. Scrivener, K. Silhadi and S. Hanini,
“Effect of recycled cellulose fibres on the properties of lightweight
cement composite matrix,” Construction and Building Materials, 34,
451-456, (2012).
[5] N. Degirmenci and A. Yılmaz, “Use of diatomite as partial replacement
for Portland cement in cement mortars,” Construction and Building
Materials, 23, 284-288, (2009).
[6] A. A. Ramezanianpour, S. Atarodi, M. Sami, “Durability of concretes
containing ground granulated blast furnace GGBS against sulphate
attack,” Third International Conference on Sustainable Construction
Materials and Technologies
[7] S. P. Sangeetha, P. S. Joanna, “Flexural Behaviour of Reinforced
Concrete Beams with Partial Replacement of GGBS,” American Journal
of Engineering Research (AJER) e-ISSN: 2320-0847 p-ISSN : 2320-
0936, Volume-03, Issue-01, pp:119-127
[8] M. Soman and K. Sobha, “Strength and Behaviour of High Volume Fly
Ash Concrete,” International Journal of Innovative Research in Science,
Engineering and Technology, Vol. 3, Issue 5, May 2014, Pp 12416-
12424.
[9] S. Arivalagan, “Sustainable Studies on Concrete with GGBS as a
Replacement Material in Cement” Jordan Journal of Civil Engineering,
Volume 8, No. 3, 2014, Pp 263-270
[10] A.H.L. Swaroop, K. Venkateswararao, P Kodandaramarao, “Durability
Studies On Concrete With Fly Ash & GGBS,” International Journal of
Engineering Research and Applications (IJERA) ISSN: 2248-9622, Vol.
3, Issue 4, Jul-Aug 2013, pp.285-289 285
[11] BSI (2005) EN 450-1:2005 “Fly ash for concrete. Definition,
specifications and conformity criteria,” BSI, London, UK.
[12] BSI (2006) EN 15167-1:2006, “Ground granulated blast furnace slag for
use in concrete, mortar and grout. Definitions, specifications and
conformity criteria,” BSI, London, UK.
[13] C. Ince, M.A. Carter, M.A. Wilson, N.C. Collier, A. El-Turki, R.J. Ball,
G.C. Allen, “Factors Affecting the Water Retaining Characteristics of
Lime and Cement Mortars in the Freshly-Mixed State,” Mater. Struct.
44(2), 2011, 509-516.
[14] BSI (1999) EN 1015-3:1999. “Methods of test for mortar for masonry.
Determination of consistence of fresh mortar (by flow table)”. BSI,
London, UK.
[15] BSI (2005) EN 196-3:2005 +A1:2008. “Methods of testing cement.
Determination of setting times and soundness,” BSI, London, UK.
[16] BSI EN 14630:2006, “Products and systems for the protection and repair
of concrete structures. Test methods. Determination of carbonation depth
in hardened concrete by the phenolphthalein method.” ISBN 0580
496228.