Finite Element Simulation of Deep Drawing Process to Minimize Earing

Earing defect in drawing process is highly undesirable not only because it adds on an additional trimming operation but also because the uneven material flow demands extra care. The objective of this work is to study the earing problem in the Deep Drawing of circular cup and to optimize the blank shape to reduce the earing. A finite element model is developed for 3-D numerical simulation of cup forming process in ABAQUS. Extra-deep-drawing (EDD) steel sheet has been used for simulation. Properties and tool design parameters were used as input for simulation. Earing was observed in the simulated cup and it was measured at various angles with respect to rolling direction. To reduce the earing defect initial blank shape was modified with the help of anisotropy coefficient. Modified blanks showed notable reduction in earing.




References:
[1] P. Das, S K Panda, D K Pratihar, “Modification Of Initial Blank Shape To Minimize Earing In Deep Drawing Process”, Advanced Materials Manufacturing & Characterization, vol. 3, Issue 1, 2013.
[2] O O Oluwole, C O Anyaeche and C V Faola, “Effect of Draw Ratio and Sheet Thickness on Earing and Drawability of Al 1200 Cups”, Journal of Minerals & Materials Characterization & Engineering, vol. 9, no.5, pp.461-470, 2010.
[3] R Padmanabhan, M C Oliveira, J L Alves, L F Menezes, “Influence of process parameters on the deep drawing of stainless steel”, Finite Elements in Analysis and Design 43, 1062 – 1067, 2007.
[4] N Kishor and D R Kumar, “Optimization of initial blank shape to minimize earing in deep drawing using FE method”, Journal of Materials Processing Technology, vol. 130-131, pp. 20-30, 2002.
[5] D K Leu, “Prediction of the limiting drawing ratio and the maximum drawing load in the cup drawing”, International Journal of Mechanical Science, vol. 37 (2), pp. 201-213, 1997.
[6] A Agrawal, N V Reddy, P M Dixit, “Determination of optimum process parameters for wrinkle free products in deep drawing process”, Journal of Materials Processing Technology 191, 51–54, 2007.
[7] H Zein, M El-Sherbiny, M Abd-Rabou, M El Shazly, “Effect of Die Design Parameters on Thinning of Sheet Metal in the Deep Drawing Process”, American Journal of Mechanical Engineering, vol. 1, no. 2, 20-29, 2013.
[8] M Colgan, and J Monaghan, “Deep Drawing Process: Analysis and Experiment”, Journal of Materials Processing Technology, 132, 35-41, 2003.
[9] H I Demirci, M Yaşar, K Demiray, M Karali, “The Theoretical and Experimental Investigation of Blank Holder Forces Plate Effect in Deep Drawing Process of AL 1050 Material”, Journal of Materials & Design, 29(2), 526-532, 2008.
[10] J Han, K Yamazaki, S Makino and T Shirasawa, “Optimization of Deep Drawing Process for Circular Cup Forming”, 10th World Congress on Structural and Multidisciplinary Optimization May 19 -24, 2013, Orlando, Florida, USA.
[11] D T Nguyen, D K Dinh, H M Nguyen, T L Banh, Y S Kim, “Formability improvement and blank shape definition for deep drawing of cylindrical cup with complex curve profile from SPCC sheets using FEM”, J. Cent. South Univ. 21: 27−34, 2014.