Abstract: A current mirror (CM) based on self cascode MOSFETs low voltage analog and mixed mode structures has been proposed. The proposed CM has high output impedance and can operate at 0.5 V. P-Spice simulations confirm the high performance of this CM with a bandwidth of 6.0 GHz at input current of 100 μA.
Abstract: This paper presents a fast and efficient on-line technique for estimating impedance of unbalanced loads in power systems. The proposed technique is an application of a discrete timedynamic filter based on stochastic estimation theory which is suitable for estimating parameters in noisy environment. The algorithm uses sets of digital samples of the distorted voltage and current waveforms of the non-linear load to estimate the harmonic contents of these two signal. The non-linear load impedance is then calculated from these contents. The method is tested using practical data. Results are reported and compared with those obtained using the conventional least error squares technique. In addition to the very accurate results obtained, the method can detect and reject bad measurements. This can be considered as a very important advantage over the conventional static estimation methods such as the least error square method.
Abstract: In this paper, we present an analytical framework for the evaluation of the uplink performance of multihop cellular networks based on dynamic time division duplex (TDD). New wireless broadband protocols, such as WiMAX, WiBro, and 3G-LTE apply TDD, and mobile communication protocols under standardization (e.g., IEEE802.16j) are investigating mobile multihop relay (MMR) as a future technology. In this paper a novel MMR TDD scheme is presented, where the dynamic range of the frame is shared to traffic resources of asymmetric nature and multihop relaying. The mobile communication channel interference model comprises of inner and co-channel interference (CCI). The performance analysis focuses on the uplink due to the fact that the effects of dynamic resource allocation show significant performance degradation only in the uplink compared to time division multiple access (TDMA) schemes due to CCI [1-3], where the downlink results to be the same or better.The analysis was based on the signal to interference power ratio (SIR) outage probability of dynamic TDD (D-TDD) and TDMA systems,which are the most widespread mobile communication multi-user control techniques. This paper presents the uplink SIR outage probability with multihop results and shows that the dynamic TDD scheme applying MMR can provide a performance improvement compared to single hop applications if executed properly.
Abstract: This article presents a voltage-mode universal
biquadratic filter performing simultaneous 3 standard functions: lowpass,
high-pass and band-pass functions, employing differential
different current conveyor (DDCC) and current controlled current
conveyor (CCCII) as active element. The features of the circuit are
that: the quality factor and pole frequency can be tuned independently
via the input bias currents: the circuit description is very simple,
consisting of 1 DDCC, 2 CCCIIs, 2 electronic resistors and 2
grounded capacitors. Without requiring component matching
conditions, the proposed circuit is very appropriate to further develop
into an integrated circuit. The PSPICE simulation results are
depicted. The given results agree well with the theoretical
anticipation.
Abstract: Due to the non-linear characteristics of photovoltaic
(PV) array, PV systems typically are equipped with the capability of
maximum power point tracking (MPPT) feature. Moreover, in the
case of PV array under partially shaded conditions, hotspot problem
will occur which could damage the PV cells. Partial shading causes
multiple peaks in the P-V characteristic curves. This paper presents a
hybrid algorithm of Particle Swarm Optimization (PSO) and
Artificial Neural Network (ANN) MPPT algorithm for the detection
of global peak among the multiple peaks in order to extract the true
maximum energy from PV panel. The PV system consists of PV
array, dc-dc boost converter controlled by the proposed MPPT
algorithm and a resistive load. The system was simulated using
MATLAB/Simulink package. The simulation results show that the
proposed algorithm performs well to detect the true global peak
power. The results of the simulations are analyzed and discussed.
Abstract: DS-CDMA system is well known wireless
technology. This system suffers from MAI (Multiple Access
Interference) caused by Direct Sequence users. Multi-User Detection
schemes were introduced to detect the users- data in presence of
MAI. This paper focuses on linear multi-user detection schemes used
for data demodulation. Simulation results depict the performance of
three detectors viz-conventional detector, Decorrelating detector and
Subspace MMSE (Minimum Mean Square Error) detector. It is seen
that the performance of these detectors depends on the number of
paths and the length of Gold code used.
Abstract: We demonstrate a 1×4 coarse wavelength
division-multiplexing (CWDM) planar concave grating
multiplexer/demultiplexer and its application in re-configurable
optical add/drop multiplexer (ROADM) system in silicon-on-insulator
substrate. The wavelengths of the demonstrated concave grating
multiplexer align well with the ITU-T standard. We demonstrate a
prototype of ROADM comprising two such concave gratings and four
wide-band thermo-optical MZI switches. Undercut technology which
removes the underneath silicon substrate is adopted in optical switches
in order to minimize the operation power. For all the thermal heaters,
the operation voltage is smaller than 1.5 V, and the switch power is
~2.4 mW. High throughput pseudorandom binary sequence (PRBS)
data transmission with up to 100 Gb/s is demonstrated, showing the
high-performance ROADM functionality.
Abstract: In this paper, a new developed construction model of
the UPFC is proposed. The construction of this model consists of one
shunt compensation block and two series compensation blocks. In
this case, the UPFC with the new construction model will be
investigated when it is installed in multi-machine systems with nonlinear
load model. In addition, the steady–state performance of the
new model operating as impedance compensation will be presented
and compared with that obtained from the system without
compensation.
Abstract: This paper presents a new approach for image
segmentation by applying Pillar-Kmeans algorithm. This
segmentation process includes a new mechanism for clustering the
elements of high-resolution images in order to improve precision and
reduce computation time. The system applies K-means clustering to
the image segmentation after optimized by Pillar Algorithm. The
Pillar algorithm considers the pillars- placement which should be
located as far as possible from each other to withstand against the
pressure distribution of a roof, as identical to the number of centroids
amongst the data distribution. This algorithm is able to optimize the
K-means clustering for image segmentation in aspects of precision
and computation time. It designates the initial centroids- positions
by calculating the accumulated distance metric between each data
point and all previous centroids, and then selects data points which
have the maximum distance as new initial centroids. This algorithm
distributes all initial centroids according to the maximum
accumulated distance metric. This paper evaluates the proposed
approach for image segmentation by comparing with K-means and
Gaussian Mixture Model algorithm and involving RGB, HSV, HSL
and CIELAB color spaces. The experimental results clarify the
effectiveness of our approach to improve the segmentation quality in
aspects of precision and computational time.
Abstract: The mosaicing technique has been employed in more and more application fields, from entertainment to scientific ones. In the latter case, often the final evaluation is still left to human beings, that assess visually the quality of the mosaic. Many times, a lack of objective measurements in microscopic mosaicing may prevent the mosaic from being used as a starting image for further analysis. In this work we analyze three different metrics and indexes, in the domain of signal analysis, image analysis and visual quality, to measure the quality of different aspects of the mosaicing procedure, such as registration errors and visual quality. As the case study we consider the mosaicing algorithm we developed. The experiments have been carried out by considering mosaics with very different features: histological samples, that are made of detailed and contrasted images, and live stem cells, that show a very low contrast and low detail levels.
Abstract: Energy efficient protocol design is the aim of current
researches in the area of sensor networks where limited power
resources impose energy conservation considerations. In this paper
we care for Medium Access Control (MAC) protocols and after an
extensive literature review, two adaptive schemes are discussed. Of
them, adaptive-rate MACs which were introduced for throughput
enhancement show the potency to save energy, even more than
adaptive-power schemes. Then we propose an allocation algorithm
for getting accurate and reliable results. Through a simulation study
we validated our claim and showed the power saving of adaptive-rate
protocols.
Abstract: Versatile dual-mode class-AB CMOS four-quadrant
analog multiplier circuit is presented. The dual translinear loops and
current mirrors are the basic building blocks in realization scheme.
This technique provides; wide dynamic range, wide-bandwidth response
and low power consumption. The major advantages of this
approach are; its has single ended inputs; since its input is dual translinear
loop operate in class-AB mode which make this multiplier
configuration interesting for low-power applications; current multiplying,
voltage multiplying, or current and voltage multiplying can
be obtainable with balanced input. The simulation results of versatile
analog multiplier demonstrate a linearity error of 1.2 %, a -3dB bandwidth
of about 19MHz, a maximum power consumption of 0.46mW,
and temperature compensated. Operation of versatile analog multiplier
was also confirmed through an experiment using CMOS transistor
array.
Abstract: This paper evaluates performances of an adaptive noise
cancelling (ANC) based target detection algorithm on a set of real test
data supported by the Defense Evaluation Research Agency (DERA
UK) for multi-target wideband active sonar echolocation system. The
hybrid algorithm proposed is a combination of an adaptive ANC
neuro-fuzzy scheme in the first instance and followed by an iterative
optimum target motion estimation (TME) scheme. The neuro-fuzzy
scheme is based on the adaptive noise cancelling concept with the
core processor of ANFIS (adaptive neuro-fuzzy inference system) to
provide an effective fine tuned signal. The resultant output is then
sent as an input to the optimum TME scheme composed of twogauge
trimmed-mean (TM) levelization, discrete wavelet denoising
(WDeN), and optimal continuous wavelet transform (CWT) for
further denosing and targets identification. Its aim is to recover the
contact signals in an effective and efficient manner and then determine
the Doppler motion (radial range, velocity and acceleration) at very
low signal-to-noise ratio (SNR). Quantitative results have shown that
the hybrid algorithm have excellent performance in predicting targets-
Doppler motion within various target strength with the maximum
false detection of 1.5%.
Abstract: A mobile agent is a software which performs an
action autonomously and independently as a person or an
organizations assistance. Mobile agents are used for searching
information, retrieval information, filtering, intruder recognition in
networks, and so on. One of the important issues of mobile agent is
their security. It must consider different security issues in effective
and secured usage of mobile agent. One of those issues is the
integrity-s protection of mobile agents.
In this paper, the advantages and disadvantages of each method,
after reviewing the existing methods, is examined. Regarding to this
matter that each method has its own advantage or disadvantage, it
seems that by combining these methods, one can reach to a better
method for protecting the integrity of mobile agents. Therefore, this
method is provided in this paper and then is evaluated in terms of
existing method. Finally, this method is simulated and its results are
the sign of improving the possibility of integrity-s protection of
mobile agents.
Abstract: It is known that if harmonic spectra are decreased, then
acoustic noise also decreased. Hence, this paper deals with a new
random switching strategy using DSP TMS320F2812 to decrease the
harmonics spectra of single phase switched reluctance motor. The
proposed method which combines random turn-on, turn-off angle
technique and random pulse width modulation technique is shown. A
harmonic spread factor (HSF) is used to evaluate the random
modulation scheme. In order to confirm the effectiveness of the new
method, the experimental results show that the harmonic intensity of
output voltage for the proposed method is better than that for
conventional methods.
Abstract: This paper proposes a fast code acquisition scheme for
optical code division multiple access (O-CDMA) systems. Unlike the
conventional scheme, the proposed scheme employs multiple thresholds
providing a shorter mean acquisition time (MAT) performance.
The simulation results show that the MAT of the proposed scheme
is shorter than that of the conventional scheme.
Abstract: This paper demonstrates the application of craziness based particle swarm optimization (CRPSO) technique for designing the 8th order low pass Infinite Impulse Response (IIR) filter. CRPSO, the much improved version of PSO, is a population based global heuristic search algorithm which finds near optimal solution in terms of a set of filter coefficients. Effectiveness of this algorithm is justified with a comparative study of some well established algorithms, namely, real coded genetic algorithm (RGA) and particle swarm optimization (PSO). Simulation results affirm that the proposed algorithm CRPSO, outperforms over its counterparts not only in terms of quality output i.e. sharpness at cut-off, pass band ripple, stop band ripple, and stop band attenuation but also in convergence speed with assured stability.
Abstract: In this paper we study the use of a new code called
Random Diagonal (RD) code for Spectral Amplitude Coding (SAC)
optical Code Division Multiple Access (CDMA) networks, using
Fiber Bragg-Grating (FBG), FBG consists of a fiber segment whose
index of reflection varies periodically along its length. RD code is
constructed using code level and data level, one of the important
properties of this code is that the cross correlation at data level is
always zero, which means that Phase intensity Induced Phase (PIIN)
is reduced. We find that the performance of the RD code will be
better than Modified Frequency Hopping (MFH) and Hadamard code
It has been observed through experimental and theoretical simulation
that BER for RD code perform significantly better than other codes.
Proof –of-principle simulations of encoding with 3 channels, and 10
Gbps data transmission have been successfully demonstrated together
with FBG decoding scheme for canceling the code level from SAC-signal.
Abstract: A general stochastic spatial MIMO channel model is
proposed for evaluating various MIMO techniques in this paper. It can
generate MIMO channels complying with various MIMO
configurations such as smart antenna, spatial diversity and spatial
multiplexing. The modeling method produces the stochastic fading
involving delay spread, Doppler spread, DOA (direction of arrival),
AS (angle spread), PAS (power azimuth Spectrum) of the scatterers,
antenna spacing and the wavelength. It can be applied in various
MIMO technique researches flexibly with low computing complexity.
Abstract: Proposal for a secure stream cipher based on Linear Feedback Shift Registers (LFSR) is presented here. In this method, shift register structure used for polynomial modular division is combined with LFSR keystream generator to yield a new keystream generator with much higher periodicity. Security is brought into this structure by using the Boolean function to combine state bits of the LFSR keystream generator and taking the output through the Boolean function. This introduces non-linearity and security into the structure in a way similar to the Non-linear filter generator. The security and throughput of the suggested stream cipher is found to be much greater than the known LFSR based structures for the same key length.