Homotopy Analysis Method for Hydromagnetic Plane and Axisymmetric Stagnation-point Flow with Velocity Slip
This work is focused on the steady boundary layer flow
near the forward stagnation point of plane and axisymmetric bodies
towards a stretching sheet. The no slip condition on the solid
boundary is replaced by the partial slip condition. The analytical
solutions for the velocity distributions are obtained for the various
values of the ratio of free stream velocity and stretching velocity, slip
parameter, the suction and injection velocity parameter, magnetic
parameter and dimensionality index parameter in the series forms with
the help of homotopy analysis method (HAM). Convergence of the
series is explicitly discussed. Results show that the flow and the skin
friction coefficient depend heavily on the velocity slip factor. In
addition, the effects of all the parameters mentioned above were more
pronounced for plane flows than for axisymmetric flows.
[1] Hiemenz, Die Grenzschicht an einem in den gleichfor-migen
Fluessigkeitsstrom eingetauchten geraden Kreiszy-linder. Dinglers
Polytechnisches J, 326 (1911) 321-410.
[2] T. Chiam, Stagnation-point flow towards a stretching plate, J. Phys. Soc.
Jpn, 63(6), (1994) 2443-2444.
[3] T.R.Mahapatra and A.S.Gupta, Heat transfer in stagnation-point flow
towards a stretching sheet, Heat Mass. Tran, 38(6) (2002) 517-521.
[4] A.Ishak, R. Nazar and I.Pop, Dual solutions in mixed convection flow
near a stagnation point on a vertical surface in a porous medium, Int. J.
Heat. Mass. Tran, 51(5-6) (2008) 1150-1155.
[5] A. Yoshimura and R.K. Prudhomme, Wall slip correc-tions for Couette
and parallel disc viscometers, J. Rheol, 32(1) (1988) 53-67.
[6] M.Mooney, Explicit formulas for slip and fluidity. J. Rheology. 2(2)
(1931) 210-222.
[7] I. J.Rao and K. R.Rajagopal, The effect of the slip condition on the flow of
fluids in a channel, Acta Mech. 135(3) (1999) 113-126.
[8] A. R. A.Khaled and Vafai, K. The effect of slip condition on Stokes and
Couette flows due to an oscillating wall: exact solutions, Int. J.
Non-Linear Mech, 39(5) (2004) 795-804.
[9] T.Hayat, K.Masood and M.Ayub, The effect of the slip condition on flows
of an Oldroyd 6-constant fluid, J. Comput. Appl. Math, 202(2), (2007)
402-413.
[10] R.C.Chaudnary, A.K. Jiha and F.Hang, Effects of Chemical Reaction on
MHD Micropolar Fluid Flow Past a Vertical Plate in Slip-Flow Regime,
Appl. Math. Mech. 29(9) (2008) 1179-1194.
[11] H. I. Andersson and M.Rousselet, Slip flow over a lubri-cated rotating
disk, Int. J. Heat.Fluid Flow 27(2) (2006) 329-335.
[12] F.Labropulu and D.Li, Stagnation-point flow of a second- grade fluid
with slip, Int. J. Non-Linear Mech, 43(9) (2008) 941-947.
[13] C. Y.Wang, Flow due to a stretching boundary with partial slipÔÇòan exact
solution of the Navier-Stokes equations, Chem. Eng. Sci, 57(17) (2002)
3745-3747.
[14] C. Y.Wang, Stagnation slip flow and heat transfer on a moving plate,
Chem. Eng. Sci, 61(23) (2006)7668-7672.
[15] S.J.Liao, Beyond perturbation: introduction to homo-topy analysis
method. Boca Raton, Chapman, 2003, Hall/CRC.
[16] J.Zhu, L. C.Zheng and X. X.Zhang, Analytic solution of stagnation-point
flow and heat transfer over a stretching sheet based on homotopy analysis,
Appl. Math. Mech. 30(4) (2009) 463-474.
[17] T.Hayat Z.Abbas and M.Sajid, Series solution for the upper-convected
Maxwell fluid over a porous streching plate, Phys. Lett. A, 358(5-6) (2006)
396-403.
[18] C.Wang and I.Pop, Analysis of the flow of a power-law fluid film on an
unsteady stretching surface by means of homotopy analysis method,
Journal of Non-Newtonian Fluid Mechanics, 138(2-3) (2006) 161-172.
[1] Hiemenz, Die Grenzschicht an einem in den gleichfor-migen
Fluessigkeitsstrom eingetauchten geraden Kreiszy-linder. Dinglers
Polytechnisches J, 326 (1911) 321-410.
[2] T. Chiam, Stagnation-point flow towards a stretching plate, J. Phys. Soc.
Jpn, 63(6), (1994) 2443-2444.
[3] T.R.Mahapatra and A.S.Gupta, Heat transfer in stagnation-point flow
towards a stretching sheet, Heat Mass. Tran, 38(6) (2002) 517-521.
[4] A.Ishak, R. Nazar and I.Pop, Dual solutions in mixed convection flow
near a stagnation point on a vertical surface in a porous medium, Int. J.
Heat. Mass. Tran, 51(5-6) (2008) 1150-1155.
[5] A. Yoshimura and R.K. Prudhomme, Wall slip correc-tions for Couette
and parallel disc viscometers, J. Rheol, 32(1) (1988) 53-67.
[6] M.Mooney, Explicit formulas for slip and fluidity. J. Rheology. 2(2)
(1931) 210-222.
[7] I. J.Rao and K. R.Rajagopal, The effect of the slip condition on the flow of
fluids in a channel, Acta Mech. 135(3) (1999) 113-126.
[8] A. R. A.Khaled and Vafai, K. The effect of slip condition on Stokes and
Couette flows due to an oscillating wall: exact solutions, Int. J.
Non-Linear Mech, 39(5) (2004) 795-804.
[9] T.Hayat, K.Masood and M.Ayub, The effect of the slip condition on flows
of an Oldroyd 6-constant fluid, J. Comput. Appl. Math, 202(2), (2007)
402-413.
[10] R.C.Chaudnary, A.K. Jiha and F.Hang, Effects of Chemical Reaction on
MHD Micropolar Fluid Flow Past a Vertical Plate in Slip-Flow Regime,
Appl. Math. Mech. 29(9) (2008) 1179-1194.
[11] H. I. Andersson and M.Rousselet, Slip flow over a lubri-cated rotating
disk, Int. J. Heat.Fluid Flow 27(2) (2006) 329-335.
[12] F.Labropulu and D.Li, Stagnation-point flow of a second- grade fluid
with slip, Int. J. Non-Linear Mech, 43(9) (2008) 941-947.
[13] C. Y.Wang, Flow due to a stretching boundary with partial slipÔÇòan exact
solution of the Navier-Stokes equations, Chem. Eng. Sci, 57(17) (2002)
3745-3747.
[14] C. Y.Wang, Stagnation slip flow and heat transfer on a moving plate,
Chem. Eng. Sci, 61(23) (2006)7668-7672.
[15] S.J.Liao, Beyond perturbation: introduction to homo-topy analysis
method. Boca Raton, Chapman, 2003, Hall/CRC.
[16] J.Zhu, L. C.Zheng and X. X.Zhang, Analytic solution of stagnation-point
flow and heat transfer over a stretching sheet based on homotopy analysis,
Appl. Math. Mech. 30(4) (2009) 463-474.
[17] T.Hayat Z.Abbas and M.Sajid, Series solution for the upper-convected
Maxwell fluid over a porous streching plate, Phys. Lett. A, 358(5-6) (2006)
396-403.
[18] C.Wang and I.Pop, Analysis of the flow of a power-law fluid film on an
unsteady stretching surface by means of homotopy analysis method,
Journal of Non-Newtonian Fluid Mechanics, 138(2-3) (2006) 161-172.
@article{"International Journal of Mechanical, Industrial and Aerospace Sciences:55711", author = "Jing Zhu and Liancun Zheng and Xinxin Zhang", title = "Homotopy Analysis Method for Hydromagnetic Plane and Axisymmetric Stagnation-point Flow with Velocity Slip", abstract = "This work is focused on the steady boundary layer flow
near the forward stagnation point of plane and axisymmetric bodies
towards a stretching sheet. The no slip condition on the solid
boundary is replaced by the partial slip condition. The analytical
solutions for the velocity distributions are obtained for the various
values of the ratio of free stream velocity and stretching velocity, slip
parameter, the suction and injection velocity parameter, magnetic
parameter and dimensionality index parameter in the series forms with
the help of homotopy analysis method (HAM). Convergence of the
series is explicitly discussed. Results show that the flow and the skin
friction coefficient depend heavily on the velocity slip factor. In
addition, the effects of all the parameters mentioned above were more
pronounced for plane flows than for axisymmetric flows.", keywords = "slip flow, axisymmetric flow, homotopy analysismethod, stagnation-point.", volume = "4", number = "3", pages = "304-5", }
{
"title": "Homotopy Analysis Method for Hydromagnetic Plane and Axisymmetric Stagnation-point Flow with Velocity Slip",
"abstract": "This work is focused on the steady boundary layer flow\r\nnear the forward stagnation point of plane and axisymmetric bodies\r\ntowards a stretching sheet. The no slip condition on the solid\r\nboundary is replaced by the partial slip condition. The analytical\r\nsolutions for the velocity distributions are obtained for the various\r\nvalues of the ratio of free stream velocity and stretching velocity, slip\r\nparameter, the suction and injection velocity parameter, magnetic\r\nparameter and dimensionality index parameter in the series forms with\r\nthe help of homotopy analysis method (HAM). Convergence of the\r\nseries is explicitly discussed. Results show that the flow and the skin\r\nfriction coefficient depend heavily on the velocity slip factor. In\r\naddition, the effects of all the parameters mentioned above were more\r\npronounced for plane flows than for axisymmetric flows.",
"keywords": [
"slip flow",
"axisymmetric flow",
"homotopy analysismethod",
"stagnation-point."
],
"authors": [
"Jing Zhu",
"Liancun Zheng",
"Xinxin Zhang"
],
"values": 4,
"issue": 3,
"issn": null,
"page_start": 304,
"page_end": 5,
"year": "2010",
"doi": "https://doi.org/10.5281/zenodo.1063274",
"journal": "International Journal of Mechanical, Industrial and Aerospace Sciences",
"categories": [
"Aerospace and Mechanical Engineering"
],
"files": [
"http://scholarly.org/pdf/display/homotopy-analysis-method-for-hydromagnetic-plane-and-axisymmetric-stagnation-point-flow-with-velocity-slip"
]
}