Phase Transformation Temperatures for Shape Memory Alloy Wire

Phase transformation temperature is one of the most important parameters for the shape memory alloys (SMAs). The most popular method to determine these phase transformation temperatures is the Differential Scanning Calorimeter (DSC), but due to the limitation of the DSC testing itself, it made it difficult for the finished product which is not in the powder form. A novel method which uses the Universal Testing Machine has been conducted to determine the phase transformation temperatures. The Flexinol wire was applied with force and maintained throughout the experiment and at the same time it was heated up slowly until a temperature of approximately 1000C with direct current. The direct current was then slowly decreased to cool down the temperature of the Flexinol wire. All the phase transformation temperatures for Flexinol wire were obtained. The austenite start at 52.540C and austenite finish at 60.900C, while martensite start at 44.780C and martensite finish at 32.840C.




References:
[1] Kiyohide Wada and Yong Liu, ''Shape recovery of NiTi shape memory alloy under various pre-strain and constraint conditions,'' Smart Mater. Struct. 14 (2005) S273-S286. [2] Antonio Vitiello, Giuseppe Giorleo and Renata Erica Morace, ''Analysis of thermomechanical behaviour of Nitinol wires with high strain rates,'' Smart Mater. Struct. 14 (2005) 215-221. [3] Z.G. Wan, X.T. Zu, X.D. Feng, L.B. Lin, S. Zhu, L.P. You and, L.M. Wang, ''Design of TiNi alloy two-way shape memory coil extension spring,'' Science and Technology of Advanced Materials 6 (2005) 889-894. [4] Z.G. Wang, X.T. Zu, X.D. Feng, S. Zhu, J.W. Bao and, L.M. Wang, ''Characteristics of two-way shape memory TiNi springs driven by electrical current,'' Materials and Design 25 (2004) 699-703. [5] J. Rena and, K.M. Liewa, ''Meshfree modelling and characterisation of thermomechanical behaviour of NiTi alloys,'' Engineering Analysis with Boundary Elements 29 (2005) 29-40. [6] Mohammad H Elahinia and Mehdi Ahmadian, ''An enhanced SMA phenomenological model: II. The experimental study,'' Smart Mater. Struct. 14 (2005) 1309-1319. [7] A J ┼╗ak, M P Cartmell, W M Ostachowicz and M Wiercigroch, ''One-dimensional shape memory alloy models for use with reinforced composite structures,'' Smart Mater. Struct. 12 (2003) 338-346. [8] Z.W. Zhong and C.K. Yeong, ''Development of a gripper using SMA wire,'' Sensors and Actuators A (2005) to be published. [9] Mohammad H Elahinia and Mehdi Ahmadian, ''An enhanced SMA phenomenological model: I. The shortcomings of the existing models,'' Smart Mater. Struct. 14 (2005) 1297-1308. [10] Elwaleed Awad Khidir, Nik Abdullah Mohameda, Mohd Jailani Mohd Nora and Mohd Marzuki Mustafa, ''A new concept of a linear smart actuator,'' Sensors and Actuators A (2006) to be published. [11] Technical characteristics of Flexinol® actuator wires, Dynalloy, inc. [12] Otsuka K and Wayman C M 1998 ''Shape Memory Materials'' (Cambridge: Cambridge University Press).