Abstract: This paper predicts the effect of the user-s hand-hold
position on the Total Isotropic Sensitivity (TIS) of GSM900/1800
mobile phone antennas of realistic in-use conditions, where different
semi-realistic mobile phone models, i.e., candy bar and clamshell, as
well as different antenna types, i.e., external and internal, are
simulated using a FDTD-based platform. A semi-realistic hand model
consisting of three tissues and the SAM head are used in simulations.
The results show a considerable impact on TIS of the adopted mobile
phone models owing to the user-s hand presence at different
positions, where a maximum level of TIS is obtained while grasping
the upper part of the mobile phone against head. Maximum TIS
levels are recorded in talk position for mobile phones with external
antenna and maximum differences in TIS levels due to the hand-hold
alteration are recorded for clamshell-type phones.
Abstract: In this paper, a new design technique for enhancing
bandwidth that improves the performance of a conventional
microstrip patch antenna is proposed. This paper presents a novel
wideband probe fed inverted slotted microstrip patch antenna. The
design adopts contemporary techniques; coaxial probe feeding,
inverted patch structure and slotted patch. The composite effect of
integrating these techniques and by introducing the proposed patch,
offer a low profile, broadband, high gain, and low cross-polarization
level. The results for the VSWR, gain and co-and cross-polarization
patterns are presented. The antenna operating the band of 1.80-2.36
GHz shows an impedance bandwidth (2:1 VSWR) of 27% and a gain
of 10.18 dBi with a gain variation of 1.12 dBi. Good radiation
characteristics, including a cross-polarization level in xz-plane less
than -42 dB, have been obtained.
Abstract: A new Feed-Forward/Feedback Generalized
Minimum Variance Pole-placement Controller to incorporate the
robustness of classical pole-placement into the flexibility of
generalized minimum variance self-tuning controller for Single-Input
Single-Output (SISO) has been proposed in this paper. The design,
which provides the user with an adaptive mechanism, which ensures
that the closed loop poles are, located at their pre-specified positions.
In addition, the controller design which has a feed-forward/feedback
structure overcomes the certain limitations existing in similar poleplacement
control designs whilst retaining the simplicity of
adaptation mechanisms used in other designs. It tracks set-point
changes with the desired speed of response, penalizes excessive
control action, and can be applied to non-minimum phase systems.
Besides, at steady state, the controller has the ability to regulate the
constant load disturbance to zero. Example simulation results using
both simulated and real plant models demonstrate the effectiveness of
the proposed controller.
Abstract: An effective approach for unbalanced three-phase
distribution power flow solutions is proposed in this paper. The
special topological characteristics of distribution networks have been
fully utilized to make the direct solution possible. Two matrices–the
bus-injection to branch-current matrix and the branch-current to busvoltage
matrix– and a simple matrix multiplication are used to
obtain power flow solutions. Due to the distinctive solution
techniques of the proposed method, the time-consuming LU
decomposition and forward/backward substitution of the Jacobian
matrix or admittance matrix required in the traditional power flow
methods are no longer necessary. Therefore, the proposed method is
robust and time-efficient. Test results demonstrate the validity of the
proposed method. The proposed method shows great potential to be
used in distribution automation applications.
Abstract: This paper describes an interfacing of C and the
TMS320C6713 assembly language which is crucially important for
many real-time applications. Similarly, interfacing of C with the
assembly language of a conventional microprocessor such as
MC68000 is presented for comparison. However, it should be noted
that the way the C compiler passes arguments among various
functions in the TMS320C6713-based environment is totally
different from the way the C compiler passes arguments in a
conventional microprocessor such as MC68000. Therefore, it is very
important for a user of the TMS320C6713-based system to properly
understand and follow the register conventions when interfacing C
with the TMS320C6713 assembly language subroutine. It should be
also noted that in some cases (examples 6-9) the endian-mode of the
board needs to be taken into consideration. In this paper, one method
is presented in great detail. Other methods will be presented in the
future.
Abstract: Discrete Wavelet Transform (DWT) has demonstrated
far superior to previous Discrete Cosine Transform (DCT) and
standard JPEG in natural as well as medical image compression. Due
to its localization properties both in special and transform domain,
the quantization error introduced in DWT does not propagate
globally as in DCT. Moreover, DWT is a global approach that avoids
block artifacts as in the JPEG. However, recent reports on natural
image compression have shown the superior performance of
contourlet transform, a new extension to the wavelet transform in two
dimensions using nonseparable and directional filter banks,
compared to DWT. It is mostly due to the optimality of contourlet in
representing the edges when they are smooth curves. In this work, we
investigate this fact for medical images, especially for CT images,
which has not been reported yet. To do that, we propose a
compression scheme in transform domain and compare the
performance of both DWT and contourlet transform in PSNR for
different compression ratios (CR) using this scheme. The results
obtained using different type of computed tomography images show
that the DWT has still good performance at lower CR but contourlet
transform performs better at higher CR.
Abstract: The purpose of this paper is to provide a practical
example to the Linear Quadratic Gaussian (LQG) controller. This
method includes a description and some discussion of the discrete
Kalman state estimator. One aspect of this optimality is that the
estimator incorporates all information that can be provided to it. It
processes all available measurements, regardless of their precision, to
estimate the current value of the variables of interest, with use of
knowledge of the system and measurement device dynamics, the
statistical description of the system noises, measurement errors, and
uncertainty in the dynamics models.
Since the time of its introduction, the Kalman filter has been the
subject of extensive research and application, particularly in the area
of autonomous or assisted navigation. For example, to determine the
velocity of an aircraft or sideslip angle, one could use a Doppler
radar, the velocity indications of an inertial navigation system, or the
relative wind information in the air data system. Rather than ignore
any of these outputs, a Kalman filter could be built to combine all of
this data and knowledge of the various systems- dynamics to
generate an overall best estimate of velocity and sideslip angle.
Abstract: Nodes in mobile Ad Hoc Network (MANET) do not
rely on a central infrastructure but relay packets originated by other
nodes. Mobile ad hoc networks can work properly only if the
participating nodes collaborate in routing and forwarding. For
individual nodes it might be advantageous not to collaborate, though.
In this conceptual paper we propose a new approach based on
relationship among the nodes which makes them to cooperate in an
Adhoc environment. The trust unit is used to calculate the trust
values of each node in the network. The calculated trust values are
being used by the relationship estimator to determine the relationship
status of nodes. The proposed enhanced protocol was compared with
the standard DSR protocol and the results are analyzed using the
network simulator-2.
Abstract: A multiphase harmonic load flow algorithm is developed based on backward/forward sweep to examine the effects of various factors on the neutral to earth voltage (NEV), including unsymmetrical system configuration, load unbalance and harmonic injection. The proposed algorithm composes fundamental frequency and harmonic frequencies power flows. The algorithm and the associated models are tested on IEEE 13 bus system. The magnitude of NEV is investigated under various conditions of the number of grounding rods per feeder lengths, the grounding rods resistance and the grounding resistance of the in feeding source. Additionally, the harmonic injection of nonlinear loads has been considered and its influences on NEV under different conditions are shown.
Abstract: DG application has received increasing attention during
recent years. The impact of DG on various aspects of distribution system
operation, such as reliability and energy loss, depend highly on DG
location in distribution feeder. Optimal DG placement is an important
subject which has not been fully discussed yet.
This paper presents an optimization method to determine optimal DG
placement, based on a cost/worth analysis approach. This method
considers technical and economical factors such as energy loss, load point
reliability indices and DG costs, and particularly, portability of DG. The
proposed method is applied to a test system and the impacts of different
parameters such as load growth rate and load forecast uncertainty (LFU)
on optimum DG location are studied.
Abstract: This paper presents the results of a preventive maintenance application-based study and modeling of failure rates in breakers of electrical distribution systems. This is a critical issue in the reliability assessment of a system. In the analysis conducted in this paper, the impacts of failure rate variations caused by a preventive maintenance are examined. This is considered as a part of a Reliability Centered Maintenance (RCM) application program. A number of load point reliability indices is derived using the mathematical model of the failure rate, which is established using the observed data in a distribution system.
Abstract: In this paper, a novel deinterlacing algorithm is
proposed. The proposed algorithm approximates the distribution of the
luminance into a polynomial function. Instead of using one
polynomial function for all pixels, different polynomial functions are
used for the uniform, texture, and directional edge regions. The
function coefficients for each region are computed by matrix
multiplications. Experimental results demonstrate that the proposed
method performs better than the conventional algorithms.
Abstract: Flexible macroblock ordering (FMO), adopted in the
H.264 standard, allows to partition all macroblocks (MBs) in a frame
into separate groups of MBs called Slice Groups (SGs). FMO can not
only support error-resilience, but also control the size of video packets
for different network types. However, it is well-known that the number
of bits required for encoding the frame is increased by adopting FMO.
In this paper, we propose a novel algorithm that can reduce the bitrate
overhead caused by utilizing FMO. In the proposed algorithm, all MBs
are grouped in SGs based on the similarity of the transform
coefficients. Experimental results show that our algorithm can reduce
the bitrate as compared with conventional FMO.
Abstract: Position based routing protocols are the kinds of
routing protocols, which they use of nodes location information,
instead of links information to routing. In position based routing
protocols, it supposed that the packet source node has position
information of itself and it's neighbors and packet destination node.
Greedy is a very important position based routing protocol. In one of
it's kinds, named MFR (Most Forward Within Radius), source node
or packet forwarder node, sends packet to one of it's neighbors with
most forward progress towards destination node (closest neighbor to
destination). Using distance deciding metric in Greedy to forward
packet to a neighbor node, is not suitable for all conditions. If closest
neighbor to destination node, has high speed, in comparison with
source node or intermediate packet forwarder node speed or has very
low remained battery power, then packet loss probability is
increased. Proposed strategy uses combination of metrics distancevelocity
similarity-power, to deciding about giving the packet to
which neighbor. Simulation results show that the proposed strategy
has lower lost packets average than Greedy, so it has more reliability.
Abstract: Fuel cell's system requires regulating circuit for
voltage and current in order to control power in case of connecting to
other generative devices or load. In this paper Fuel cell system and
convertor, which is a multi-variable system, are controlled using
sliding mode method. Use of weighting matrix in design procedure
made it possible to regulate speed of control. Simulation results show
the robustness and accuracy of proposed controller for controlling
desired of outputs.
Abstract: Degradation of polymeric insulation systems of
electrical equipments increases the space charge density and the
concentration of electrical dipoles. By consequence, the maximum
values and the slopes of absorption/resorption (A/R) currents can
change with insulation systems ageing. In this paper, an analysis of
the nature of the A/R currents and the importance of their
components, especially the polarization current and the current given
by the space charge, is presented. The experimental study concerns
the A/R currents measurements of plane samples (made from
CALMICAGLAS tapes), virgin and thermally accelerated aged. The
obtained results show that the ageing process produces an increase of
the values and a decrease of shapes of the A/R currents. Finally, the
possibility of estimating insulations ageing state and lifetime from
A/R currents measurements is discussed.
Abstract: This paper presents a reliability-based approach to select appropriate wind turbine types for a wind farm considering site-specific wind speed patterns. An actual wind farm in the northern region of Iran with the wind speed registration of one year is studied in this paper. An analytic approach based on total probability theorem is utilized in this paper to model the probabilistic behavior of both turbines- availability and wind speed. Well-known probabilistic reliability indices such as loss of load expectation (LOLE), expected energy not supplied (EENS) and incremental peak load carrying capability (IPLCC) for wind power integration in the Roy Billinton Test System (RBTS) are examined. The most appropriate turbine type achieving the highest reliability level is chosen for the studied wind farm.
Abstract: In order to perform on-line measuring and detection
of PD signals, a total solution composing of an HFCT, A/D
converter and a complete software package is proposed. The
software package includes compensation of HFCT contribution,
filtering and noise reduction using wavelet transform and soft
calibration routines. The results have shown good performance and
high accuracy.
Abstract: In this paper in consideration of each available
techniques deficiencies for speech recognition, an advanced method
is presented that-s able to classify speech signals with the high
accuracy (98%) at the minimum time. In the presented method, first,
the recorded signal is preprocessed that this section includes
denoising with Mels Frequency Cepstral Analysis and feature
extraction using discrete wavelet transform (DWT) coefficients; Then
these features are fed to Multilayer Perceptron (MLP) network for
classification. Finally, after training of neural network effective
features are selected with UTA algorithm.
Abstract: This paper presents features that characterize power
quality disturbances from recorded voltage waveforms using wavelet
transform. The discrete wavelet transform has been used to detect
and analyze power quality disturbances. The disturbances of interest
include sag, swell, outage and transient. A power system network has
been simulated by Electromagnetic Transients Program. Voltage
waveforms at strategic points have been obtained for analysis, which
includes different power quality disturbances. Then wavelet has been
chosen to perform feature extraction. The outputs of the feature
extraction are the wavelet coefficients representing the power quality
disturbance signal. Wavelet coefficients at different levels reveal the
time localizing information about the variation of the signal.