Abstract: In this paper Artificial Neural Network (ANN) is used
to predict the solar irradiation in Djibouti for the first Time that
is useful to the integration of Concentrating Solar Power (CSP)
and sites selections for new or future solar plants as part of solar
energy development. An ANN algorithm was developed to establish
a forward/reverse correspondence between the latitude, longitude,
altitude and monthly solar irradiation. For this purpose the German
Aerospace Centre (DLR) data of eight Djibouti sites were used as
training and testing in a standard three layers network with the back
propagation algorithm of Lavenber-Marquardt. Results have shown a
very good agreement for the solar irradiation prediction in Djibouti
and proves that the proposed approach can be well used as an
efficient tool for prediction of solar irradiation by providing so helpful
information concerning sites selection, design and planning of solar
plants.
Abstract: The objective from this paper is to design a solar
thermal engine for space vehicles orbital control and electricity
generation. A computational model is developed for the prediction of
the solar thermal engine performance for different design parameters and conditions in order to enhance the engine efficiency. The engine is divided into two main subsystems. First, the concentrator dish
which receives solar energy from the sun and reflects them to the
cavity receiver. The second one is the cavity receiver which receives
the heat flux reflected from the concentrator and transfers heat to the
fluid passing over. Other subsystems depend on the application required from the engine. For thrust application, a nozzle is
introduced to the system for the fluid to expand and produce thrust.
Hydrogen is preferred as a working fluid in the thruster application.
Results model developed is used to determine the thrust for a
concentrator dish 4 meters in diameter (provides 10 kW of energy),
focusing solar energy to a 10 cm aperture diameter cavity receiver.
The cavity receiver outer length is 50 cm and the internal cavity is 47
cm in length. The suggested design material of the internal cavity is
tungsten to withstand high temperature. The thermal model and
analysis shows that the hydrogen temperature at the plenum reaches
2000oK after about 250 seconds for hot start operation for a flow rate
of 0.1 g/sec.Using solar thermal engine as an electricity generation
device on earth is also discussed. In this case a compressor and
turbine are used to convert the heat gained by the working fluid (air)
into mechanical power. This mechanical power can be converted into
electrical power by using a generator.